Microchip SY88933AL Manual

Microchip Ikke kategoriseret SY88933AL

Læs gratis den danske manual til Microchip SY88933AL (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Microchip SY88933AL, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
3.3V, 1.25Gbps PECL High-Sensitivity
Limiting Post Amplifier with TTL
Signal Detect
SY88933AL Evaluation Board
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
June 2005
M9999-062705
hbwhelp@micrel.com or (408) 955-1690
General Description
The SY88933AL high-sensitivity, limiting post amplifier
is designed for use in fiber-optic receivers. The device
connects to typical transimpedance amplifiers (TIAs).
The linear signal output from TIAs can contain
significant amounts of noise and may vary in
amplitude over time. The SY88933AL quantizes these
signals and outputs PECL-level waveforms.
The SY88933AL operates from a single +3.3V power
supply, over an industrial temperature range of –40°C
to +85°C. With its wide bandwidth and high gain
signals with data rates up to 1.25Gbps and as small
as 5mV
pp
can be amplified to drive devices with PECL
inputs.
The SY88933AL generates a high-gain, signal-detect
(SD), open-collector, TTL output. The SD function has
a high gain input stage for increased sensitivity. A
programmable signal-detect level set pin (SD
LVL
) sets
the sensitivity of the input amplitude detection. SD
asserts high if the input amplitude rises above the
threshold set by SD
LVL
and de-asserts low otherwise.
The enable input (EN) de-asserts the true output
signal without removing the input signal. The SD
output can be fed back to the enable (EN) input to
maintain output stability under a loss-of-signal
condition. Typically, 3.4dB SD hysteresis is provided
to prevent chattering.
This manual provides information on the SY88933AL
evaluation board. It should be used in conjunction with
the SY88933AL data sheet, which contains full
specifications of the SY88933AL.
The SY88933AL evaluation board enables fast and
thorough evaluation of the SY88933AL. The board is
an easy-to-use, single supply design. It’s designed to
be driven by a high-speed, pattern generator and
provides onboard 50Ω terminations for the generator’s
outputs. The input termination network also provides
the required input bias of V
CC
–1.3V for the
SY88933AL.
The SY88933AL evaluation board is intended to
terminate to a 50Ω scope and provides for simple user
adjustability of the SD threshold through the
adjustment of an on-board potentiometer.
All data sheets and support documentation can be on
Micrel’s web site at: www.micrel.com.
Features
• Single 3.3V supply
• DC-to-1.25Gbps operation
• Low-noise PECL data outputs
• High-gain SD
Chatter-free open-collector TTL signal detect (SD)
output with internal 4.75kΩ pull-up resistor
• TTL EN input
• Programmable SD level set (SD
LVL
)
• Available in a tiny 10-pin MSOP
• AC-coupled I/O with SMA connectors
• 50Ω input network termination
Related Documentation
• SY88933AL, 3.3V, 1.25Gbps PECL High-
Sensitivity Limiting Post Amplifier w/ TTL SD Data
Sheet
Evaluation Board
Micrel, Inc. SY88933AL Evaluation Board
June 2005
2 M9999-062705
hbwhelp@micrel.com or (408) 955-1690
Measurement Setup
Equipment used for measurements:
1. Agilent 83752A Synthesized Sweeper
2. Agilent 70004A Display
3. Agilent 70843B Error Performance Analyzer
4. Agilent 86100A Wide-Bandwidth
Oscilloscope
5. Two (2) MCL BW S15W2 40dB Attenuators
6. Agilent E3620A DC Power Supply
7. Tektronix DMM157 Multimeter
8. Matched High-Speed Cables w/SMA
Connectors
Note:
Items 1 through 3 constitute the BERT stack
Figure 1. Setup for Measurement

Produkt Specifikationer

Mærke: Microchip
Kategori: Ikke kategoriseret
Model: SY88933AL

Har du brug for hjælp?

Hvis du har brug for hjælp til Microchip SY88933AL stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Microchip Manualer

Microchip

Microchip HS12-100D0/12DS2F Manual

18 Februar 2025
Microchip

Microchip HSA0-040SDA/A0SA10 Manual

18 Februar 2025
Microchip

Microchip HSA0-040SIA/A0S1F Manual

18 Februar 2025
Microchip

Microchip HT12-100S0s/12ST25 Manual

17 Februar 2025
Microchip

Microchip EMC2103-2 Manual

17 Februar 2025
Microchip

Microchip EMC1047 Manual

17 Februar 2025
Microchip

Microchip HCS201 Manual

17 Februar 2025
Microchip

Microchip LE9653 Manual

17 Februar 2025
Microchip

Microchip LAN7430 Manual

17 Februar 2025
Microchip

Microchip HCS500 Manual

17 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

XO

XO D1HPBF Manual

16 Juni 2025
Fantech

Fantech RS1 Manual

16 Juni 2025
Playtive

Playtive IAN 425414 Manual

16 Juni 2025
Playtive

Playtive IAN 321249 Manual

16 Juni 2025
Playtive

Playtive IAN 115930 Manual

16 Juni 2025
Aiphone

Aiphone GT-102HB Manual

16 Juni 2025
Playtive

Playtive HG05516 Manual

16 Juni 2025
Playtive

Playtive IAN 295154 Manual

16 Juni 2025
Playtive

Playtive IAN 324362 Manual

16 Juni 2025
Playtive

Playtive IAN 302521 Manual

16 Juni 2025