Mount-It! MI-397 Manual

Mount-It! Flad panel støtte MI-397

Læs gratis den danske manual til Mount-It! MI-397 (2 sider) i kategorien Flad panel støtte. Denne vejledning er vurderet som hjælpsom af 44 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 22.5 anmeldelser. Har du et spørgsmål om Mount-It! MI-397, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

please contact us

(Mount-It!) for assistance.

(Mount-It!) for a replacement.

please contact us

SKU: MI-397

TV Wall Mount with Extra Long Extension

The angle of the screen can be adjusted down up to 10 degrees and up 5 degrees. To adjust the tilt angle

of the TV, loosen the tilt adjustment nuts shown here then adjust the tilt to the desired angle then tighten the

nuts back down.

Note: If the screen tilts down slowly over time adjust the screen back to the proper angle and ensure the tilt

adjustment nuts are firmly tightened.

The mount allows up to 3 degrees of levelling adjustment post installation. To adjust the level of the TV

loosen the 2 nuts located behind the rectangular VESA plate, level the TV then tighten the 2 nuts again to

secure the TV in position.

Tilt Adjustment

4Levelling Adjustment

We recommend using professional installation services if you are unable to follow the instructions provided in this manual.

(855)- 925-5668

Please scan this QR code

to visit the product page.

+5°

-10°

S-5

-3° +3°

S-5

ø 6mm

(ø 1/4")

90mm

(3.5")

Wood Stud Installation Option

Attach the TV to the VESA Arms (No Spacers)

Attach the TV to the VESA Arms (With Spacers)

MI-397 80

WARNING: This installation manual is intended to provide guidance on how to install the TV mount and the TV on a suitable wall.

Please contact a qualified professional if you are unsure of the steps described in the manual or have doubts about the safety of the

installation. Improper installation may cause damage or serious injury. We cannot be held liable for damage or injury caused by

improper mounting. Incorrect assembly, inappropriate use or for use cases not explicitly specified in this document. If unsure, please

Mount and Accessories

TV Mounting Hardware

Wall Mounting Hardware

CHOKING HAZARD. Package includes small parts. Not for children under 3 years. Adult supervision is required

Check carefully to make sure there are no missing or defective parts. Some hardware provided may not be used.

Use the correct monitor mounting hardware suitable for your installation.

1. Use a stud finder to locate the wall studs and mark their location with a pencil.

2. Hold, tape or secure the Wall Template (#L) to the wall at the desired installation location. Use a bubble

level to ensure the straightness of the Wall Template (#L) and on the center of the studs mark the locations

for the 4 Lag Screws as shown. Once marked, remove the Wall Template.

3. Use a 1/4” drill bit and drill on the marked locations to a depth of 3.5”.

4. Hold the Mount (#M) to the wall over the holes and secure to the wall using all 4 Lag Screws (#A) and

Lag Washers (#B).

Select the appropriate size Mounting Bolt (Select one size #D, #E) and Square Washer (#C) for your

display’s mounting holes and verify the length of the VESA bolt is not too long. If you are unsure of the

correct bolt size for your display refer to your TV user manual or contact the TV manufacturer for sizing

information. Attach the 2 VESA Arms (#N) to the back of your TV using the selected bolts and washer.

If necessary, use the included spacers (#I, J) between the mount and the screen as shown above to adjust

the length of the mounting bolt. Multiple spacers can be used in combination to achieve the desired bolt

depth.

Select the appropriate size Mounting Bolt (Select one size #F, #G,#H) and Square Washer (#C) for your

display’s mounting holes and verify the length of the VESA bolt is not too long. If you are unsure of the

correct bolt size for your display refer to your TV user manual or contact the TV manufacturer for sizing

information. Attach the 2 VESA Arms (#N) to the back of your TV using the selected bolts, washer and

spacers.

Hang the TV on the mount arms as shown in the diagram. Caution: Use the help of a second person for

safe lifting and easier installation.

Attach the Safety Clips (#S-1 and #S-2) to the bottom of the VESA arms as shown here, and secure them

in place using Safety Bolts (#S-3).

1.Hold, tape or secure the Wall Template (#L) to the wall at the desired installation location. Use a bubble

level to ensure the straightness of the Wall Template and mark the locations for the 5 Lag Screws as

shown, then remove the template.

2.Use a 2/5” drill bit and drill on the marked locations to a depth of 3.7”. Note: Do not drill mounting holes

into mortar (such as between bricks or stones) only drill and install into solid stone or concrete surfaces.

3.Clear any dust and debris from the holes and insert the 5 Concrete Anchors (#K). Hold the Mount (#M) to

the wall over the holes and secure to the wall using all 5 Lag Screws (#A) and Lag Washers (#B).

Hang the TV on the Mount Arms

55kg

(121lbs)

Wall Mount

M (x1)

VESA Arms

N (x2)

Wall Template

L (x1)

Hex Wrench

S-4 (x1)

S-1 (x1)

Security Clips

S-2 (x1)

Security Bolt

S -3 (x2)

Wrench

S-5 (x1)

Square Washer

C (x4)

15mm Spacer

I (x4)

5mm Spacer

J (x4)

Concrete Anchor

K (5)

M4 14x (x4)

M6 14x (x4)

M6 30x (x4)

M8x20 (x4 )

M8 45x (x4)

Lag Screw

A(x5)

Lag Washer

B (x5)

132

X X

√

16/24 inches

Level the wall plate

6mm(1/4”)

B A

90mm (3.5”)

Concrete/Stone Installation Option

1b 95mm

(3.7")

ø 10 mm

(ø 2 /5")

X X

√

D/E

F/H

S-1/S-2

S-3

Produkt Specifikationer

Mærke:	Mount-It!
Kategori:	Flad panel støtte
Model:	MI-397

Har du brug for hjælp?

Hvis du har brug for hjælp til Mount-It! MI-397 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Flad panel støtte Mount-It! Manualer

Mount-It! MI-7919 Manual

2 April 2025

Mount-It! MI-384 Manual

2 April 2025

Mount-It! MI-766 Manual

2 April 2025

Mount-It! MI-14009 Manual

4 September 2024

Mount-It! MI-394 Manual

4 September 2024

Mount-It! MI-14010 Manual

4 September 2024

Mount-It! MI-2752 Manual

4 September 2024

Mount-It! MI-20810 Manual

4 September 2024

Mount-It! MI-2753 Manual

4 September 2024

Mount-It! MI-2758 Manual

4 September 2024

Flad panel støtte Manualer

Nyeste Flad panel støtte Manualer

Chief MWCU Manual

3 April 2025

Chief KITXWXSM1U Manual

3 April 2025

Chief RLXT3 Manual

3 April 2025

Anywhere Cart AC-GO-16 Manual

2 April 2025

Proaim P-DMC Manual

2 April 2025

Proaim CT-VNGD-CS Manual

2 April 2025

Proaim CT-VNGD-UC5 Manual

2 April 2025

Premier Mounts 7170-0977 Manual

2 April 2025

Erard FLAK 800+ Manual

2 April 2025

Chief LPE1U Manual

2 April 2025