Microchip CW01DB1 Manual

Microchip Ikke kategoriseret CW01DB1

Læs gratis den danske manual til Microchip CW01DB1 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om Microchip CW01DB1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Supertex inc.

www.supertex.com

CW01DB1

Doc.# DSDB-CW01DB1

A062014

General Description

The CW01 has 6 logic inputs; OE, CLK, DIN1, DIN2, DIN3,

and DIN4. Every logic input has a 10kΩ pull down resistor.

There are 3 power input voltages: VLL, VDD and VDX. VLL is the

input logic level, typically 2.5V. VDD is the level translator,

typically 5.0V. VDX is the gate drive voltage, and is at the

same voltage level as VDD. High peak currents will be

drawn from VDX during switching. Each supply has a series

ferrite bead and a 0.1µF ceramic chip capacitor to keep the

supply clean from high frequency noise.

There are 4 outputs: HV1, HV2, HV3 and HV4. These are

the connections to the drains of 100V, 7.0Ω, N-channel

MOSFETs.

4-Channel, Low Phase Noise,

Low Power, Continuous Wave Transmitter

Board Layout

Actual Size: 41.0mm x 31.0mm

Parameter Value

VLL 0V to +5.5V

VDD 0V to +5.5V

VDX 0V to +5.5V

Specications

Supertex inc. does not recommend the use of its products in life support applications, and will not knowingly sell them for use in such applications unless it receives

an adequate “product liability indemnification insurance agreement.” Supertex inc. does not assume responsibility for use of devices described, and limits its liability

to the replacement of the devices determined defective due to workmanship. No responsibility is assumed for possible omissions and inaccuracies. Circuitry and

specifications are subject to change without notice. For the latest product specifications refer to the Supertex inc. (website: http//www.supertex.com)