Copyright
Copyright 20 Technology Corp. rights reserved. part of 16 by PLANET All No this
publication reproduced, transmitted, transcribed, stored may be a in retrieval system, or
translated any language or computer language, any form or into in by any means, electronic,
mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written
permission of PLANET.
PLANET makes no representations or warranties, either expressed or implied, with respect
to the contents hereof and specifically disclaims any warranties, merchantability or fitness for
any particular purpose. software described this manual sold or "as Any in is licensed is".
Should the programs prove defective purchase, the following their buyer (and not PLANET,
its its distributor, or dealer) assumes the entire cost of all necessary servicing, repair, and
any incidental or consequential damages from any defect software. Further, resulting in the
PLANET t reserves the right to revise this publication and to make changes from ime to time
in revision the contents hereof without obligation to notify any person of such or changes.
All brand and product names mentioned in this manual are trademarks and/or
registered trademarks their respective holders. of
Federal mmission Statement Communication Co Interference
This limits equipment has been tested and found to comply with the a B for Class digital
device, pursuant 15 of Rules. These are designed provide reasonable to Part FCC limits to
protection against harmful interference a in residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, not and used accordance if installed in
with the instructions, may cause harmful interference to radio communications. However,
there no guarantee interference not occur installation. is t tha will a in particular If this
equipment does cause harmful interference or reception, can be to radio television which
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference one or of the measures: by more following
1. Reorient or relocate the receiving antenna.
2. Increase separation between the equipment and receiver. the
3. Connect equipment an outlet on different from that receiver the into a circuit to which the
is connected.
4. Consult dealer or experienced radio technician for help. the an
