KoolScapes KSPK-84 Manual

KoolScapes Ikke kategoriseret KSPK-84

Læs gratis den danske manual til KoolScapes KSPK-84 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om KoolScapes KSPK-84, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Please Read These Instructions Carefully Before Use!

84-GALLON POND KIT

KSPK-84

Installation Manual

ASSEMBLING YOUR PUMP

Place desired fountain head (1) on riser (2)

pushing down until snug.

Adjust the size of the waterbell by turning

the round piece (3) on top.

Put riser (2) into diverter (4), pushing down

until the hole is no longer visible.

Some light force may be required.

Adjust the flow of water to your fountain

head by turning the diverter knob (5).

Attach all to the pump (6) by pushing

down the diverter into the hole located on

top of the pump (6).

FOR A HIGHER FOUNTAIN HEAD

• Extend the tube extention (7) found

inside the riser (2).

FOR A WATERFALL

• Place clamp over tubing.

• Fit tubing over diverter.

• Tighten clamp over tubing with a flat

head screwdriver.

NOTE

Do NOT plug in your pump until it is fully immersed in water. Never run your pump dry!

WARRANTY

This KOOLATRON product is warranted to the retail consumer for 90 days from

date of retail purchase, against defects in material and workmanship.

WHAT IS COVERED

- Replacement parts and labor.

- Transportation charges to customer for the repaired product.

WHAT IS NOT COVERED

- Commercial or industrial use of this product.

- Damage caused by abuse, accident, misuse, or neglect.

- Transportation of the unit or component from the customer to Koolatron.

IMPLIED WARRANTIES

Any implied warranties, including the implied warranty of merchantability are also

limited to duration of 90 days from the date of retail purchase.

WARRANTY AND SERVICE PROCEDURE

Keep the original, dated, sales receipt with this manual. If you have a problem with

your unit, or you require replacement parts, please telephone the following number

for assistance:

1-800-265-8456

A Koolatron Master Service Centre must perform all warranty work. Service after warranty

may be obtained at a Master Service Centre or at an authorized service dealer.

Purchase Receipt is required to establish warranty eligibility.

Koolatron has Master Service Centres at these locations:

U.S.A. - 4330 Commerce Dr., Batavia, NY 14020-4102

Canada - 139 Copernicus Blvd., Brantford, ON N3P 1N4

www.koolatron.com

All specification are subject to change without notice.

Made in China

5/2020-v4H1S087

FEATURES

The popularity of backyard ponds continues to grow at a vigorous pace. This kit includes

everything you need to construct a beautiful, low maintenance water garden.

- 8ft x 10ft non-toxic Pond Liner

- 200gph Filter Free Pump

with protective shell

- Water-bell Fountain Head

- 3-tier Fountain Head

- Telescopic Riser

- Diverter with flow control

- 2 silk Water Lilies

- 1 Solar Glo - floating pond light

- Installation Manual

ELECTRICAL

- Pump Voltage: 110V

- Pump Capacity: 200 gallons/hour

- Pump Power Consumption: 12W

- Pump cULus: E 204083

INSTALLATION

YOU WILL NEED

flat head

screwdriver

rope edging material

(i.e.rock)

garden shovel

TO START

Once you gathered everything you need, it is time

tostart. It is important to take the time to design your

pond before beginning. Keep in mind the depth and

width of your pond compared to the size of liner you

have to work with. Once you have a style and size

inmind mark the shape using heavy rope. Be mindful

ofburied wires and pipes. Ensure electric cable will

reach pump.

INSTALLATION (cont.) INSTALLATION (cont.)

ADDING WATER

Your pond is now ready to fill with water. As the pond

is filling you may want to smooth major wrinkles in

the liner by pulling and shifting the liner. Once the

pond is about half full remove some of the anchor

stones to allow the liner to sink to the bottom of the

hole.

CARE AND MAINTENANCE

With the proper care and maintenance this pond will last a very long time and look more

beautiful with each year. Simple steps can be taken to ensure a long life from your pond.

Clean your pump regularly to prevent build up. If your pump stops working, unplug it and

take it out of the pond. Follow the care instructions given in your pump kit box. If there is

a lot of calcium build up on your pump it may stop working. To clean, simply place the

pump motor (remove attachments) in vinegar water then plug it in. Let the pump run for

about 30 seconds. Once cleaned rinse your pump with water and place back in pond.

WINTER CARE

Getting ready for winter may seem like an arduous task, but if the right steps are taken it

can be very beneficial to your pond and any life within it. During the fall months the pond

should be kept free from fallen leaves and other debris that may rot and cause harmful

toxins in your pond. Once the temperature reaches 43°F (6°C) outside, it is time to winterize

your pond. The first step is to remove any submersible pumps and clean them for winter

storage. If you have fish the next step is to add a Pond Breather or Floating Pond Heater

to circulate oxygen and release toxic gases. After the pond has been winterized and the

ice has formed, there isn’t much work to be done during the winter months. The fish will

naturally go to deeper depths of the pond where the water is warmer and require no

feeding during these cold months. Never allow water to freeze in the pump.

FINISHING

Once your pond is full you should use some long

nails to secure the liner in place. Cut off any excess

liner. Using decorative rocks around the edge will

help hold the liner in place and give your pond a

more natural look. Place the pump in your pond,

then plug it in. If adding plants to your pond you

should wait 48 hours after completion, and if adding

fish you should wait 72 hours after completion.

DECORATE AND ENJOY!

DIGGING

Start by removing the sod in the area you have

marked with the rope. It is best to start digging from

the middle out. This will allow you to easily remove

dirt with a wheelbarrow. When digging, keep in mind

that most ponds have plant shelves. These shelves

are traditionally 6" below water level and should be

at a 20° angle for support.

PREPARATION

To prepare the hole for the liner you must remove

anysharp stones or roots. Sharp objects could

puncture\or ruin your liner. You may put 5-8cm (2-3in)

of sandat the bottom of the pond, but it is not necessary.

Once the area is clear, place the provided liner inside

the hole, friends or family may be required for help.

Hold the liner in place using some of the rocks for

theedging.

WARNING! This product contains chemicals known to

the State of California to cause cancer, and birth defects

or other reproductive harm. www.P65Warnings.ca.gov

Produkt Specifikationer

Mærke:	KoolScapes
Kategori:	Ikke kategoriseret
Model:	KSPK-84

Har du brug for hjælp?

Hvis du har brug for hjælp til KoolScapes KSPK-84 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret KoolScapes Manualer

KoolScapes WTCB-50 Manual

23 Juli 2025

KoolScapes PJ-200 Manual

28 Juni 2025

KoolScapes FSK-01 Manual

26 Juni 2025

KoolScapes KSPK-270SL Manual

26 Juni 2025

KoolScapes PJ-530 Manual

25 Juni 2025

KoolScapes PJ-340 Manual

25 Juni 2025

KoolScapes KSPK-400G-SL Manual

25 Juni 2025

KoolScapes FJ-200 Manual

7 Juni 2025

KoolScapes CSFK-5 Manual

7 Juni 2025

KoolScapes FJ-92 Manual

7 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Navman MY500XT Manual

1 August 2025

Navman FOCUS150 GPS Manual

1 August 2025

Scheppach TW1000 Manual

1 August 2025

Navman MiVue 750 WIFI Manual

1 August 2025

Navman MiVue Drive FHD Manual

1 August 2025

Midea MEC64 Manual

1 August 2025

Navman MY50T Manual

1 August 2025

Navman M100 Manual

1 August 2025

Navman MiVue 770 SAFETY Manual

1 August 2025

Navman MiVue 790 Manual

1 August 2025