PY5500 User Manual (020-1103-00 Rev. A) 1
This manual is designed for use with the PY5500 industrial display. Information in this
document has been carefully checked for accuracy; however, no guarantee is given to
the correctness of the contents. The information in this document is subject to change
without notice.
Copyright 2008
Copyright 2008
Copyright 2008
Copyright 2008 Copyright 2008
This document contains proprietary information protected by copyright. All rights are reserved.
No part of this manual may be reproduced by any mechanical, electronic or other means, in
any form, without prior written permission of the manufacturer.
Trademarks
Trademarks
Trademarks
Trademarks Trademarks
All trademarks and registered trademarks are the property of their respective owners.
FCC compliance
FCC compliance
FCC compliance
FCC compliance FCC compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Federal communications commission (FCC) statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
