KitchenAid KUID508HBL Manual

KitchenAid Isterningmaskine KUID508HBL

Læs gratis den danske manual til KitchenAid KUID508HBL (37 sider) i kategorien Isterningmaskine. Denne vejledning er vurderet som hjælpsom af 75 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 38 anmeldelser. Har du et spørgsmål om KitchenAid KUID508HBL, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/37
ICE MAKER INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
DELAMACHINE À GLAÇONS
INSTRUCCIONES DE INSTALACIÓN
DELAFÁBRICA DE HIELO
W11255279A
Table of Contents
ICE MAKER SAFETY
ICE MAKER SAFETY ..................................1
INSTALLATION INSTRUCTIONS ...............2
Unpack the Ice Maker ..............................2
Location Requirements ............................ 2
Electrical Requirements ...........................3
Water Supply Requirements ....................3
Vacation or Extended Time Without Use ..3
Connect Water Supply ............................. 4
Drain Pump Installation ........................... 5
Drain Connection .....................................7
Door Reversal—Side Swing Only ............9
Leveling ..................................................11
Cleaning .................................................11
SÉCURITÉ DE LA MACHINE
À GLAÇONS ..............................................13
INSTRUCTIONS D’INSTALLATION .........14
Déballage de la machine à glaçons ....... 14
Exigences d’emplacement .....................14
Spécications électriques ...................... 15
Spécications de l’alimentation en eau ..15
Vacances ou longue période
d’inutilisation ..........................................16
Raccordement à la canalisation d’eau ..16
Installation de la pompe de vidange ......17
Raccord au drain ....................................20
Inversion du sens de la porte –
porteàouverture latérale uniquement ...21
Ajustement de l’aplomb ......................... 23
Nettoyage ............................................... 23
SEGURIDAD DE LA FÁBRICA
DE HIELO ..................................................25
INSTRUCCIONES DE INSTALACIÓN ..... 26
Cómo desempacar la fábrica de hielo ... 26
Requisitos de ubicación ......................... 26
Requisitos eléctricos .............................. 27
Requisitos de suministro de agua ......... 27
Vacaciones o tiempo prolongado
sin uso ....................................................28
Conexión del suministro de agua ..........28
Instalación de la bomba de desagüe .....29
Conexión de desagüe ............................ 32
Reversión de puertas—
Solo lado de apertura .............................33
Nivelación ............................................... 35
Limpieza .................................................35
Table des matières
You can be killed or seriously injured if you don't immediately
You can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
Índice
2
INSTALLATION INSTRUCTIONS
Unpack the Ice Maker
Removing Packaging Materials
Remove tape and glue from your ice maker before using.
To remove any remaining tape or glue from the exterior of the
ice maker, rub the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing a small amount
of liquid dish soap over the adhesive with your ngers. Wipe
with warm water and dry.
Do not use sharp instruments, rubbing alcohol, ammable
uids, or abrasive cleaners to remove tape or glue. Do not
use chlorine bleach on the stainless steel surfaces of the ice
maker. These products can damage the surface of your ice
maker.
Cleaning Before Use
After you remove all of the packaging materials, clean the inside
of your ice maker before using it. See the cleaning instructions in
the “Ice Maker Care” section.
Location Requirements
To ensure proper ventilation for your ice maker, the front
side must be completely unobstructed. The ice maker may
be closed-in on the top and three sides, but the installation
should allow the ice maker to be pulled forward for servicing if
necessary.
Installation of the ice maker requires a cold water supply inlet
of 1/4" (6.35 mm) OD soft copper tubing with a shutoff valve
or a Whirlpool supply line Part Number 8212547RB, and a
Whirlpool approved drain pump, Part Number 1901A, only to
carry the water to an existing drain.
Choose a well-ventilated area with temperatures above 55°F
(13°C) and below 110°F (43°C). Best results are obtained
between 70°F and 90°F (21ºC and 32°C).
The ice maker must be installed in an area sheltered from the
elements, such as wind, rain, water spray, or drip.
When installing the ice maker under a counter, follow the
recommended opening dimensions shown. Place electrical
and plumbing xtures in the recommended location as shown.
NOTES:
Check that the power supply cord is not damaged or
pinched or kinked between the ice maker and the cabinet.
Check that the water supply line is not damaged or
pinched or kinked between the ice maker and the cabinet.
Check that the drain line (on some models) is not
damaged or pinched or kinked between the ice maker and
the cabinet.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
: To reduce the risk of fire, electric shock, or injury when using your ice maker, follow these basic
precautions:
SAVE THESE INSTRUCTIONS
Plug into a grounded prong outlet.3
Do not remove ground prong.
Do not use an adapter.
Do n uot se an extension cord.
Disconnect power before manually cleaning the inside components.
D .isconnect power before servicing
Replace all nels parts and pa before operating.
Use two or more people to move and install ice maker.
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of California to cause cancer.
WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or
other reproductive harm.
WARNING
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.

Produkt Specifikationer

Mærke: KitchenAid
Kategori: Isterningmaskine
Model: KUID508HBL

Har du brug for hjælp?

Hvis du har brug for hjælp til KitchenAid KUID508HBL stil et spørgsmål nedenfor, og andre brugere vil svare dig


Isterningmaskine KitchenAid Manualer

KitchenAid

KitchenAid KUIX335HPS Manual

20 December 2023
KitchenAid

KitchenAid KUID508HBL Manual

21 Oktober 2023
KitchenAid

KitchenAid KUIS15NNZW Manual

30 September 2023
KitchenAid

KitchenAid KUIO18NNZS Manual

13 September 2023
KitchenAid

KitchenAid KUIS18PNZW Manual

6 Juni 2023
KitchenAid

KitchenAid KUIS18NNZB Manual

7 November 2022
KitchenAid

KitchenAid Architect 18 inch Manual

17 Oktober 2022

Isterningmaskine Manualer

Nyeste Isterningmaskine Manualer

Domo

Domo DO9292IB Manual

18 Juni 2025
Ice-O-Matic

Ice-O-Matic ICEU150 Manual

17 Juni 2025
Hoshizaki

Hoshizaki KM-1601SWJ3 Manual

16 Juni 2025
Ice-O-Matic

Ice-O-Matic MFI1256W Manual

15 Juni 2025
Ice-O-Matic

Ice-O-Matic GEM0650R Manual

15 Juni 2025
Ice-O-Matic

Ice-O-Matic GEM0450W Manual

15 Juni 2025
Ice-O-Matic

Ice-O-Matic MFI0800W Manual

15 Juni 2025
Ice-O-Matic

Ice-O-Matic GEM0650W Manual

15 Juni 2025
Ice-O-Matic

Ice-O-Matic GEM0956W Manual

15 Juni 2025
Hoshizaki

Hoshizaki AM-50BAJ Manual

15 Juni 2025