MRP Ribbon Coil Manual

MRP Ikke kategoriseret Ribbon Coil

Læs gratis den danske manual til MRP Ribbon Coil (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 2 anmeldelser. Har du et spørgsmål om MRP Ribbon Coil, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/6
MAINTENANCE DESCRIPTION
FREQUENCY
(in hours)
REPLACE BATH OIL
NORMAL CONDITIONS:
50
MUDDY CONDITIONS: 30
REPLACE WIPER SEALS
NORMAL CONDITIONS:
100
CHANGE DAMPER OIL 200
CHECK FASTENERS 30
INSPECT STANCHIONS EVERY RIDE
CLEAN DIRT AND MUD FROM STANCHIONS EVERY RIDE
CHECK ADJUSTMENT CONTROLS EVERY RIDE
TORQUE VALUES
FASTENER TORQUE
COMPRESSION BOLT (DAMPER SIDE) 70-75 LB-IN 8 NM
COMPRESSION BOLT (AIR SPRING SIDE) 70-75 LB-IN 8 NM
REGISTER YOUR FORK ONLINE AT MRPBIKE.COM
A link to registration can be found under the “SUPPORT” heading.
While there check out our “TECH RESOURCES” section for more
information on the tuning, maintenance, and the technology found
in your MRP fork.
MRP IS A DIVISION OF:
MOUNTAIN RACING PRODUCTS
580 N WESTGATE DR.
GRAND JUNCTION, CO 81505
970.241.3518
GET THE LATEST INFO ON MRP PRODUCTS
Follow us on:
Facebook.com/MRPbike
Instagram.com/MRPbike
MAINTENANCE SCHEDULE
OWNER’S
MANUAL
IMPORTANT CONSUMER SAFETY INFORMATION
WARNING: RIDING A BIKE IS DANGEROUS. NOT PROPERLY
MAINTAINING OR INSPECTING YOUR BIKE AND ITS
COMPONENTS IS EVEN MORE DANGEROUS. IT IS ALSO
DANGEROUS TO NOT READ AND FOLLOW THESE
INSTRUCTIONS.
Thank you for choosing MRP. This owner’s manual is your
FORK INSTALLATION
1. Remove your old fork from the bicycle. Measure the diameter and
length of your old fork’s steerer tube to ensure that your new steerer
tube is the correct diameter and sucient length for the installation.
If your MRP fork has a tapered steerer tube, be sure to leave enough
room above the taper to allow for proper stem installation.
2. Remove the crown race from your old fork.
3. Press the crown race onto your new fork. (See Figure #1)
4. Preassemble the fork on the bike with the headset, stem, and
spacers (optional). Refer to your stem manufacturer’s instructions to
determine how much room is needed to clamp the stem.
5. Mark the steerer tube at the top of the stem. The steerer tube will
now need to be cut to the correct length. Disassemble and cut 3mm
MAINTENANCE LOG
DATE PROCEDURE

Produkt Specifikationer

Mærke: MRP
Kategori: Ikke kategoriseret
Model: Ribbon Coil

Har du brug for hjælp?

Hvis du har brug for hjælp til MRP Ribbon Coil stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret MRP Manualer

MRP

MRP Ribbon Coil Manual

4 Juli 2025
MRP

MRP Ribbon Manual

3 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Schneider

Schneider LUCD1XES Manual

4 Juli 2025
Ikea

Ikea BLÄDDRARE 304.743.99 Manual

4 Juli 2025
NUX

NUX Komp Core Deluxe MKII Manual

4 Juli 2025
Ikea

Ikea GRÖNAMARANT 204.604.25 Manual

4 Juli 2025
Rowenta

Rowenta Focus DW5121 Manual

4 Juli 2025
Racktime

Racktime Baskit Breeze 2.0 Manual

4 Juli 2025
Schneider

Schneider KSB32CP15D Manual

4 Juli 2025
Wiesenfield

Wiesenfield WIE-IN-100 Manual

4 Juli 2025
Ergotec

Ergotec PM-705N Manual

4 Juli 2025
Sol Expert

Sol Expert 19590 Manual

4 Juli 2025