Construction manual for robot kit Nibo2 22.11.2011
Safety instructions
For construction and operation of the robot please consider the
following safety instructions:
•The robot kit Nibo2 is designed for learning, teaching and experimental
purposes only. The company does not accept any liability for other
uses of the programming adapter. Any other use is at the users own
risk.
•No machines must be attached to the robot. In particular the operation
with devices on mains voltage is forbidden.
•The robot must not be operated without supervision. When not in use
the robot is to be separated from the power supply.
•The robot must be operated with stabilized DC voltage by 9.6 V. In
particular the robot must be operated with rechargeable batteries
(1,2V) only and never with normal batteries (1,5V).
•We take no responsibility for data loss of an attached computer.
•The robot must be used indoors only. In particular the usage of the
robot is expressly forbidden on public roadways!
•For a usage deviating from these guidelines no warranty and no
accountability are assumed, the operation is at your own risk!
For soldering please consider following points:
•Always work with extreme caution with the soldering iron!
•Inappropriate operation can lead to severe burns or cause fires.
•Never place the hot soldering iron on the table or on other surfaces.
•Never leave the soldering iron switched on unsupervised.
•Please consider the possible emission of poisonous fumes when
soldering. Ensure there is sufficient ventilation and wash your hands
thoroughly after work.
•Keep the soldering iron away from children!
•Please consider the safety instructions of the soldering iron
manufacturer!
•Pay attention to a correct soldering tip temperature: High temperatures
(400°C) may damage the tip, but also allow a short soldering time. Low
temperatures (320°C) will increase the soldering time. This may
damage the electronic components.
http://nibo.nicai-systems.com 2
