IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, these instructions and warnings should always be
followed to reduce the risk of fi re, electrical shock, injury to persons and hyperthermia:
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, ALWAYS FOLLOW
THESE IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS:
Plug heaters directly into a 120v wall outlet/receptacle only. Never use with an extension cord. Do not plug heater into any other cord Plug heaters
directly into a 120v wall outlet/receptacle only. Never use with an extension cord. Do not plug heater into any other cord connected device, such
as a power strip, surge protector, multiple outlet adapter, cord reel or outlet-type air freshener. The use of such devices may create a fi re hazard.
Do not plug multiple devices in the same outlet or on same circuit as heater.
Faulty wall outlet connections may cause the wall outlet to overheat. Be sure that heater plug fi ts tightly into outlet before each use. During use,
check to make certain the heater plug is not overheating. If necessary have a qualifi ed electrician check and/or replace the wall outlet. Do not use
this heater with any solid state speed control devices.
Make certain that the power source conforms to the electrical requirements of the heater.
Extreme caution is necessary when any heater is used by or near children or invalids. The heater should not be left operating unattended. Never
leave children unattended when the heater is on or plugged in.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fi t in a
polarized outlet only one way. If the plug does not fi t fully in the outlet, reverse the plug. If it still does not fi t, contact a qualifi ed electrician. Do not
attempt to defeat this safety feature.
Do not use the heater in areas where gasoline, paint, or fl ammable liquids are used or stored. Do not use heater in locations where fl ammable or
explosive chemicals are stored, or in wet atmospheres.
Do not operate any heater with a damaged cord or plug or after the heater malfunctions, or has been dropped or damaged in any manner. To
disconnect heater, turn the heater off then remove the plug from the outlet.
Always unplug heater when not in use. Unplug power cord before servicing or moving the heater.
Do not insert or allow fi ngers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock, fi re, or damage the
heater. Do not block or tamper with the heater in any manner while it is in operation.
Do not block air intakes or exhaust in any manner. Do not place on soft surfaces, like a bed, where openings may become blocked. Do not
depend on the on/off switch as the sole means of disconnecting power when servicing or moving the heater. Always unplug the power cord.
Hyperthermia can result in death. Symptoms of hyperthermia include high body temperature, headache, nausea, vomiting, tiredness, dizziness,
fainting, and rapid pulse. If you begin to experience symptoms related to hyperthermia, turn off the heater and seekmedical attention.
To avoid excessive room temperatures which can cause hyperthermia: DO NOT leave product running unattended in a confi ned space around
infants, or individuals with reducedphysical, sensory, or mental capabilities.
• Always unplug heater when not in use. Unplug power cord before servicing or moving the heater.
• Do not insert or allow fi ngers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock, fi re, or damage
the heater. Do not block or tamper with the heater in any manner while it is in operation.
• Do not block air intakes or exhaust in any manner. Do not place on soft surfaces, like a bed, where openings may become blocked. Do not
depend on the on/off switch as the sole means of disconnecting power when servicing or moving the heater. Always unplug the power cord.
• Always place the heater on a stable, fl at, level surface when operating, to avoid the chance of the heater overturning. Locate the power cord
so the heater or other objects are not resting on it. Do not run power cord under carpeting. Do not cover power cord with throw rugs, runners,
or similar coverings as this may cause cord to overheat. Arrange power cord away from room traffi c and where
it will not be tripped over.
• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handle when moving this heater. Keep
combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 M) from the front of the heater and
keep them at least 1 foot (0.3 M) from the sides and rear.
• This heater is not intended for use in wet or damp locations. This heater is not intended for use in bathrooms, laundry areas and similar
indoor locations. Never locate a heater where it may fall into a bathtub or other water container.
• Do not use heater outdoors.
• This heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confi ned. Please refer
to national electric code (nec) article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for
agricultural buildings. This heater does not meet the requirements of nec article 547-7 (2008).
• This heater is not suitable for use in hazardous locations. Please refer to national electric code (nec) article 500 or applicable state or local
codes or standards relating to electrical requirements for hazardous locations. This heater does not meet the requirements of
• Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this heater. If this occurs, move
the heater to another location.
• Keep heater remote control unit away from chairs and your bed where it may be sat or laid upon and inadvertently turn on the heater.
• Install two “AAA” batteries (included).
• Do not mix old and new batteries. Do not mix al ka line, stan dard (carbon-zinc)
or rechargeable (nickel-cad mi um) batteries.
• Do not dispose of batteries in fi re. Batteries may explode or leak.
• Always purchase the correct size and grade of battery most suitable
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery in-
• Ensure the batteries are installed correctly with regards to polarity (+ and -).
• Remove batteries from equipment that is not to be used for an
• Remove used batteries promptly.
Read all instructions before using this Heater. Save these instructions
* PARA UNA DESCRIPCIÓN MÁS DETALLADA DE FUNCIÓN AUTO ECO
1 Cuerpo 3 Control Remoto
2 Cubierta del Filtro 4 Baterías
3. Use un cepillo de dientes u otro cepillo de
cerdas suaves para afl ojar suavemente
cualquier polvo que no haya sido retirado
por la aspiradora. Vuelva a colocar la Tapa
2. Aspire las parrillas de entrada cada dos
semanas; esto ayudará a mantener el
rendimiento óptimo del Calefactor.
1. Presione la lengüeta hacia adentro y
luego retire la Cubierta del Filtro de la
parte espalda del Calefactor.
El temporizador se puede confi gurar hasta 12 horas. 0.5 - 12.0
horas en intervalos de 0.5 horas hasta 2 horas, incrementos de
1 hora de 2 horas a 12 horas. Continúe presionando el botón del
temporizador para alcanzar la confi guración de tiempo deseada.
ENCENDIDO/APAGADO el Calefactor presionando el Botón de
El calor se puede ajustar a H3 (Alto), H2 (Medio) o H1 (Bajo).
Botón de Oscilación de Base
Presione para Iniciar/Detener la función de oscilación de la base.
Botón de rotación de la parrilla
Pulse para arrancar/detener la función de rotación de la parrilla.
Para un calor enfocado, presione nuevamente el botón de rotación
de la parrilla. Esto detendrá la parrilla en
Su ubicación deseada, proporcionando un calor más enfocado.
* Botón de termostato ecológico™ automático (+)
Púlselo para aumentar la temperatura ambiente deseada.
Bloqueo de niños (cuando se mantiene con Temp - durante 3
* Botón de termostato ecológico™ automático (-)
Presione para disminuir la temperatura ambiente deseada.
Bloqueo de niños (cuando se mantiene con Temp + durante 3
Pulse el botón MODO NOCTURNO del mando a distancia para
activar el modo nocturno. El icono del BOTÓN DE CALOR se
iluminará para reconocer que el modo nocturno está activado y
todos los demás iconos se apagarán. Al tocar cualquier botón de
la unidad o control remoto, se desactivará el modo nocturno.
BLOQUEO PARA NIÑOS (Activar):
Cuando el botón Auto Eco (+) y el botón Auto Eco™ (-) se mantienen juntos
durante 3 segundos, todas las funciones del calefactor se desactivan, excepto
el botón de encendido. Todas las funciones que están activadas actualmente
permanecerán activadas. El segement dispays mostrará “CL”.
BLOQUEO DE NIÑOS (Desactivar):
Para desactivar el bloqueo para niños, pulse el botón Auto Eco (+) y el botón
Auto Eco™ (-) juntos durante 3 segundos. La función de bloqueo para niños se
desactivará. Desenchufar la unidad también desactivará la función de
