
Press the blinking button; the BREW
BREW button light will remain illuminated
while brewing. Brewing is complete when
all lights turn off. Pour the hot water into
Do not remove the water reservoir or lift
the handle once the button has been BREW
pressed until the brew has completed.
The one-time setup process is now
complete and you are ready to brew!
Plug the brewer in. Remove the water
reservoir by lifting it straight up from
the brewer. Remove the lid and rinse
the reservoir with fresh water. Fill the
reservoir with fresh water up to the
8 oz line. Replace the lid. Replace
reservoir, making sure it is seated
properly in the brewer. Place a large
mug (10 oz minimum) on the drip tray.
NOTE: Do not use distilled water.
Open the handle by lifting straight
up as shown. Do not insert a
K-Cup® pod. Close the handle by
pushing straight down. The BREW
button will blink, indicating the
handle is closed properly.
Remove the water reservoir by
lifting it straight up from the
brewer. Remove the lid and
ill reservoir with water to the
desired brew size. Replace the
lid. Replace reservoir, making
sure it is seated properly in
NOTE: Do not use distilled water.
Press the blinking BREW button;
the button light will remain BREW
illuminated while brewing. Brewing
is complete when all lights turn off.
CAUTION: While brewing, there is
extremely hot water in the K-Cup®
pod holder. To avoid injury, do not lift
the handle during the brewing process.
After brewing one-step latte
beverage, do a water rinse cycle.
Place a mug on the drip tray. If using a
travel mug, remove the drip tray and
place the mug on the counter in the drip
tray location. Open the handle and place
a K-Cup® pod in the K-Cup® pod holder.
Close the handle by pushing straight
down. The BREW button will blink,
indicating the handle is closed properly.
Do not remove the foil lid on the