JUNG FTRGO231 Manual

JUNG Termostat FTRGO231

Læs gratis den danske manual til JUNG FTRGO231 (6 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om JUNG FTRGO231, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

Temperature Management Floor heating controller

Ref.-no.: FTR..231 ..

Operating Instructions

Floor heating controller

1. Area of application

Used in domestic electrical installations to regulate electrical floor heating

systems and temperature control systems.

2. Function

The floor heating controller consists of two parts:

• Control unit for setting the required floor temperature

• Remote sensor in the floor for monitoring the set temperature

Control unit:

Using the setting knob, set the required temperature for your floor. The

numbers 7 – 6 on the knob correspond to a temperature range of

10 – 50 °C.

Note the setting instructions from the manufacturer of your floor heating

system.

If the temperature in the floor falls below the temperature you have set,

the control unit requests heat; this state is displayed by the red LED

above the setting knob. You can therefore see if your heating is using

energy.

A range restriction can also be carried out in the setting knob.

The operating state of your floor heating is switched on or off with the

mains switch 0 – I.

You also have the option of programming a temperature reduction via an

external time switch e.g. during the night.

If you have installed this type of time switch, the temperature reduction is

indicated by the green LED above the setting knob. The temperature

reduction is approx. 5 °C.

Example: The temperature set by you on the control unit is 34 °C

(number on dial = 4). This means that the temperature in the floor e.g.

during the night can drop down to 29 °C without your heating switching

itself on.

Stand: Jun-09 240 9090 1

Temperature Management Floor heating controller

Ref.-no.: FTR..231 ..

Sensor:

The sensor is to be installed in the floor. It monitors the floor temperature

set on the control unit and issues commands to switch the floor heating

on and off.

Safety instructions

Electrical equipment may only be installed and fitted by qualified

electricians while observing the current accident prevention

regulations.

Non-observance of the safety warnings or installation instructions

may damage the device, cause fire or other hazards.

In the event of a fault, mains potential can be present at the sensor.

L The switch 0 – I on the control unit causes a singlepole disconnection

of the device from the mains and interrupts the circuit to the heating

resistor in the floor.

L When working on the load circuit, the mains voltage must be

disconnected in principle.

L When the sensor is interrupted, the relay contact is closed. If the

sensor experiences a short circuit, the relay contact is open.

3. Connection and installation

Control unit

Mount the control unit in a switch box in accordance with

DIN 49 073.

Notice! The device must always be mounted with its supporting

frame on top of the wallpaper!

• Carry out the electrical connection according to the wiring diagram

(Fig. (1)). Solid conductor cross-section: 1 to 2.5 mm2 No PE

conductor required. PE conductor is only used for looping through.

Protection class II can be achieved through appropriate installation

measures.

Abb.1

Symbols used in the wiring diagram

L : L conductor

Produkt Specifikationer

Mærke:	JUNG
Kategori:	Termostat
Model:	FTRGO231

Har du brug for hjælp?

Hvis du har brug for hjælp til JUNG FTRGO231 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Termostat JUNG Manualer

JUNG CD 500 Manual

7 August 2025

JUNG TRDCD231 Manual

1 Oktober 2024

JUNG TRDLS-DISPWW Manual

28 August 2024

JUNG TRDA523048WW Manual

28 August 2024

25 August 2024

25 August 2024

24 August 2024

16 August 2024

16 August 2024

9 August 2024

Termostat Manualer

Nyeste Termostat Manualer

Honeywell CT30A1005 Manual

14 August 2025

Honeywell RTH6450D Manual

14 August 2025

Honeywell CT62B1015/U Manual

14 August 2025

Renkforce MH-810HN Manual

14 August 2025

Honeywell RTH2310B1002/A Manual

13 August 2025

Honeywell CT53K1006/E Manual

13 August 2025

Honeywell CT87N1001/E1 Manual

13 August 2025

Honeywell RTH6580WF1001/U Manual

13 August 2025

Fantini Cosmi C900R Manual

13 August 2025

GE RAK190V Manual

12 August 2025