Livn Basic 10 Manual


Læs gratis den danske manual til Livn Basic 10 (50 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Livn Basic 10, eller vil du spørge andre brugere om produktet?

Side 1/50
EN INFRARED FLOOR HEATING
NL INFRAROOD VLOERVERWARMING
FR CHAUFFAGE AU SOL INFRAROUGE
DE INFRAROT-FUSSBODENHEIZUNG
EN Instruction manual NL Handleiding FR Manuel d'instructions DE Bedienungsanleitung
EN INSTRUCTION MANUAL
Please read the instructions and user manual carefully before installing or using the floor heating,
and keep them retained for future reference. This manual is part of the floor heating and should be
stored with it. If sold to a third party, these user instructions should be supplied with the product.
Liability will not be accepted, and the warrant will not apply, in cases of improper use or failure to
follow the safety instructions. Should you encounter any problems, please contact a qualified
technician for help. For assistance or additional information, contact a qualified technician, the help
desk, or the retail outlet.
HEATING FILM INSTALLATION GUIDANCE
CAUTION!
Suitable for the following types of finishing floors: wooden floors, laminate, parquet and click
PVC (not suitable for adhesive PVC!).
Warning: the wooden floors, laminate, parquet and click PVC must have a minimum thickness of
5 mm and a maximum thickness of 22 mm. Contact your supplier for deviating thicknesses
advice.
Before installation of heating film, clean the floor.
Before installation, waterproof the floor first in case of moisture at the site.
Do not use insulator coated with conductive material like silver foil (you should use heat-resisting
insulator).
Take care not to damage heating film or step on it while installation. In case of damage on heating
film, insulate heating film using thin insulation tape.
Check the contract power when installing heating films. And then you are allowed to install
heating films. If you don’t abide by this, a fire could break out.
Calculate power consumption per 1 m printed on heating film and make sure that 75~80%
electric capacity of a thermostat is not exceeded.
Make sure that you insulate the cut section with insulation tape.
Do not put heavy things like a piano, refrigerator which could cause overheating on heating film.
Livn heating foil may only be installed in dry places.
Thick rugs or other insulating materials should never be placed on a floor with electrical heating.
The thermostat needs to have the floor sensor properly installed to work.
If you have a wooden floor, make sure you set the floor sensor to 28 °C. This function ensures
that the floor never reaches a temperature higher than 28 °C.
Please visually check the foil for creasing or folding that may have happened during transit. Any
such damaged areas must be discarded.
The heating foil should always be installed together with an RCD (Residual Current Device).
Formula for Power Consumption
: Power Consumption (Watt) = V(Voltage)²/R(Resistance)


Produkt Specifikationer

Mærke: Livn
Kategori: Ikke kategoriseret
Model: Basic 10

Har du brug for hjælp?

Hvis du har brug for hjælp til Livn Basic 10 stil et spørgsmål nedenfor, og andre brugere vil svare dig