Muse M-1010 Manual

Muse Bilradio M-1010

Læs gratis den danske manual til Muse M-1010 (2 sider) i kategorien Bilradio. Denne vejledning er vurderet som hjælpsom af 56 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 28.5 anmeldelser. Har du et spørgsmål om Muse M-1010, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Remove the Front Panel

Press button in the upper left corner, and then the front panel will be folded down.

AF button

(release button)

PWR button

7/MOD button

disc slot

SEL/VOL knob

9/ button

8/ button

LCD display

(eject button)

USB Port

AUX IN jack

6/DIR+ button

5/DIR- button

4/RDM button

3/RPT button

2/INT button

1/PAU button

BAND/LOUD button

0/DSP button

EQ button

TA button

PTY button

SCH/AMS button

RESET button

SD/SDHC/MMC slot

Do not attempt to modify the unit, modifying the unit may cause an accident.

Installation or servicing of the unit by persons without training and experience in

electronic equipment and automotive accessories may be dangerous and could

expose you to the risk of electric shock or other hazards.

Stop the vehicle before carrying out any operation that could interfere with your

driving.

Keep the volume at a level which you could hear sounds from outside the vehicle.

Do not work in extremely high or low temperature. Be sure the temperature inside

the vehicle is between +60°C and -10°C before turning on your unit.

When replacing the fuse(s), the replacement must be of the same amperage as

shown on the fuse holder.

Do not block vents or radiator panels. Blocking them will cause heat to build up

inside and may result in re.

Using this unit without running the engine can result in battery drainage.

Use only in cars with a 12 volt negative ground.

After completing the installation and beginning to play the unit(including replacing

the battery), please remove the front panel at rst, and then press RESET button

on the base with pointed object (such as ball-point pen) to set the unit to initial sta-

tus.

Before you install the unit, remove absolutely the two transportation screws on top

of the unit.

10.

11.

12.

13.

14.

15.

16.

17.

18.

19.

20.

21.

22.

23.

24.

25.

26.

10.

11.

M-1010 MR

GB - 1

User Manual

CAR RADIO CD/MP3

PLAYER WITH USB & SD

Please read the instruction carefully

before operating the unit.

PRECAUTIONS

English

* Do not attempt to load more than one disc.

* Only 12cm discs are compatible.

* New discs may have some roughness around the edges. Before load such disc into

the player, use a ball-point pen or the like to remove any roughness from the edge of

the disc.

* If there is a scratch, dirt or ngerprints on the disc, it may cause tracking error. Before

playing, clean the disc with a clean cloth. Wipe the disc from the center out.

* Don’t store discs in places with high temperatures or high humidity, they can become

warped. After playing, store the disc in its case.

GB - 2 GB - 3

CONNECTION

1. Antenna socket

2. Line out Right (red)

3. Line out Left (white)

4. Output plug (male)

5. Output plug (female)

6. FUSE holder (15 A)

Caution!

- Make sure to connect the color coded leads according to the diagram. Incorrect con-

nections may cause the unit to malfunction or damage the vehicle’s electrical system.

- Make sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect

the left and right channel speaker cables each other or to the vehicle body.

- Make sure all the connections are completely correct before turning on your unit.

Do not connect the ignition wire (red) and the battery wire (yellow), it may cause a short circuit,

even result in re.

1. Remove the outer trim frame.

2. Select a position where the screw holes of the mounting bracket supplied with the

car and the screw holes of the main unit become aligned (are tted).

3. Tighten the screws. And then fasten them to the car.

GB - 4 GB - 5

Install the front panel

Insert the panel into the housing and make sure the panel is properly installed.

Otherwise, abnormality occurs on the display or some keys will not function properly.

Note: Never put any objects into the front panel.

Remove the unit

1. Detach the front panel. (please refer to upper part)

2. Take out the outer trim frame.

3. Insert the keys supplied to the unit at the both sides of the unit (shown as illustrated)

until they click. Pulling the keys and makes them to remove the unit from the dash-

board.

GB - 6

LOCATION OF CONTROLS

GB - 7

Notice on disc

Use such discs may cause malfunction or breakdown of the internal mechanism:

with large scratches; with irregular shape; cracked; with any cellophane tape or other

glue on it or with peeling off marks; with protection sheet; equipped with stabilizers, etc.

- Method 2 DIN Rear-mount (For Japanese car)

BASIC OPERATION

Turning on/off the unit

Press button to turn on the unit. Press this button again to turn off the unit.PWR

Note: When the unit is off, press any key except to turn on the unit.

Selecting the mode

After the unit is on, press 7/MOD button to select different sourcing mode: Radio

CD USB SD/MMC AUX

UNPACK YOUR UNIT

When you unpack your new car radio, make sure that you have removed all the acces-

sories and information papers:

Main unit

User manual

Accessories:

Install the unit

- Method 1: DIN Front-Mount

INSTALL AND REMOVE THE UNIT

SOUND FEATURES

Setting the Sound:

Repeatedly press SEL/VOL knob to select the desired mode in the following order :

“BAS” (Bass) -> “TRE” (Treble) -> “BAL” (Balance) -> “FAD“ (Fader) ->“BEEP“ (BEEP

ON/OFF) -> “TA VOL“ (TA volume) ->”LOC” (local) ->”STEREO” -> “EON” (EON ON/

OFF) -> “VOL” (Volume). After selecting the desired mode, you can adjust the current

level by rotating the knob.SEL/ VOL

- In Beep mode, rotate -BEEP: SEL/VOL to select “BEEP ON” or “BEEP OFF”, for cor

responding BEEP status.

- EON: please refer to RDS operation.

Note: The unit will return to the previous mode after 5 seconds without key press.

Reset the unit

Operating the unit for the rst time or after replacing the car battery, you must reset

the unit. To set the unit to initial status, press RESET button located on the base with

a pointed object. When some errors occur in display, you can also reset the unit, but it

will erase the clock setting and some memorized functions.

Volume adjusting:

To increase or decrease the sound level, rotate SEL/VOL knob clockwise or anti-

clockwise.

2625

Preset equalizer

When you are listening to pop music, classic music or rock music, use the equalizer to

adjust the sound quality. Repeatedly press EQ button to select different equalizer mode

in following order: FLAT->POP->ROCK->CLASS -> EQ off.

Switching Loudness On/off

Press and hold button until “LOUD ON” shows on display to activate BAND/LOUD

LOUDNESS function. By this function, you can increase the low frequency, which can

improve sound sensitivity. Press and hold this button again until “LOUD OFF” to cancel

LOUDNESS function.

NOTE: It will return to normal play mode if no key is pressed within 5 seconds.

Information display

- In case a RDS station is received.

In radio mode: CT -> FREQ ->PTY ->PS

In CD (MP3 / WMA) mode: CD (MP3/WMA) -> CT -> FREQ -> PTY ->PS

- In case received station is not RDS.

In radio mode: CT -> FREQ -> NO PTY -> NO PS

In CD mode: CD -> CT -> FREQ -> NO PTY -> NO PS

Time display

Press button to show the current time on display.0/DSP

Adjust time: Long press 0/DSP until clock time with ashing hour digits appears.

Then Press and button to adjust the hour value and press to conrm.0/DSP

Then minute digits ash. Press and button to adjust the minute value and

press 0/DSP to conrm.

LINE OUT

PartA

Part

(GREEN/BLACK)

(VIOLET/BLACK)

(WHITE/BLACK)

+ +

(VIOLET)

(GRAY)

(WHITE)

(GRAY/BLACK)

(GREEN)

642 8

531 7

642 8

531 7

4-SPEAKERSYSTEM

RearLeft

Speaker

FrontLeft

Speaker

FrontRight

Speaker

RearRight

Speaker

GroundWire (Black)

+12V Accessory/Switch (Red)

Power Antenna/Amplifier Turn on (Blue)

+12V Constant Power Supply (Yellow)

FUSE holder (15 A)

1 2 3 5 6

8 9 11

M5 X 21

AR-3108 IB MUSE 001 REV0 GB.indd1 1 2011-8-23 10:09:35

Produkt Specifikationer

Mærke:	Muse
Kategori:	Bilradio
Model:	M-1010

Har du brug for hjælp?

Hvis du har brug for hjælp til Muse M-1010 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Bilradio Muse Manualer

Muse M-205 BT Manual

4 December 2024

Muse M-715 DR Manual

3 Oktober 2024

Muse M-1010 Manual

7 September 2024

Muse M-198 DAB Manual

6 September 2024

3 September 2024

24 August 2024

31 Juli 2024

29 Juli 2024

28 Juli 2024

26 Juli 2024

Bilradio Manualer

Nyeste Bilradio Manualer

Boss MCBK634B Manual

4 December 2025

Auna MVD-480 Manual

30 November 2025

Snooper SMH-550DAB Manual

11 November 2025

Kenwood eXcelon DAX8000S Manual

8 November 2025

Kenwood eXcelon DAX800XR Manual

8 November 2025

Kenwood eXcelon DMX1058XR Manual

7 November 2025

RetroSound Liberty M2 Manual

30 Oktober 2025

RetroSound Liberty M1 Manual

30 Oktober 2025

Sony DSX-GS80 Manual

28 Oktober 2025

Audison VRX 2 150 Manual

19 Oktober 2025