K&K Sound Mandolin Twin Fusion Manual

K&K Sound Ikke kategoriseret Mandolin Twin Fusion

Læs gratis den danske manual til K&K Sound Mandolin Twin Fusion (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 20 anmeldelser. Har du et spørgsmål om K&K Sound Mandolin Twin Fusion, eller vil du spørge andre brugere om produktet?

Side 1/5
92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541 888 3517 | Toll Free 800 867 6863 | kksound.com- - - -
M A N D O L IN T W I N F U S IO N
Thank you for choosing the Mandolin Twin Fusion!
This pickup system can easily be installed by the musician. It provides the same great sound as the
fully internal Mandolin Twin System offered by K&K Sound but it does not require any permanent
alteration to your instrument.
INSTALLATION
1. The picture shows the desired locations of the two transducers
inside the mandolin. In some models the two braces will run
differently than shown here.
If a brace does not allow you to place the pickup next to the
exact center (the widest part) of the F hole, just move the pickup
up or down a bit until you find a spot that fits the transducer.
However, move it a little as possible from the position shown.
2. The materials you will need for installation, from left to right:
Scissors, tweezers (if you do not have tweezers handy, a pair of
small needle-nose pliers will work just fine). In the sales
package, locate the bent nail (this is your installation tool), the
putty piece (gray putty on brown/white paper), the double-stick
tape (on brown/white paper), and, of course, the pickup.
92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541 888 3517 | Toll Free 800 867 6863 | kksound.com- - - -
2
3. Apply double stick tape to the golden side of the transducers, it is a very thin film:
We recommend applying two layers of the double stick tape. After the first layer is applied as shown, peel
off the brown protective tape. Repeat the procedure. This helps to reduce the sensitivity towards unwanted
mechanical transmissions and guarantees the most secure adhesion.
4. Put the transducers into the treble side F-hole. If you have a pick-guard, remove it temporarily.
Maneuver the bass side pickup over to the bass side F hole, - and fish it out with tweezers or needle-nose
pliers.
5. Locate the putty piece and form a round ball from it.


Produkt Specifikationer

Mærke: K&K Sound
Kategori: Ikke kategoriseret
Model: Mandolin Twin Fusion

Har du brug for hjælp?

Hvis du har brug for hjælp til K&K Sound Mandolin Twin Fusion stil et spørgsmål nedenfor, og andre brugere vil svare dig