Mobotix Move VT1A-203-IR Manual

Mobotix sikkerhedskamera Move VT1A-203-IR

Læs gratis den danske manual til Mobotix Move VT1A-203-IR (10 sider) i kategorien sikkerhedskamera. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Mobotix Move VT1A-203-IR, eller vil du spørge andre brugere om produktet?

Side 1/10
NOTE!
This guide is only valid for the 2MP Varifocal IR Vandal Turret. For installing and connecting
more information on the camera, please refer to the other documents (see ). Further Reading, p. 9
Important Installation Notes
n
This camera must be installed by qualified personnel and the installation should conform to
all local codes.
n
n
Do not use this product in a dusty environment.
n
Protect this product from moisture or water entering the housing.
n
Install this product as outlined in this document. A faulty installation can damage the
product!
n
Do not replace batteries of the camera. If a battery is replaced by an incorrect type, the bat-
tery can explode.
n
This equipment is not suitable for use in locations where children are likely to be present.
n
External power supplies must comply with the Limited Power Source (LPS) requirements and
share the same power specifications with the camera.
n
When using a ClassI adapter, the power cord shall be connected to a socket-outlet with
proper ground connection.
n
To comply with the requirements of EN 50130-4 regarding the power supply of alarm systems
for 24/7 operation, it is highly recommended to use an uninterruptible power supply (UPS) for
backing up the power supply of this product.
V1.07_1/29/2024, Order Code: Mx-VT1A-203-IR
Quick Installation
MOBOTIX MOVE 2MP Varifocal IR Vandal Turret
Mx-VT1A-203-IR
©2024 MOBOTIX AG
Quick Installation 2MP Varifocal IR Vandal Turret
NOTE! To ensure that the unit is not affected by vibration, twisting, etc. after adjusting the camera,
properly tighten all mounting screws.
Package Contents
Check the package for the items listed below.
2MP Varifocal IR Vandal Turret
3 x Plastic anchors
3 x self tapping screws
1 x Cable entry cover
1 x Water proof cover
1 x Security Torx Wrench (T 1 0) * 1
1 x Drilling template
Disassembling the Camera
1.
Loosen the screw on the top cover using the T10 Torx wrench.
2.
Remove the top cover .
3.
Carefully remove the camera lens module from the bottom camera case .
2 / 10


Produkt Specifikationer

Mærke: Mobotix
Kategori: sikkerhedskamera
Model: Move VT1A-203-IR

Har du brug for hjælp?

Hvis du har brug for hjælp til Mobotix Move VT1A-203-IR stil et spørgsmål nedenfor, og andre brugere vil svare dig




sikkerhedskamera Mobotix Manualer

sikkerhedskamera Manualer

Nyeste sikkerhedskamera Manualer