Nemco 6302-4 Manual

Nemco Madvarmer 6302-4

Læs gratis den danske manual til Nemco 6302-4 (2 sider) i kategorien Madvarmer. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Nemco 6302-4, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Operating and Maintenance Instructions

Model Series: 6 -( ) Heated Shelves 302

INTRODUCTION

1. Please read all instructions thoroughly before using this appliance.

2. When using electrical appliances, basic precautions should always be followed to reduce the risk of re, electric shock and

injury.

3. Clean machine thoroughly before and after all uses following the cleaning instructions below.

ELECTRICAL REQUIREMENTS

Plug warmer into a grounded outlet with correct voltage and sucient power capacity. Refer to the product label (serial plate) on

the warmer for voltage and wattage requirements.

SAFETY INSTRUCTIONS

1. All power must be disconnected at power source before any service procedure is performed. Warning!

2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials away

from the appliance.

3. Extreme caution is necessary when any appliance is used by or near children and whenever the appliance is left unattended.

4. Always unplug appliance when not in use and before cleaning, adjusting or maintaining this machine. To disconnect appliance,

turn controls o and remove plug from power source.

5. Do not operate any appliance with a damaged or altered cord or plug, after the appliance malfunctions, has been dropped, or

damaged. Return appliance to an authorized service facility for examination, electrical or mechanical adjustment, or repair.

6. Do not use outdoors. This appliance is not intended for use in wet or moist locations. Never locate appliance where it may fall

into water.

7. Connect to properly grounded outlets only. Avoid the use of extension cords Do not run cord under carpeting, runners, or the .

like. Arrange cord away from trac area and where it will not create a trip hazard.

8. To reduce the risk of re, it is recommended that the unit is placed on a non-combustible surface.

9. is appliance has electrical parts. Do not use it in areas where gasoline, paint, or ammable liquids are used or stored. Th

PREPARATION

1. Remove heat shelf from packaging.

2. Install the heat shelf on a at, stable, non-combustible surface near a power source .

OPERATION

1. This product is intended to hold hot, packaged food items for up to 30 minutes.

2. Plug CORD into a grounded electrical outlet of the correct voltage. Electrical shock can occur if appliance is not grounded

properly.

3. Preheat the heat shelf. Turn the unit on, and move control knob to setting 10. The heat shelf will preheat in 30 minutes.

4. Do not put food product directly onto the heat shelf. Food must always be placed on the shelf using an appropriate

container or tray.

5. For the function of hot food holding, set the heat control knob to the desired setting. Monitor food temperatures closely for

food safety. It is the responsibility of the operator to make sure that food is maintained at a safe temperature for serving.

6. Turn heat shelf o when not in use. To disconnect appliance, turn controls o and remove plug from power source.

CLEANING

NOTE: Proper maintenance plays an important part in the life span and functioning of the heat shelf. To maintain appearance and

increase the service life, the warmer should be cleaned at least daily.

1. Unplug the power cord and let warmer cool before cleaning or moving.

2. Wipe the stainless steel top surface interior clean, damp cloth or stainless steel cleaner.

3. Do not clean with a water jet. Do not immerse in water or other liquid.

4. If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water, immediately after cleansing.

Chemical residue could damage warmer.

TROUBLESHOOTING

Won’t Heat

Check that unit is plugged in

Check that thermostat is turned to desired heat setting

Product Cold/Not to

Temperature

Adjust thermostat to increase temperature.

Product too Hot

Adjust thermostat to decrease temperature.

Unit Blows Fuse or Circuit

Breaker

Check to make sure circuit is not overloaded. Unplug from power and check for

short circuits

NEMCO FOOD EQUIPMENT 301 Meuse Argonne, Hicksville, OH 43526

Phone: (419) 542-7751 Fax: (419) 542-6690 Toll free: 1-800-782- 6761

www.nemcofoodequip.com

8-2022

SERVICE INSTRUCTIONS

Repair: To avoid serious injury or damage, do not repair the heat shelf or replace a damaged power cord yourself.

Repairs must be coordinated through NEMCO Food Equipment customer service at 1-(800) 782-6761.

Schematic shown is for the 5 Shelf

Warmer. Wiring for all other models is the

same less a series of components based

on the number of shelves.

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Madvarmer
Model:	6302-4

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 6302-4 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Madvarmer Nemco Manualer

Nemco 6301 Manual

14 Juni 2025

Nemco 6460 Manual

14 Juni 2025

Nemco 6454 Manual

14 Juni 2025

Nemco 6480-30S Manual

13 Juni 2025

13 Juni 2025

13 Juni 2025

13 Juni 2025

13 Juni 2025

13 Juni 2025

13 Juni 2025

Madvarmer Manualer

Nyeste Madvarmer Manualer

ServIt 423FDSPSH Manual

14 Juni 2025

Alto-Shaam HN2-72 Manual

14 Juni 2025

Alto-Shaam EC2SYS-96 Manual

14 Juni 2025

ServIt 423HSW20403 Manual

14 Juni 2025

Vollrath 40732 Manual

14 Juni 2025

ServIt 423HSW20404 Manual

14 Juni 2025

ServIt 423FW150 Manual

14 Juni 2025

Alto-Shaam PD2SYS-72 Manual

14 Juni 2025

Alto-Shaam EC2-96 Manual

14 Juni 2025

Vollrath HFM36 Manual

14 Juni 2025