Brew Your First Cup
Plug & Place
Remove packing tape from brewer.
Plug into an outlet.
Place a large mug (10oz minimum)
on the drip tray.
Cleansing Brew
The 3 cup sizes will blink. Press the 8oz
button, then press the blinking BREW
button to start a cleansing brew. Pour
the hot water into the sink.
Do not remove the water reservoir or
lift the handle once the BREW button
has been pressed until the brew has
completed. The one-time setup process is
now complete and you are ready to brew!
Lift & Lower
Lift and lower the handle. Do not
insert a K-Cup® pod. The brewer will
power on automatically.
Rinse & Fill
Remove the water reservoir lid, then lift
the reservoir straight up to remove it.
If you have a Keurig® Water Filter (sold
separately), install it now. Refer to your
Water Filter Starter Kit for instructions.
Rinse reservoir with fresh water and fill
to the MAX FILL line.
Replace water reservoir, making sure
the tank is seated properly in the base.
Replace lid.
NOTE: Do not use distilled water.
Brew & Enjoy!
The 3 brew size buttons will blink. Select
your brew size, then press the blinking
BREW BREW button. The button will
remain illuminated while brewing. Brewing
is complete when all the buttons are
illuminated. Lift the handle and dispose
of the K-Cup® pod. For a bolder brew, the
STRONG button may be turned on before
or after brew size is selected.
CAUTION: While brewing, there is extremely hot water in the
K-Cup® pod holder. To avoid injury, do not lift the handle during
the brewing process.
Place Mug & Pod
Place a mug on the drip tray. If using a
travel mug, remove the drip tray and
place the mug on the drip tray base.
Lift the handle and place a K-Cup®
pod in the K-Cup® pod holder. Lower
the handle completely to close the lid.
Do not remove the foil lid on the
K-Cup® pod.
1 2
3
5
4
6
8 10
ADD WATER DESCA LE
12
STRONG