Microchip PIC32MX270F512L Manual

Microchip Ikke kategoriseret PIC32MX270F512L

Læs gratis den danske manual til Microchip PIC32MX270F512L (72 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Microchip PIC32MX270F512L, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/72

USB On-The-Go

(OTG)

Section 27. USB On-The-Go (OTG)

HIGHLIGHTS

This section of the manual contains the following major topics:

27.1 Introduction .................................................................................................................. 27-2

27.2 Control Registers ......................................................................................................... 27-4

27.3 Operation ................................................................................................................... 27-36

27.4 Host Mode Operation................................................................................................. 27-51

27.5 Interrupts.................................................................................................................... 27-59

27.6 I/O Pins ...................................................................................................................... 27-62

27.7 Operation in Debug and Power-Saving Modes.......................................................... 27-64

27.8 Effects of a Reset....................................................................................................... 27-66

27.9 Related Application Notes.......................................................................................... 27-67

PIC32 Family Reference Manual

27.1 INTRODUCTION

The PIC32 USB OTG module includes the following features:

• USB Full-Speed Support for Host and Device

• Low-Speed Host Support

• USB On-The-Go (OTG) Support

• Integrated Signaling Resistors

• Integrated Analog Comparators for VBUS Monitoring

• Integrated USB Transceiver

• Transaction Handshaking Performed by Hardware

• Endpoint Buffering Anywhere in System RAM

• Integrated Bus Master to Access System RAM and Flash

• USB OTG module does not require the PIC32 DMA module for its operation

The USB OTG module contains analog and digital components to provide a USB 2.0 full-speed

and low-speed embedded host, full-speed device, or OTG implementation with a minimum of

external components. This module in Host mode is intended for use as an embedded host and

therefore does not implement a UHCI or OHCI controller.

The USB OTG module consists of the clock generator, the USB voltage comparators, the trans-

ceiver, the Serial Interface Engine (SIE), a dedicated USB Bus Master, pull-up and pull-down

resistors and the register interface. A block diagram of the USB OTG module is presented in

Figure 27-1.

The clock generator provides the 48 MHz clock, which is required for USB full-speed and

low-speed communication. The voltage comparators monitor the voltage on the VBUS pin to

determine the state of the bus. The transceiver provides the analog translation between the USB

bus and the digital logic. The SIE is a state machine that transfers data to and from the endpoint

buffers, and generates the hardware protocol for data transfers. The USB Bus Master transfers

data between the data buffers in RAM and the SIE. The integrated pull-up and pull-down resistors

eliminate the need for external signaling components. The register interface allows the CPU to

configure and communicate with the module.

Note: This family reference manual section is meant to serve as a complement to device

data sheets. Depending on the device variant, this manual section may not apply to

all PIC32 devices.

Please consult the note at the beginning of the “USB On-The-Go (OTG)” chapter

in the current device data sheet to check whether this document supports the device

you are using.

Device data sheets and family reference manual sections are available for

download from the Microchip Worldwide Web site at: http://www.microchip.com

IMPORTANT: The implementation and use of the USB specifications, as well as other

third-party specifications or technologies, may require licensing; including,

but not limited to, USB Implementers Forum, Inc. (also referred to as

USB-IF). The user is fully responsible for investigating and satisfying any

applicable licensing obligations.

Produkt Specifikationer

Mærke:	Microchip
Kategori:	Ikke kategoriseret
Model:	PIC32MX270F512L

Har du brug for hjælp?

Hvis du har brug for hjælp til Microchip PIC32MX270F512L stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Microchip Manualer

Microchip AT7913 Manual

1 September 2025

Microchip ATmega1281 Manual

19 Juli 2025

Microchip ATtiny461 Manual

19 Juli 2025

Microchip ATxmega128D3 Manual

19 Juli 2025

Microchip ATxmega128D4 Manual

19 Juli 2025

Microchip ATTINY28 Manual

19 Juli 2025

Microchip ATTINY861 Manual

19 Juli 2025

Microchip ATmega1280 Manual

19 Juli 2025

Microchip ATtiny84A Manual

19 Juli 2025

Microchip ATmega645P Manual

19 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Elektrobock PT44 Manual

14 September 2025

BSS Audio FDS-366T Manual

14 September 2025

Systemair Airline R-114 Manual

14 September 2025

IFM SU2031 Manual

14 September 2025

Morel Tempo Ultra Integra 502 Manual

14 September 2025

IMC Networks 232CL9R Manual

14 September 2025

Varta Speed Charger 57955 Manual

14 September 2025

Melissa & Doug 9336 Manual

14 September 2025

Opus dataPREDATOR Manual

13 September 2025

Varta Wireless Power Bank 20000 57909 Manual

13 September 2025