Paxton Proximity P200 Manual

Paxton Sikkerhed adgangskontrolsystem Proximity P200

Læs gratis den danske manual til Paxton Proximity P200 (3 sider) i kategorien Sikkerhed adgangskontrolsystem. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Paxton Proximity P200, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

Suitability

Fitting

Mounted on metal surface

Security-sensitive doors

Wet environments

Readers mounted together

P200 P200E metal mount

between readers

500 mm

between readers

500 mm

Reader covers

The P200 comes supplied with Black and White covers. The P200E is only available in Black.

Overview

The P200 is a standard P series reader with a much larger coil to give an increased read range with hands free

tokens. This larger coil makes it unsuitable for mounting the reader directly onto metal surfaces, posts, etc as

the radio eld becomes distorted and so the P200E (External) has been designed with the reader coil spaced

away from the backplate.

The read range of both units is similar to the standard P series reader with passive tokens but is greatly

extended (up to 2.5 metres) when used in conjunction with a hands free interface, tokens and keycards.

P200 P200E

Cable extensions

Readers can be extended using Belden CR9540 10-core overall screened cable to a maximum of 100 metres.

15/03/2011

Ins-30026 PROXIMITY P200 & P200E metal mount reader

Technical Support

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

01273 811011 support@paxton.co.uk

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

Paxton

Wiring

Hands free interface

The interface should be positioned as close as practical to the reader. A distance from interface to reader of 10

to 15 meters can be achieved but wireless technology is susceptible to environmental factors and so if problems

are experienced it may be necessary to move the interface closer to the reader.

The hands free interface should not be housed in a metal enclosure as it contains the main receiver aerial.

Sticky feet allow the interface to be stuck to the ACU wiring label in a PSU plastic housing.

WHITE labelled control units provide 5V at the Red terminal. The Red power wire for the

reader should therefore be directly connected to the 12V supply terminal.

The reader port module is designed to convert the

standard reader ports on Switch2 and Net2 controllers

to accept one or two RJ45 connections. Pull off the

screw terminal block from the reader port and simply

replace it with this module.

This module can be used to provide a

connection point for the reader RJ45 plug.

The terminals on the module are then wired

colour for colour to the controller.

Alternatively, the reader can be wired directly

into the screw terminals of the control unit by

rst cutting off the RJ45 plug and stripping

back the wires in the cable.

Reader port module (325-030)

This module may be purchased separately to speed up

the installation and replacement of readers.

Connection modules

Further information on how to purchase Installer Tools is available at:

http://paxton.info/841

Reader junction box (325-020)

Connection to a control

unit reader port

Produkt Specifikationer

Mærke:	Paxton
Kategori:	Sikkerhed adgangskontrolsystem
Model:	Proximity P200
Produktfarve:	Sort
Dimensioner (BxDxH):	200 x 40 x 200 mm
Indikatorlampe:	Ja
Certificering:	IPX7
Trådløs forbindelse:	Ingen