• T r f ar s uct out t et ca ot he impo tant sa egu ds and in tr ions lined in his she nn
cov le c t t that may occur. t st be er all possib ondi ions and situa ions I mu
unde ood hat tain be ol ed. hesrst t caut cerion and care factors ust m f low T e
in ions ided sa high endstruct ar rove p fo yor ur fet we y and ly recomm that a
li ensed, trician in tall his nic tra lecined e s t u t.
• T ur t ount correctl stall sta ard his fixt e is designed o be m ed on a y in ed nd
rou oc o throu r bo ith a e r T bond or tagon b x OR gh a wi ing x w a pl st r f ame. he x
mu be sec oun ed he e he ding. he ossbst urely m t to t st cturru o tf buil T cr ar and
ha pplied sho be used, di ing he herdware su uld rectly mount t fixture to t o
bo ma ke le to correctl t ure.x y ma it impossib y align he fixt
W D CA I SARNINGS AN UT ON
· Make sure is POWER COMPLETELY OFF at the fuse box
· Have your fixture installed by a qualified licensed electrician
· Prepare everything in a clear area
· Wear gloves at all times during this installation
· Read instructions carefully before you start assembly
· Keep this installation sheet for future reference
C DA:ANA 19054 28 - Sur V3Z 6Mth Ave., rey, C B 3
USA: 3035 E L i Rd. V. one Mounta n - Las egas, N 1V 8908
TE CH N I C PO TA L SU P R
te cal pport lor .comchni su @a alighting
Remove fixture from its original package.
Separate mounting plate (1c) from canopy (2a) by removing
washers (2c) and canopy screws (2b).
Attach mounting plate (1c) to electrical junction box (1a) using
junction box screws provided (1e) in hardware package.
Make proper electrical connections (black hot white to “L”, to
neutral ground “N”, to “GND”) with wire nuts (1b) provided in
Attach canopy (2a) to mounting plate (1c) with washers (2c) and
Install recommended lamp (4a) (not provided) (referred on the
socket label for maximum wattage and type) to fixture socket.
Attach glass (3b) to fixture (3a) by threading clockwise.
To prevent moisture from entering the electrical junction box (1a)
and causing a short, seal around the top and side perimeter
between the fixture and the wall surface with weather resistant
caulking (Illustration 1). The space at the bottom should be left
un-caulked to prevent moisture build up.
You are now ready to enjoy your fixture.
