Onkyo HTP-678 Manual


Læs gratis den danske manual til Onkyo HTP-678 (24 sider) i kategorien Højttalersystem. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om Onkyo HTP-678, eller vil du spørge andre brugere om produktet?

Side 1/24
En-1
E
n
5.1.2ch Home Theater Speaker Package
Make sure you have the following accessories.
Front & Height Speakers (SKF-693)
Center Speaker (SKC-591N)
*1 Configuration of the rubber stoppers may be different from the
figure, such as being 2 sheets instead of 1 sheet, but the total
number will be same.
Surround Speakers (SKR-590)
Powered Subwoofer (SKW-658)
Front & Height Speakers (SKF-693)
Center Speaker (SKC-591N)
Surround Speakers (SKR-590)
Supplied Accessories
Front & Height speakers Speaker cables
3.0 m
Center speaker Speaker cable
3.0 m
4 rubber stoppers*1
(White) (Red)
(Brown) (Tan)
(Green)
Subwoofer RCA cable
3.0 m
4 floor pads
(Blue) (Gray)
Part Names
Speaker terminals
(Height)
Keyhole slot
Speaker terminals
(Front)
Rear
Front
Speaker unit
Speaker terminals
Keyhole slots
Speaker terminals
Keyhole slot
HTP-678
* 2 9 4 0 1 8 7 8 *
D1406-0
Speaker cables 8.0 m
Surround speakers
En-2
Caution
The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
Powered Subwoofer (SKW-658)
Front
Rear
Note
The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level. If the Auto Standby function
does not work reliably, try slightly increasing or decreasing the
subwoofer output level on your receiver.
Using the Rubber Stoppers for a More Stable
Platform
We recommend using the supplied rubber stoppers to
achieve the best possible sound from your speakers. The
rubber stoppers prevent the speakers from moving,
providing a more stable platform. Use rubber stoppers for
the center speaker.
Using the Floor Pads for Subwoofer
If the subwoofer is placed on a hard floor (wood, vinyl,
tile, etc.) and playback is very loud, the subwoofer’s feet
may damage the flooring. To prevent this, place the
supplied pads underneath the subwoofer’s feet. The pads
also provide a stable base for the subwoofer.
Setting the Subwoofer Level
To set the level of the subwoofer, use the
OUTPUT LEVEL control. Set it so that bass
sounds are evenly balanced with the treble sounds
from the other speakers. Because our ears are less
sensitive to very low bass sounds, there’s a temptation to
set the level of the subwoofer too high. As a rule of thumb,
set the subwoofer level to what you think is the optimal
level, and then back it off slightly.
Wall Mounting
To mount the front/surround speakers vertically, use the
keyhole slot shown to hang each speaker on a screw that’s
securely screwed into the wall.
To mount the center speaker horizontally, use the two
keyhole slots shown to hang the speaker on two screws that
are securely screwed into the wall.
Tip
If the center speaker is tilted, loosen the screw on the declined
side to move upward so that the speaker could be adjusted
vertically.
Status indicator
Off: Subwoofer in standby mode or
disconnected from power source
Blue:Subwoofer on
The status indicator lights blue when
low frequency sound is being passed
through the speaker.
The indicator does not light in the
normal dialog or high frequency
sound.
Note
The indicator does not indicate that
power supply of the subwoofer has
turned on.
With the Auto Standby function, the
SKW-658 automatically turns on
when an input signal is detected in
standby mode. When there’s no input
signal for a while, the SKW-658
automatically enters standby mode.
To AC outlet
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be
connected to the subwoofer pre
out on your AV receiver with
supplied RCA cable.
Before Using the Home Theater
Speaker Package
Rubber stoppers
Bottom of the
SKC-591N
Side panel
Floor pad
SKF-693 SKR-590
Keyhole slots for
wall mounting
Keyhole slots for wall mounting
200 mm
SKC-591N


Produkt Specifikationer

Mærke: Onkyo
Kategori: Højttalersystem
Model: HTP-678

Har du brug for hjælp?

Hvis du har brug for hjælp til Onkyo HTP-678 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttalersystem Onkyo Manualer

Højttalersystem Manualer

Nyeste Højttalersystem Manualer

Auna

Auna 10000147 Manual

12 Januar 2025
Jamo

Jamo A500 Manual

25 August 2024
Jamo

Jamo C109 Manual

23 August 2024
Jamo

Jamo 8A2 Manual

23 August 2024
Jamo

Jamo IW 1060 SW Manual

23 August 2024
Jamo

Jamo IW 625 Manual

22 August 2024
Jamo

Jamo C10 Manual

21 August 2024
Jamo

Jamo IC606FG Manual

21 August 2024