Tripp Lite PowerVerter RV1250ULHW Manual

Tripp Lite Batteri PowerVerter RV1250ULHW

Læs gratis den danske manual til Tripp Lite PowerVerter RV1250ULHW (12 sider) i kategorien Batteri. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Tripp Lite PowerVerter RV1250ULHW, eller vil du spørge andre brugere om produktet?

Side 1/12
Owner’s Manual
Quiet Mobile Power
Congratulations! You’ve purchased the most advanced, feature-rich Inverter/Charger designed for recreational vehicle applications. Tripp Lite
RV Inverter/Chargers are the quiet alternative to gas generators—with no fumes, fuel or noise to deal with! You get AC electricity anywhere
and anytime you need it: rolling down the highway, dry camping in majestic back country or parked overnight at a money-saving non-electric
site. RV Inverter/Chargers provide your equipment with utility- or generator-supplied AC electricity (filtered through premium ISOBAR
®
surge
protection) whenever available. In addition, your RV Inverter/Charger automatically powers your RV’s 12V system and recharges your connected
battery bank—doing what traditional RV converter/chargers do. Whenever power blackouts, brownouts or high voltages occur, your RV
Inverter/Charger immediately and automatically switches over to inverting battery output to power connected AC equipment.
Better for Your Equipment Premium Protection Levels
Built-In ISOBAR
®
Surge Protection
Automatic Overload Protection
Ideal Output for All Loads
Frequency-Controlled Output
Automatic Load Switching
Balanced Load Sharing
Better for Your Batteries Faster Battery Recharge
High-Amp, 3-Stage Battery Charger (adjustable)
Critical Battery Protection
Battery Charge Conserver (Load Sense)
Battery Temperature Sensing
High-Efficiency DC-to-AC Inversion
Better for You Quiet, Simple, Maintenance-Free Operation
Multi-Function Lights & Switches
Automatic Generator Starting
Dead Battery Startup
Ignition Interlock & In/Out Swap Protection
Moisture-Resistant Construction*
Safety 2
Feature Identification 3
Operation 4-5
Configuration 5-7
Battery Selection 7-8
Mounting 8
Battery Connection 9
AC Input/Output Connection 10
Service/Maintenance 10
Troubleshooting 11
Warranty/Warranty Registration 11
PowerVerter
®
DC-to-AC
Inverter/Chargers
Input Output
Invert: 12 VDC 120V, 60 Hz. AC
Charge: 120V, 60 Hz. AC 12 VDC
1111 W. 35th Street, Chicago, IL 60609 USA
Customer Support: (773) 869-1234
www.tripplite.com
* Inverter/Chargers are moisture-resistant, not waterproof.
Copyright © 2008. PowerVerter
®
is a registered trademark of Tripp Lite. All rights reserved.
Contents
WARRANTY
REGISTRATION
Register on-line today for
a chance to win a FREE Tripp Lite
product! www.tripplite.com/warranty
200712159 93-2768 RV Series Inverter-Charger Owner’s Manual_Eng.qxd 2/29/2008 1:55 PM Page 1
Important Safety Instructions
SAVE THESE INSTRUCTIONS!
This manual contains important instructions and warnings that should be followed during the installation, operation and storage of all Tripp
Lite Inverter/Chargers.
Location Warnings
Although your Inverter/Charger is moisture resistant, it is NOT waterproof. Flooding the unit with water will cause it to short circuit
and could cause personal injury due to electric shock. Never immerse the unit, and avoid any area where standing water might
accumulate. Mounting should be in the driest location available.
Leave a minimum of 2" clearance at front and back of the Inverter/Charger for proper ventilation. To avoid automatic Inverter/Charger
shutdown due to overtemperature, any compartment that contains the Inverter/Charger must be properly ventilated with adequate
outside air flow. The heavier the load of connected equipment, the more heat will be generated by the unit.
Do not install the Inverter/Charger directly near magnetic storage media, as this may result in data corruption.
Do not install near flammable materials, fuel or chemicals.
Do not mount unit with its front or rear panel facing down (at any angle). Mounting in this manner will seriously inhibit the unit's
internal cooling, eventually causing product damage not covered under warranty.
Battery Connection Warnings
Multiple battery systems must be comprised of batteries of identical voltage, age, amp-hour capacity and type.
Because explosive hydrogen gas can accumulate near batteries if they are not kept well ventilated, your batteries should not be
installed (whether for a mobile or stationary application) in a “dead air” compartment. Ideally, any compartment would have some
ventilation to outside air.
Sparks may result during final battery connection. Always observe proper polarity as batteries are connected.
Do not allow objects to contact the two DC input terminals. Do not short or bridge these terminals together. Serious personal injury
or property damage could result.
Equipment Connection Warnings
Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the fail-
ure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equip-
ment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
You may experience uneven performance results if you connect a surge suppressor, line conditioner or UPS system to the output of
the Inverter/Charger.
Corded Models: Do not modify the Inverter/Charger’s plug or receptacle in a way that eliminates its ground connection. Do not use
power adapters that will eliminate the plug’s ground connection.
Connect your Inverter/Charger only to a properly grounded AC power outlet or hardwired source. Do not plug the unit into itself;
this will damage the device and void your warranty.
Tripp Lite recommends wiring hardwired AC output to a GFCI (ground fault circuit interrupter) protector.
The main grounding lug should be connected to the vehicle chassis with a minimum #8 AWG wire.
Operation Warnings
Your Inverter/Charger does not require routine maintenance. Do not open the device for any reason. There are no user serviceable parts inside.
Potentially lethal voltages exist within the Inverter/Charger as long as the battery supply and/or AC input are connected. During any
service work, the battery supply and AC input connection (if any) should therefore be disconnected.
Do not connect or disconnect batteries while the Inverter/Charger is operating in either inverting or charging mode. Operating Mode
Switch should be in the DC OFF position. Dangerous arcing may result.
Caution: These models have a failsafe AC pass-through feature where the AC output will be live (if AC input is
available) even though the operating mode switch is set to DC OFF.
2
200712159 93-2768 RV Series Inverter-Charger Owner’s Manual_Eng.qxd 2/29/2008 1:55 PM Page 2


Produkt Specifikationer

Mærke: Tripp Lite
Kategori: Batteri
Model: PowerVerter RV1250ULHW

Har du brug for hjælp?

Hvis du har brug for hjælp til Tripp Lite PowerVerter RV1250ULHW stil et spørgsmål nedenfor, og andre brugere vil svare dig