Pioneer RD-HWK100 Manual

Pioneer Dash cam RD-HWK100

Læs gratis den danske manual til Pioneer RD-HWK100 (3 sider) i kategorien Dash cam. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Pioneer RD-HWK100, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

Hard Wire Kit

RD-HWK100

Installation Manual

Thank you for buying this Pioneer product. Please read through

these instructions so you will know how to operate your model

properly. After you have finished reading the instructions, keep

this document in a safe place for future reference.

Be sure to disconnect the terminal of the vehicle’s

battery before connecting the power or AV cable.

Handling precautions

• Be sure to install this product correctly according to this

instruction manual. Installation other than specified may

cause an accident or injury. In this case, Pioneer does not

take any responsibility.

• When installing this product, also read the “Safety

Precautions” for the compatible Dash Camera to which this

product is to be installed.

Precautions before connecting the system

CAUTION

• Secure all wiring with cable clamps or electrical tape. Do

not allow any bare wiring to remain exposed.

• Make sure that the cables and wires will not interfere with

or become caught in any of the vehicle’s moving parts,

especially the steering wheel, gearstick, handbrake, sliding

seat tracks, doors, or any of the vehicle’s controls.

• Do not route wires where they will be exposed to high

temperatures. If the insulation heats up, wires may become

damaged, resulting in a short circuit or malfunction and

permanent damage to the product.

• Do not shorten any cables. If you do, the protection circuit

(fuse holder, fuse resistor or filter, etc.) may fail to work

properly.

• Never feed power to other electronic products by cutting

the insulation of the power supply cable of this product

and tapping into the cable. The current capacity of the

cable will be exceeded, causing overheating.

Important safeguards

WARNING

• Any obstruction of or other interference with the airbag,

either deployed or non-deployed, or with the clear view of

the road must be avoided and, accordingly, professional

installation is required.

• Do not allow this product to come into contact with liquids.

Electrical shock could result. Also, damage to the product,

smoke, and overheating could result from contact with

liquids.

• Do not disassemble or modify this product, as there are

high-voltage components inside which may cause an

electric shock. Be sure to consult your dealer or the nearest

authorised Pioneer Service Station for internal inspection,

adjustments or repairs.

• Do not use this product in locations subjected to high

temperatures of 60°C or higher, low temperatures of –10°C

or lower, or high humidity.

To prevent damage

WARNING

• When replacing the fuse, be sure to only use a fuse of the

rating prescribed on this product.

Precautions before installation (I)

CAUTION

• Never install this product in places where, or in a manner

that:

- Could injure the driver or passengers if the vehicle stops

suddenly.

- May interfere with the driver’s operation of the vehicle,

such as on the floor in front of the driver’s seat, or close to

the steering wheel or gearstick.

• To ensure proper installation, be sure to use the supplied

parts in the manner specified. If any parts are not supplied

with this product, use compatible parts in the manner

specified after you have the parts’ compatibility checked

by your dealer. If parts other than supplied or compatible

ones are used, they may damage internal parts of this

product or they may work loose and the product may

become detached.

English

Precautions before installation (II)

CAUTION

• Do not install this product where it may:

(i) obstruct the driver’s vision,

(ii) impair the performance of any of the vehicle’s operating

systems or safety features, including airbags, hazard lamp

buttons or

(iii) impair the driver’s ability to safely operate the vehicle.

• Consult with your nearest dealer if installation requires

drilling holes or other modifications of the vehicle.

• Before making a final installation of this product,

temporarily connect the wiring to confirm that the

connections are correct and the system works properly.

• Do not install this product in places subject to high

temperatures or humidity, such as:

- Places close to a heater, vent or air conditioner.

- Places that may be exposed to rain, such as close to the

door or on the vehicle’s floor.

Notes

• The security mode can be set to on or off.

→ “This Product Settings” - “Configurable Features” -

“Parking Mode” - “Security mode”

• In the security mode, this product runs in the low power

consumption mode to reduce the risk of the battery

running flat.

• When the battery voltage drops below 11.2 V, security

mode standby and recording are stopped.

• The security mode starts recording within three seconds of

detection of impact.

• Vibration that is detected for approximately three minutes

before the vehicle’s engine is turned on (ACC ON) is not

covered by the notification message display feature.

• The security mode is a feature for starting up and

activating this product after an impact is detected. For this

reason, the battery might wear more quickly if this product

is used in mechanical multi-story parking garages or

location subjected to lots of vibration. When parking in

locations such as these, set the security mode to off before

using this product.

• The parking mode (security mode allowing 24-hour, 365-

day surveillance) can be used by extracting

power directly from the vehicle by the power / AV cable.

You can also connect the product to navigation by the

power / AV cable to project realtime video from this

product or movies and photos that are being played back

on the screen of the navigation.

Disclaimer

• Given the large number of variables and conditions that

can be involved in an accident, Pioneer cannot guarantee

that every accident or occurrence will trigger the recording

feature in this device.

• Pioneer Corporation accepts no responsibility whatsoever

for product failures or damage that occur due to this

product.

24/7 Security Mode

• If the pre-set operation time elapses when the security

mode is turned ON, the security mode in which parking

surveillance is performed 24 hours per day, 365 days per

year is automatically activated. When this device detects

vehicle movement caused by vibration while the security

mode is activated, that event is saved for the set normal

video time after the moment of detection as a parking

mode file, and a notification message is displayed at the

next startup.

Produkt Specifikationer

Mærke:	Pioneer
Kategori:	Dash cam
Model:	RD-HWK100
Produktfarve:	Black, Red, White, Yellow
Kapabilitet:	VREC-DZ600
Mærke kompatibilitet:	Pioneer
Stik 1 køn:	Hanstik
Stik 2 køn:	Hanstik