Nemco 56600-3 Manual

Nemco Skæremaskine 56600-3

Læs gratis den danske manual til Nemco 56600-3 (2 sider) i kategorien Skæremaskine. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Nemco 56600-3, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Cartridge Tomato Slicer

56600-1 3/16” Slice

56600-2 1/4” Slice

56600-3 3/8” Slice

Operating and Maintenance Instructions

Important

1. To get the best operation and life from your machine, please read and comply with these instructions.

2. Clean machine thoroughly before and after each use following the cleaning instructions below.

3. Minimize the use of alkaline cleaners as they may cause pitting and dulling of the finish.

Safety instructions

Remember that the blades are VERY SHARP! Be careful when handling and operating the machine to keep hands

away from the blades.

Preparation

1. Set unit on a flat surface.

2. If unit fails to work properly when first operated call NEMCO customer service at 1-800-782-6761.

Operation

1. Your Cartridge Tomato Slicer comes assembled and ready to use. You may want to install the TABLE STOP for your

convenience.

2. Pull HANDLE all the way toward you and carefully place the tomato on the SLIDE BOARD between the PUSHER

PLATES and the BLADES. CAUTION: SHARP BLADES

3. Withdraw your hand. With one quick motion, push the HANDLE toward the BLADES and catch the tomato in your

hand or container.

4. Remove the sliced tomato from the SLIDE BOARD and repeat the procedure for the next tomato to be sliced.

Cleaning

NOTE: Proper maintenance plays an important part in the life span and functioning of the unit.

Clean machine thoroughly after each use.

1. Be careful of the sharp blades.

2. Remove the CARTRIDGE BLADE ASSEMBLY by loosening the CLAMPING KNOBS and lifting the BRIDGE off the

BLADE ASSEMBLY. The BLADE ASSEMBY can now be lifted up and off the GUIDE RODS. (NOTE: When replacing the

BLADE ASSEMBLY, it will only fit on the machine properly one way. Be sure that the notch in the BLADE

ASSEMBLY is aligned with the protrusion in the FRAME.)

3. To remove the PUSHER ASSEMBLY for cleaning, remove the THUMB SCREWS and the SLIDE STOP and pull the

PUSHER off the end of the SLIDE BOARD.

4. Wash with a brush using soap or mild detergent and water.

5. Immediately after cleaning, a sanitizer may be used. Be sure to read and follow sanitizer manufacturer instructions.

Sanitizer must be food safe and for use with Aluminum, Stainless and HDPE plastics

6. To re-assemble, reverse the procedure.

NOTICE: Always rinse the TOMATO SLICER in cold or lukewarm water after it has been washed in hot water!

(Hot water will make the SLIDE BOARD expand and may make it hard to push the PUSHER ASSEMBLY until the

SLIDE BOARD returns to room temperature.)

IMPORTANT: NEMCO recommends occasional application of mineral oil in the grooves of the slide board.

DO NOT USE ANY TYPE OF COOKING OIL – The GUIDE PLATE will cease up on the SLIDE BOARD.

NEMCO FOOD EQUIPMENT

301 Meuse Argonne, Hicksville, OH 43526

Phone: (419) 542-7751

Fax :(

419) 542-6690 T

oll Free:

1-800-782-6761

47786

www.nemcofoodequip.com 03/13/2012

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Skæremaskine
Model:	56600-3

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 56600-3 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Skæremaskine Nemco Manualer

14 Juni 2025

14 Juni 2025

14 Juni 2025

14 Juni 2025

14 Juni 2025

14 Juni 2025

Nemco 56450A-1 Manual

14 Juni 2025

Nemco 55250A Manual

13 Juni 2025

Nemco 57500-1 Manual

13 Juni 2025

Nemco 55150C Manual

13 Juni 2025

Skæremaskine Manualer

Nyeste Skæremaskine Manualer

GARDE 181CHEESBLK Manual

14 Juni 2025

GARDE 181FC38WM Manual

14 Juni 2025

GARDE 181FC14 Manual

14 Juni 2025

Vollrath 47714 Manual

14 Juni 2025

GARDE 181FC38 Manual

14 Juni 2025

Choice 407ONSLIC316 Manual

14 Juni 2025

Vollrath 403NH Manual

14 Juni 2025

Vollrath 700-1 Manual

14 Juni 2025

GARDE 181FC14WM Manual

14 Juni 2025

Globe SG13 Manual

14 Juni 2025