GC330 Instruction Manual
1
WARNING : Please make sure the polarity of the battery is connected correctly!
:
1.Make sure the charger is shut off and choosing suitable wire s to connect the charger and ba tteries based on the rating of charging
current. The po larity must be correct: charger output (+) should be connected to the (+) term inal of batteries and charger output (-)
should be conne cted to the ( -) terminal.
In no times should the (+) an d (-) be short together or the charge r and batteries will b e da maged.
2.Connect the AC input and check whether the op eration of LED is correct.
(red : charg ing ; green : battery is f ull)
Assembly Procedure
1.The charger should be assembled in the place with good ventilation and low moisture.
Exposure to the rain o r sno w is s trictly prohibited.
2.Wir es connectin g between the charg er and batteries should be as short as possible since the high voltag e dro p on th e wires will
increase the time required to fully c harge the batteries.
3.Make sure the charging voltage an d char ging current are suitable for the batteries you are using.
4.If th e batteries need to c onnect in series for charging, old ba tterie s are not suggested to be used with new ones or th e lifetime of
batteries may reduce because of the unbalance charg ing voltage distribution on new and o ld batteries.
5.Ple ase tu rn off the cha rger before connecting or disconnecting the wires.
6.The charger has a 2-y ear wo rldwide warranty, however, damages from misusing the charge r will not be includ ed in the coverage of
warranty.
Notes On Operation:
PIN NO.
1,2
3,4
Standard male plug(power supply side): AMP 1-480702-0 equivalent
Female plug(customer side, not provide with the power supply): AMP 1-480703- 0 equivalent
OUTPUT
+V
-V
POWER LED
UL2464 16AWGx4C 1000 50mm±
1
2
3
4