One Control OC10 Manual

One Control Ikke kategoriseret OC10

Læs gratis den danske manual til One Control OC10 (9 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 63 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 32 anmeldelser. Har du et spørgsmål om One Control OC10, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/9

KEY

All Red Lines Are Cables

Taking Signal Into OC10

All Green Lines Are Cables

Taking Signal Out Of OC10

OC 10 Crocodile Tail Loop Setup Utilising Tuner Out And One Loop

 The above setup is using the OC10 in it’s most basic form were the guitar signal is run directly into

the rear main input jack.

 The tuner output is selected when the OC10 is in program mode via the top row left hand footswitch

labelled “TUNER/L10”, when selected this mutes all output from unit except signal running from tuner

jack output.

 Loop 1 is being utilised in this example. loops 1 thru 7 are internally connected so signal from main

input will always be running to OUT 1 and OUT 2 whether pedals are connected or not.

 OUT 2 is being utilised in this example to run directly to amp input, OUT 1 and OUT 2 are in parallel

and are both supplied signal from the input jacks through loops 1 to 7, OUT 1 would be utilised if sig-

nal was required to run directly into IN 8 which is the start of the second run of loops (8,9,10)

SETUP 1

KEY

All Red Lines Are Cables

Taking Signal Into OC10

All Green Lines Are Cables

Taking Signal Out Of OC10

All Purple Lines Are Cables

Taking Signal Out of OC10

and Immediately Back Into

OC10

OC10 Setup Utilising Buffer Circuit, 1 Loop

from Loops 1 thru 7 and Loop 8

 The above setup is using the OC10 with the guitar running into the Buffer circuit, Tuner out, loop 1

and loop 8

 Utilising the Buffer circuit will give the signal increased strength and retention of clarity, primarily this

circuit is designed for running longer cable runs and running through multiple effects units which ulti-

mately can lower signal strength and dull the top end of the signal.

 Loop 1 is being utilised in this example. loops 1 thru 7 are internally connected so signal from main

input will always be running to OUT 1 and OUT 2 whether pedals are connected or not.

SETUP 2

PAGE 1

Produkt Specifikationer

Mærke:	One Control
Kategori:	Ikke kategoriseret
Model:	OC10

Har du brug for hjælp?

Hvis du har brug for hjælp til One Control OC10 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret One Control Manualer

One Control OC10 Manual

5 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

10 Oktober 2025

10 Oktober 2025

10 Oktober 2025

10 Oktober 2025

Oras Saga 3970 Manual

10 Oktober 2025

TOA AT-4030B-EB Manual

10 Oktober 2025

TOA VX-030DA Manual

10 Oktober 2025

TOA RS-481 Manual

10 Oktober 2025

TOA AT-4200B-EB Manual

10 Oktober 2025

Xerox DocuShare Manual

10 Oktober 2025