Microchip MEC1703 Manual

Microchip Ikke kategoriseret MEC1703

Læs gratis den danske manual til Microchip MEC1703 (15 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Microchip MEC1703, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/15
2016-2021 Microchip Technology Inc. DS80000704J-page 1
MEC170x
TABLE 1: SILICON IDENTIFICATION
Part
Number Silicon Identifier Functional
Revision C
Functional
Revision E
Functional
Revision F
MEC1701 Device ID(1) 2Dh 2Dh 2Dh
Revision ID for Silicon Revision( )282h 84h 85h
PIS(3) Version/Revision C1 C2 C2
MEC1703 Device ID(1) 2Eh 2Eh 2Eh
Revision ID for Silicon Revision( )282h 84h 85h
PIS(3) Version/Revision F1 F2 F2
MEC1704 Device ID(1) 33h 33h 33h
Revision ID for Silicon Revision( )282h 84h 85h
PIS(3) Version/Revision C1 C2 C2
MEC1705 Device ID(1) 32h 32h 32h
Revision ID for Silicon Revision( )282h 84h 85h
PIS(3) Version/Revision C1 C2 C2
Note 1: The Device ID is visible as an 8-bit number at Plug and Play Configuration Index 20h.
2: The HW Revision Number is visible as an 8-bit number at Plug and Play Configuration Index 21h.
3: Product Identification System (PIS) is defined in the Product Data Sheet.
TABLE 2: SILICON ISSUE SUMMARY
Module Feature Item
Number Issue Summary
Affected Revisions(1)
C E F
SMB Controller SMB Master 1. SMBus Master Controller violates Bus Idle
Time between STO and STA in Byte mode
only
XXX
Boot ROM Crisis Recov-
ery
2. May enter crisis recovery mode in error X X X
JTAG Pins Pins 3. GPIO145 & GPIO146 input disabled in
SWD mode
XXX
EEPROM Con-
troller
TEST 4. For MEC1703 and MEC1705, Test
Register at address 0x4000_2C1C
needs to be programmed to
0x00060101
XXX
ESPI ESPI 5. MAFS flash transfers should be to/from 4-
byte aligned SRAM buffer starting
addresses
XXX
Note 1: Only those issues indicated in the last column apply to the current silicon revision.
2: Please refer to the description below to know a list of parts that are affected.
MEC170x
Silicon Errata and Data Sheet Clarification
MEC170x
DS80000704J-page 2 2016-2021 Microchip Technology Inc.
Silicon Errata Issues
1. Module: SMBus 2.0 Host Controller
DESCRIPTION
SMBus Master Controller violates Bus Idle Time between STO and STA in Byte mode only. This issue only occurs in a
multi-master environment.
Under firmware control, it is possible to generate a new command on the bus before the Bus Idle time expires, thereby
violating the SMBus Idle time.
END USER IMPLICATIONS
The SMBus Master Controller may generate a START condition too soon. The two consequences of this scenario are
that another master will issue a transaction that will get corrupted, which is handled by the lost arbitration mechanism,
or the MEC170x master will unfairly claim the bus too often.
Work Around
There are two solutions:
a) Use the Network Layer instead of Byte mode. This anomaly does not apply to the SMBus Network Layer
operation.
b) If firmware polls the nBB bit to indicate not busy before asserting the PIN bit and writing the data register,
the SMBus Controller will not violate the Bus Idle time.
2. Module: Crisis Recovery Mode
DESCRIPTION
The Boot ROM turns on the internal pull-up on GPIO045 (PVT_STRAP) pin during initialization, then processes the
eFuse settings and samples the GPIO045 input value. It is supposed to sample the pin after waiting a minimum of 1 ms
to determine if it should abort the standard SPI Flash load process and boot from the Crisis Recovery SPI Flash over
the Private SPI Flash interface. However, the boot code turns on the pull-up, does the eFuse processing and samples
the pin immediately without delay. Depending on the external capacitance, this pin may not have enough time to rise to
a high-level and may be misinterpreted as low and enter crisis recovery mode in error.
ROM API’s ROM API’s 6. Some API’s were removed X X
Boot ROM Boot ROM 7. The Boot ROM may not successfully load
Application Code.
X X
ESPI ESPI 8. Host needs to follow recommendations
while changing the Plug and Play base
address
XXX
VBAT VBAT 9. High IBAT current on coin cell insertion X X X(2)
PCR RESETI# 10. Glitch on RESETI# pin during VTR power
up.
XXX
TABLE 2: SILICON ISSUE SUMMARY (CONTINUED)
Module Feature Item
Number Issue Summary
Affected Revisions(1)
C E F
Note 1: Only those issues indicated in the last column apply to the current silicon revision.
2: Please refer to the description below to know a list of parts that are affected.

Produkt Specifikationer

Mærke: Microchip
Kategori: Ikke kategoriseret
Model: MEC1703

Har du brug for hjælp?

Hvis du har brug for hjælp til Microchip MEC1703 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Microchip Manualer

Microchip

Microchip ATmega1281 Manual

19 Juli 2025
Microchip

Microchip ATtiny461 Manual

19 Juli 2025
Microchip

Microchip ATxmega128D3 Manual

19 Juli 2025
Microchip

Microchip ATxmega128D4 Manual

19 Juli 2025
Microchip

Microchip ATTINY28 Manual

19 Juli 2025
Microchip

Microchip ATTINY861 Manual

19 Juli 2025
Microchip

Microchip ATmega1280 Manual

19 Juli 2025
Microchip

Microchip ATtiny84A Manual

19 Juli 2025
Microchip

Microchip ATmega645P Manual

19 Juli 2025
Microchip

Microchip ATmega16A Manual

19 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Navman

Navman MiVue Smartbox 3 Manual

1 August 2025
Navman

Navman MiVue 850 Manual

1 August 2025
Navman

Navman MiVue 690 Manual

1 August 2025
Navman

Navman MiVue 145 GPS TAG Manual

1 August 2025
Navman

Navman MY30 Manual

1 August 2025
Tripp Lite

Tripp Lite SPS610HGRA Manual

1 August 2025
AEG

AEG E1WYHSK1 Manual

1 August 2025
Thermaltake

Thermaltake Pacific R1 Plus Manual

1 August 2025
Olivetti

Olivetti d-Copia 4523MFplus Manual

1 August 2025
Gossen

Gossen GL SpectroSoft Manual

1 August 2025