NightStick Remington SFL-14WL Manual

NightStick Lys Remington SFL-14WL

Læs gratis den danske manual til NightStick Remington SFL-14WL (3 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 2 anmeldelser. Har du et spørgsmål om NightStick Remington SFL-14WL, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-SFL-Series-DL-23
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-SFL-Series-DL-23
Instruction Manual
SFL Series Shotgun Lights
US PATENT 9,713,217
WEAPON SAFETY
FAILURE TO FOLLOW SAFETY AND OPERATING
MEASURES WHEN HANDLING A FIREARM OR THE
NIGHTSTICK WEAPON LIGHT WHEN MOUNTED ON A
FIREARM IS DANGEROUS AND CAN RESULT IN SERIOUS
INJURY, DAMAGE TO PROPERTY, OR DEATH.
y Use of a rearm under any circumstance is inherently
dangerous. SERIOUS INJURY OR EVEN DEATH may
result without proper training in the safe handling of  rearms.
Proper training should be obtained from an accredited
rearms safety program conducted by a quali ed instructor.
y Read, understand and follow all of the safety instructions
that come with your  rearm before attaching your new SFL.
y Always assume every rearm is loaded and treat that
rearm as such.
y Never point a  rearm at anything that you are not willing
to destroy.
y Never service your rearm or your weapon light when
mounted on a rearm without  rst activating the weapon’s
safety (if applicable), removing the magazine, opening the
action and physically and visually inspecting to make sure
that no ammunition is installed in the  rearm.
BEFORE ATTACHING, INSPECTING OR
SERVICING THE LIGHT
WARNING: IT IS IMPERATIVE THAT SAFETY
MEASURES BE EMPLOYED AT ALL TIMES WHILE
HANDLING A FIREARM.
y Engage the safety on the  rearm (if applicable).
PROGRAM THE USER-SELECTABLE
SETTINGS
LASER MODELS
While holding down either the left or right side switch,
press and release the opposite side switch to cycle between
the modes: 1) white light only, 2) green laser only, or 3) white
light and green laser.
y Cycle through each mode by continuing to hold one side
while pressing and releasing the opposite side.
y When the desired mode is selected, release the switches.
y The setting will remain in the selected mode until
changed by the user.
ALL MODELS – BATTERY SAFE MODE
y Press and hold both switches at the same time for 3
seconds to enable or disable battery safe mode.
y After three seconds the light will ash on and off 1 time to
con rm a change in the battery safe mode.
NOTE: The battery safe mode reverts to disabled when
batteries are removed or fully discharged.
ADJUST WINDAGE AND ELEVATION
(LASER MODELS)
y Use the tool included to turn the windage (side) and
elevation (bottom) screws to adjust the laser until it is
aligned with the top of the front sight post.
y At the ring range, re ne the point of aim to match the
point of impact at your desired distance.
GENERAL SAFETY WARNINGS
y NOT FOR USE ABOVE HAZARDOUS LOCATIONS
y DO NOT use in explosive atmospheres, near ammable
liquids, or where explosion proof lamps are required.
y DO NOT use in the proximity of vehicles or equipment
when there is a risk of ammable liquids coming into
contact with the  ashlight.
y DO NOT expose the batteries to water or salt water, or
allow the batteries to get wet.
y DO NOT store the batteries with metallic objects that
may cause a short circuit.
y Immediately discontinue use of the batteries if they emit
an unusual smell, feel hot, change color, change shape or
appear abnormal in any way.
y Keep out of the reach of children.
ATTACHING THE STRAP
To attach the safety strap to the SFL, install the mounting
hardware initially with the underside of the strap facing
outward. Before tightening, rotate the strap so that the logo
faces outward. Tighten screw until snug.
LASER RADIATION
CAUTION: Use of controls or adjustments or performance
of procedures other than those speci ed herein may result in
hazardous radiation exposure.
WARNING: Laser Radiation maximum power measured at
less than 3.5mW. Avoid direct eye exposure. Do not stare into
beam. Do not turn the light on while looking directly into the bezel.
Aperture warning and Class 3R laser labels are located
on the bottom and back of the light as per illustrations below.
Complies with 21 CFR 1040.10 and 1040.11 except for
conformance with IEC 60825-1 Ed. 3., as described in Laser
Notice No. 56, date May 8, 2019. Manufactured at Longkou
Dongli Wire and Cable Co., Ltd., 413 Beihuan Road,
Huangcheng, Longkou Shandong, China 265701.
The SFL Shotgun models with a green laser are not
intended to be serviced. Contact Bayco Customer Service if
product is not functioning properly. See warranty section for
more information.
WARRANTY
LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free
from defects in workmanship and materials for the original
purchaser’s lifetime. The Limited Lifetime Warranty includes the
LEDs, housing and lenses. Rechargeable batteries, chargers,
switches, electronics and included accessories are warranted
for a period of two years with proof of purchase. Normal wear
and failures which are caused by accidents, misuse, abuse,
faulty installation and lightning damage are excluded.
We will repair or replace this product should we determine
it to be defective. This is the only warranty, expressed or
implied, including any warranty of merchantability or tness
for a particular purpose.
For a complete copy of the warranty, go to www.
baycoproducts.com/nightstick-product-support/warranties.
Retain your receipt for proof of purchase.
y Remove the magazine from the  rearm (if applicable).
y Open the action and visually and physically inspect the
chamber to be sure it is empty.
y Keep the barrel pointed in a safe direction at all times and
never place your hand in front of the muzzle.
INSTALL THE OPTIONAL HAND STRAP
y Begin with the strap logo side down on the light.
y Align the holes on the strap with the threaded holes on
the light, insert the screw/lock washer, then tighten gently.
y Twist the strap ends to turn logo outward which forms a
loop with the strap.
INSTALL THE LIGHT ONTO YOUR SHOTGUN
SAFETY WARNING: ALWAYS ENSURE SHOTGUN IS
SAFE AND UNLOADED BEFORE INSTALLING ONTO
SHOTGUN.
y Ensure the shotgun is unloaded. Remove barrel retention
cap on feed tube and remove barrel from action.
y Using included universal fore-end locking nut wrench, line
up end with M (Mossberg) or R (Remington) that engages
the slots in the locking nut and remove.
y Slide pump handle off action tube. Install SFL weapon light
onto action tube.
y For Mossberg 500/590/590A1 models with a 7.75” action
tube, use the included Mossberg Action Tube Spacer (SFL-
MSP) before installing locking nut.
y Tighten action tube locking nut. Reinstall barrel and barrel
retention cap.
y Ensure shotgun action cycles smoothly and without
interference. If action is dif cult to cycle, re-check installation.
INSTALL THE BATTERIES
SAFETY WARNING: ALWAYS ENSURE SHOTGUN
IS SAFE AND UNLOADED BEFORE CHANGING THE
BATTERY.
y Unscrew and remove the battery cap.
y Place the CR123A batteries into the battery carrier and
insert into the light.
y Replace the battery cap and turn until fully seated.
OPTIONAL RECHARGEABLE BATTERY KIT
The shotgun lights can run on rechargeable lithium-ion
batteries with purchase of the 18650-KIT1 that includes two
rechargeable batteries, charger and USB cable.
OPERATION
The left and right side swtiches on all models operate
indepedently. Either switch provides momentary or constant
on functionality.
y Turn on/off: Press down for 1/2 second or less and
release.
y Momentary on: Press and hold for 1/2 second or longer,
release to turn off.
Laser Models:
Laser models (GL) feature white light and green laser
options that can be programmed. Depending on the user-
selected program mode, activation of the switch will operate
either 1) white light only, 2) green laser only, or 3) white
light and green laser. See programming instructions in the
next section.
Standard models (WL) feature white light only and are
not programmable.

Produkt Specifikationer

Mærke: NightStick
Kategori: Lys
Model: Remington SFL-14WL

Har du brug for hjælp?

Hvis du har brug for hjælp til NightStick Remington SFL-14WL stil et spørgsmål nedenfor, og andre brugere vil svare dig


Lys NightStick Manualer

NightStick

NightStick Remington SFL-14WL Manual

20 December 2025
NightStick

NightStick XPR-5581RX Manual

19 December 2025
NightStick

NightStick XPP-5450GC Manual

19 December 2025
NightStick

NightStick TWM-854XL Manual

19 December 2025
NightStick

NightStick INTRANT XPR-5568RXLB Manual

19 December 2025
NightStick

NightStick XPR-5560 Manual

19 December 2025
NightStick

NightStick XPR-5590RCX Manual

18 December 2025
NightStick

NightStick NSR-9514B Manual

18 December 2025
NightStick

NightStick NSP-4612B Manual

18 December 2025
NightStick

NightStick NSP-2420RX Manual

18 December 2025

Lys Manualer

Nyeste Lys Manualer

Progress Lighting

Progress Lighting P3929 Manual

20 December 2025
Progress Lighting

Progress Lighting P300545 Manual

20 December 2025
Vaxcel

Vaxcel Somerset P0319 Manual

20 December 2025
Progress Lighting

Progress Lighting P500384 Manual

20 December 2025
Progress Lighting

Progress Lighting P500382 Manual

20 December 2025
Vaxcel

Vaxcel Cullerto P0424 Manual

20 December 2025
Vaxcel

Vaxcel Huntley W0189 Manual

20 December 2025
Vaxcel

Vaxcel Akron W0437 Manual

20 December 2025
Vaxcel

Vaxcel Outdoor Security T0722 Manual

20 December 2025
Vaxcel

Vaxcel Madrona P0432 Manual

20 December 2025