NUVO Clarksville 60/8066 Manual

NUVO lampe Clarksville 60/8066

Læs gratis den danske manual til NUVO Clarksville 60/8066 (2 sider) i kategorien lampe. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om NUVO Clarksville 60/8066, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
FOR YOUR SAFETY
WARNING: BE SURE THE ELECTRICITY TO THE WIRES
YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS
REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
GENERAL
You don’t need special tools to install this xture. Be sure to follow
the steps in the order given. Under no circumstances should a
xture be hung on house electrical wires, nor should a swag type
xture be installed on a ceiling which contains a radiant type heating
proceed, consult a qualied electrician.
NOTE: Proper wiring is essential for the safe operation of this xture.
FIXTURE ASSEMBLY
Carefully remove the xture from the carton and check that all parts
are included as shown in gure. Be careful not to misplace any of
the screws or parts, which are needed to install this xture.
STEP 1: Thread tube. Carefully pass the wires through each tube
during assembly. Repeat this step until the desired hanging height
is reached.
STEP 2: Thread the tube into the canopy and body.
INSTALLATION
IMPORTANT: Do not attach xture directly to outlet box.
STEP 1: Thread mounting screw into the matching hole of cross bar.
STEP 2: Secure the cross bar to outlet box with outlet box screws.
GROUNDING INSTRUCTIONS
STEP 1: Insert the green grounding screw into the hole with two
raised dimples on the mounting bar. Wrap the ground wire from the
xture (if supplied) around the green grounding screw, then connect it
to ground wire from the outlet box (if not xed on the outlet box) using
a wire connector (not supplied). If ground wire from the xture is not
supplied, wrap the ground wire (if not xed on the outlet box) from the
outlet box around the green grounding screw and tighten it.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE
POWER SUPPLY WIRES.
STEP 2: Take note of the color of the wire(s) on your xture. Identify
which group your xture wire(s) falls into and connect the wires
according to the directions below:
GROUP A:
Connect to Black House Wire
GROUP B:
Connect to White House Wire
BLACK WHITE
* PARALLEL WIRE (round & smooth) * PARALLEL WIRE (square & ridged)
WHITE OR GREY WITH TRACER WHITE OR GREY WITHOUT TRACER
BROWN, GOLD OR BLACK
WITHOUT TRACER
BROWN, GOLD OR BLACK
WITH TRACER
NOTE: When parallel wire (SPT-I & SPT-2) is used, the tracer wire is
square shaped or ridged and the less tracer wire is round in shape
or smooth (seen best when viewed from wire end.)
STEP 3: Take your xture wire(s) from group A and place evenly
against the black wire from the outlet box. Do NOT twist wires
together before using wire connectors.
STEP 4: Fit a wire connector over the wires and screw the
connector clockwise until you feel rmness.
STEP 5: Try gently to pull the connector off the wires. If you can
pull the connector off, carefully re-do steps 3 and 4 as above, and
check again for a rm connection.
STEP 6: Connect the xture wire from group B to the white wire
from the outlet box in the same manner. Make sure no bare wires
can be seen outside wire connectors.
FINAL ASSEMBLY
STEP 1: After wires are connected, tuck them carefully inside outlet
box. Raise canopy allowing the mounting screw to protrude through
the hole in the canopy, and secure with ball nuts.
STEP 2: Secure glass to the xture with socket ring.
capacity recommended on the socket.
CLEANING
To clean, wipe xture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order
replacement parts. Be sure to use exact wording from illustration
when ordering parts.
Line art shown may not exactly match the xture enclosed. However, the installations
do apply to this xture.
La ilustración puede no concordar exactamente con la pieza enviada. Sin embargo,
las instalaciones sí aplican para esta pieza.
Les images peuvent ne pas correspondre exactement au luminaire de la boîte.
Par contre, les directives d’installation s’appliquent au luminaire.
© Copyright 2024 Satco Products, Inc. 4/24 v1.0
ITEM NO: 60-8066
ARTÍCULO Nº: 60-8066
ARTICLE N°: 60-8066
INSTALLATION AND SAFETY INSTRUCTIONS
FIGURE

Produkt Specifikationer

Mærke: NUVO
Kategori: lampe
Model: Clarksville 60/8066

Har du brug for hjælp?

Hvis du har brug for hjælp til NUVO Clarksville 60/8066 stil et spørgsmål nedenfor, og andre brugere vil svare dig


lampe NUVO Manualer

NUVO

NUVO Arabel 60/6967 Manual

4 April 2025
NUVO

NUVO Gotham 60/191 Manual

4 April 2025
NUVO

NUVO Cordello 60/7884 Manual

4 April 2025
NUVO

NUVO Clarksville 60/8061 Manual

4 April 2025
NUVO

NUVO Gotham 60/190 Manual

4 April 2025
NUVO

NUVO Odeon 60/2855 Manual

1 April 2025
NUVO

NUVO Beacon 60/6827 Manual

1 April 2025
NUVO

NUVO Clarksville 60/8066 Manual

1 April 2025
NUVO

NUVO Harlow 60/4630 Manual

12 September 2024
NUVO

NUVO Laguna 60/5925 Manual

12 September 2024

lampe Manualer

Nyeste lampe Manualer

Integral LED

Integral LED ILSTRGBWB028E Manual

4 April 2025
Trust

Trust Shyne 25483 Manual

3 April 2025
Trust

Trust Vybz GXT 904 Manual

3 April 2025
Schonbek

Schonbek Priscilla BC7106N-48PBZ Manual

2 April 2025
Bresser

Bresser BR-7RGB Mini Tube Manual

2 April 2025
Sonneman

Sonneman Ray 2036 Manual

2 April 2025
Maxim

Maxim Charlton 11375BKAB Manual

2 April 2025
Schneider

Schneider OVA48313 Manual

1 April 2025
Schneider

Schneider OVA44112 Manual

1 April 2025
Schneider

Schneider OVA47013 Manual

1 April 2025