Keystone KSTSLV1 Manual


Læs gratis den danske manual til Keystone KSTSLV1 (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Keystone KSTSLV1, eller vil du spørge andre brugere om produktet?

Side 1/3
THROUGH-THE-WALL AIR CONDITIONER
SLEEVE INSTALLATION INSTRUCTIONS
HOW TO ASSEMBLE THE WALL SLEEVE
SLEEVE HARDW ARE
ITEM DESCRIPTION QT Y
1 TOP PANEL 1
2 BOTT OM PANEL 1
3
4
5
6
7
8
9
10
LEFT SIDE P ANEL
RIGHT SIDE P ANEL
FRONT COVER P ANEL
REAR COVER P ANEL
BRACKET
CLASP FOR SLEEVE
SCREW ST3.9*10
WASHER
1
1
1
1
4
4
28
8
SLEEVE DIMENSION
SLEEVE INST ALLA TION
INSTALL THE UNIT
ASSEMBLE THE WALL SLEEVE
Use four screws to fasten the side panels on the bottom panel as shown
below.
NOTE:The arrow marks on the bottom panel indicate the direction of
indoor side
Place the top panel on the top and fasten with four screws as shown
below.
CLASP FOR SLEEVE
Insert the four clasps for sleeve into the quadrate holes in the side panels
as shown below.
SLEEVE
INSIDE OUTSIDE
WALL
Remove the old air conditioner from the existing wall sleeve and remove
the existing wall sleeve.
Prepare and install the new wall sleeve into the wall opening.
The wall sleeve must be fastened in the wall secuerly before installing the
new air conditioner.
Keep the cover panels for later use to protect the sleeve from rainy or
windy weater.
To avoid distortion to the front panel of the air conditioner,the sleeve
should be installed at a distance of 4 minimum from heating source.
(e.g.Baseboard heating,radiator.etc.)
After sleeve has been installed,caulk where necessary entire perimeter
around exterior wall opening and sleeve.Use a good grade of caulking
compound to seal all cracks against air and water infiltration.
The rear grill and washer scerws should be kept well until the air conditio-
ner is installed.
Insert the louvered rear grille or the expanded rear grille (packed with air
conditioner you purchased) and fasten with 4 washer screws as shown
below.
Expanded rear grille Louvered rear grille
or
1
2
5
6
79
10
8
3
4
ASSEMBLE THE WALL SLEEVE (CONTINUED)
FIG.A FIG.B
WALL WALL
First put the assembled sleeve into the wall opening as shown below ,
then place the air conditioner into the sleeve.
SLEEVE SLEEVE
INSTALL THE COVER PANELS(when not using air conditioner for
a long time.)
FIG.C
INSTALL THE COVER PANELS(CONTINUED)
FIG.F
FIG.D
FIG.E
NOTE:To improve the firmness of the sleeve, it is recommended to
install 8 more screws as shown below.
Install two brackets on the top and one bracket on each
side of the sleeve, fasten with four screws.There are two
methods for your choice to install the brackets as shown
in FIG. A and FIG.B.
NOTE: Choose anyone hole in the bracket as you prefer
to fasten the screws on the sleeve.
To install cover panel at the back of sleeve,first remove air conditioner
from sleeve.
Take the louvered rear grille or the expanded rear grille out by
loosening the four washer screws as shown in FIG.C.
From the inside of the sleeve,insert the rear cover panel and re-insert
the four washer screws through the panel,then tighten them as shown
in FIG.D and FIG.E.
Use the front panel to cover the front of the sleeve.Fasten with 4
screws as shown in FIG.F.
CW031I-TTWQT 202000192293 20110630
Expanded rear grille
or
Louvered rear grille


Produkt Specifikationer

Mærke: Keystone
Kategori: Ikke kategoriseret
Model: KSTSLV1

Har du brug for hjælp?

Hvis du har brug for hjælp til Keystone KSTSLV1 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Keystone Manualer

Keystone

Keystone KSTSLV1 Manual

11 Januar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer