Ortofon OM 3E Manual

Ortofon DJ Gear OM 3E

Læs gratis den danske manual til Ortofon OM 3E (2 sider) i kategorien DJ Gear. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Ortofon OM 3E, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
08-17/5-800130-12 rev.02
Ortofon A/S
Stavangervej 9
DK-4900 Nakskov
D
www.ortofon.com
enmark
Moving Magnet cartridges
*) Typica
Output voltage at 1000 Hz, 5 cm/sek
Channel balance at 1 kHz
Channel separation at 1 kHz
Channel separation at 15 kHz
Frequency range at -3 dB
Frequency response
Tracking ability at 315 Hz at recommended tracking force*)
Compliance, dynamic, lateral
Stylus type
Stylus tip radius
Tracking force range
Tracking force, recommended
Tracking angle
Internal impedance, DC resistance
Internal inductance
Recommended load resistance
Recommended load capacitance
Cartridge color (body/st ylus)
Cartridge weight
Replacement stylus unit
4.5 mV
2 dB
20 dB
12 dB
20-20,000 Hz
20-22,000 Hz
60 µm
20 µm/mN
Spherical
R 18 µm
1.5-2.0 g (15-20 mN)
1.75 g (17.5 mN)
20°
750 Ohm
450 mH
47 kOhm
200-500 pF
Black/Black
5 g
1S
4 mV
2 dB
22 dB
15 dB
20-25,000 Hz
20-20,000 Hz +/- 2 dB
65 µm
20 µm/mN
Elliptical
r/R 8/18 µm
1.5-2.0 g (15-20.0 mN)
1.75 g (17.5 mN)
20°
750 Ohm
450 mH
47 kOhm
200-600 pF
Black/Black
5 g
5E
4 mV
2 dB
22 dB
15 dB
20-22,000 Hz
20-20,000 Hz +3/- 1 dB
70 µm
25 µm/mN
Elliptical
r/R 8/18 µm
1.25-1.75 g (12.5-17.5 mN)
1.5 g (15 mN)
20°
750 Ohm
450 mH
47 kOhm
200-500 pF
Black/Black
5 g
10
l value
Technical Data OM 1S OM 5E OM 10
Thank you for choosing the Ortofon Moving Magnet
cartridge. At Ortofon we constantly look for new
technology to be used in our products, thus we assure
the highest level of performance and quality. It is our
aim to bring you many hours of new and surprising
experience in listening to your precious collection.
Warning
This phono cartridge is only for mounting on tonearms
and must not be used for other purposes.
Please note
To avoid damages on the stylus please keep the stylus
guard on the cartridge any time when mounting or
dismounting the unit.
Mounting the cartridge
1. Remove stylus unit with stylus guard before working
with leads and screws. Handle all parts carefully.
2. Please correlate the colour code for the terminals on
the drawing with the colour codings on the cartridge.
3. Fasten the cartridge to the headshell using a pair
of screws enclosed the packing. Do not tighten the
screws completely before the stylus unit has been
remounted.
4. Adjust tonearm parallel to record surface, set
tracking force and antiskating acc. to the cartridge’s
recommended technical data.
For more information please refer to Ortofon HiFi FAQ:
www.ortofon.com/support/support-hifi/faq-installation.
Stylus care
To maintain optimal sound reproduction and to
minimize wear on your record as well as on your
stylus, we recommend the following procedure before
and after each playback: remove dust carefully from
record surfaces by using a fine antistatic brush or
cloth before every use. Ortofon do not recommend
the use of solvents of any kind for cleaning of either
record surface or stylus. If necessary, records may be
washed in lukewarm demineralized water with a dash
of sulphonic soap. The detergents should be allergy- &
environmental friendly, without perfume or as little as
possible: a few drops to a few liters of waters, no lather.
The use of solvents on the stylus and cantilever may
damage stylus cement; interior parts of the cartridge
can be affected seriously by the intrusion of solvents.
The Ortofon warranty service will not be valid in cases
where such treatment has caused malfunction of your
cartridge.
For cleaning the stylus, use fiber brush a few times
along the cantilever in the direction of the stylus tip,
whenever you play a new record or change sides. Use
the brush in the forward direction from the rear of the
cartridge towards the stylus tip and never from stylus
tip to the rear of the cartridge and never from side to
side. This will take all normal dust and most of the
slick release agent from new records. Following this
treatment there will normally be no need for further
stylus cleaning.
Please remember to remove dust from the diamond tip
before and after playback of each record.
White L+
Red R+
Green RG
Blue LG

Produkt Specifikationer

Mærke: Ortofon
Kategori: DJ Gear
Model: OM 3E

Har du brug for hjælp?

Hvis du har brug for hjælp til Ortofon OM 3E stil et spørgsmål nedenfor, og andre brugere vil svare dig


DJ Gear Ortofon Manualer

Ortofon

Ortofon OM 5S Manual

3 September 2024
Ortofon

Ortofon OM 3E Manual

13 August 2024
Ortofon

Ortofon Test Record Manual

9 August 2024
Ortofon

Ortofon Concorde MkII Manual

8 August 2024
Ortofon

Ortofon Concorde MKII Elite Manual

6 August 2024
Ortofon

Ortofon 2M Manual

6 August 2024

DJ Gear Manualer

Nyeste DJ Gear Manualer

Fuzzix

Fuzzix MBR60 Manual

14 Marts 2025
UDG Gear

UDG Gear AlphaTheta DDJ-GRV6 Manual

3 Marts 2025
Yamaha

Yamaha UX256 Manual

8 Februar 2025
Eliminator Lighting

Eliminator Lighting Event Facade II Manual

7 Februar 2025
Reloop

Reloop RMX-30 BT Manual

7 Februar 2025
Headliner

Headliner R4 Manual

30 Januar 2025
Arturia

Arturia BeatStep Manual

11 Januar 2025
Line 6

Line 6 Helix Control Manual

11 Januar 2025
Glorious

Glorious Record Box 55 Manual

5 Januar 2025
Glorious

Glorious Record Box Display Door Manual

5 Januar 2025