Copyright © 2016 Lauten Audio www.lautenaudio.com –
This microphone comes with a from date of sale from authorized dealer/distributor. I1 year limited warranty tems limited to 90-days
coverage include shock mounts, shock mount bands, cases, boxes, cables, microphone bags, and vacuum tubes.
1. Make sure the interface or mixer channel volume is turned down.
2. VERY IMPORTANT Make sure the proper voltage for your country is selected on the rear of the power supply.
3. Using the included cable, connect the microphone to the power supply.
4. Connect the microphone power supply to your mixer or audio interface with a standard 3-pin XLR connector.
5. Turn on the power supply and allow the microphone to warm up for at least 10 minutes before use.
6. Slowly increase volume on mixer or interface to check for sound. NEVER BLOW AIR INTO THE MICROPHONE GRILL, use a
normal speaking voice to test.
7. If recording vocals, Lauten Audio recommends using a pop lter to reduce plosives and prevent moisture from geng on and
damaging the microphones capsule.
The Series Black LA-320 large diaphragm vacuum tube condenser microphone
by Lauten Audio is a professional and versale microphone for studio
recording. This microphone features a 1" gold spuered diaphragm with
cardioid polar paern, dual-triode vacuum tube, 120 Hz low-cut lter, 12 kHz
high-cut lter, and transformer balanced output. The low-cut lter helps
reduce boomy lows or low-end rumble; the high-pass lter helps to tame
bright sources. These features help you to achieve excellent recordings
regardless of your skill level.
This microphone is a professional level piece of audio equipment. prevent To
voiding the warranty, only authorized technicians should disassemble any
part of this microphone. Use a sturdy microphone stand to prevent dropping
your microphone that can cause severe damage. When the microphone is as
not in use, take it out of its mount and place it in a case or in a safe place.
Always cover the microphone with a lint-free material when le on the stand.
Wipe with a slightly dampened cloth, being careful to never get any moisture
Type: large diaphragm pressure gradient vacuum
Frequency response: 20Hz to 20 kHz
Special features: Selectable, independent 120Hz
low-cut 12 kHz high-cut & filters
Sensivity: 14mV/Pa (@ 1 kHz, 74dB SPL)
Output impedance: <200 ohms
Equivalent noise level: <17dB-A Max. SPL (@0,5%):
Power requirement: Special power supply included.
