Planet WGS-810 Manual

Planet Skifte WGS-810

Læs gratis den danske manual til Planet WGS-810 (2 sider) i kategorien Skifte. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 13 anmeldelser. Har du et spørgsmål om Planet WGS-810, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

- 1 -

- 2 -

- 3 -

- 4 -

- 5 -

- 6 -

- 7 -

- 8 -

1. Package Contents

Thank you for purchasing PLANET 8-port 10/100/1000T Wall-

mounted Gigabit Ethernet Switch.

In the following sections, unless specied, the term “Wall-mount

Gigabit Switch” mentioned in this user’s manual refers to the

above model.

Open the box of the Wall-mount Gigabit Switch and carefully

unpack it. The box should contain the following items:

The Wall-mount Gigabit Switch x 1 User’s Manual x 1

Wall-mounted Kit x 1 Magnet Kit x 1 RJ45 Dust Cap x 8

2. Hardware Description

2.1 Switch Front View

The front panel of the Wall-mount Gigabit Switch consists of 8

auto-sensing 10/100/1000Mbps Ethernet RJ45 ports. The LED

indicators are also located on the RJ45 ports of the Wall-mount

Gigabit Switch.

 WGS-810 Front View

3 421

7 865

PWR

ACTLNK

DC Input Range

12V

, 1A max.

Standard

VLAN

Extend

Uplink

ACTLNK

Figure 2-1: WGS-810

3. Installation

3.1 Wall-mount Installation

To install the Wall-mount Gigabit Switch on the wall, simply follow

the following steps:

Step 1: Place the Wall-mount Gigabit Switch on the wall and

mark the four holes with a pencil.

133mm

Ø4mm

Ø8mm

6mm

Step 2-1: Hammer the anchors provided into the four holes and

use the four screws to tightly x the switch onto the

wall by screwing them.

PoE+

3 421

7 865

Uplink

60W

PoE Usage

45W

30W

15W

PWR

CTLNK

Po n-Us e

ACTLNK

DC Input Range

48-56V

, 1.5A max.

Standard

VLAN

Extend

2.3 DIP Switch

The front panel of Wall-mount Gigabit Switch provides one DIP

switch for and mode selections. The Standard, VLAN Extend

detailed descriptions are shown in the following table.

DIP Switch Mode Function

Standard

VLAN

Extend

This mode makes the Wall-mount Gigabit

Switch operate as a general switch and all

ports operate at 10/100/1000Mbps auto-

negotiation.

Standard

VLAN

Extend

This mode makes the Wall-mount Gigabit

Switch operate as a switch VLAN isolation

and

1. Port 1 to will isolate respectively.port 6

2. Port 1 to port 6 can only communicate

with port 7 and port 8 (uplink port).

Standard

VLAN

Extend

This mode makes the Wall-mount Gigabit

Switch operate as a VLAN isolation switch and

1. Port 1 to port 6 will isolate respectively.

2. Port 1 to port 6 can only communicate

with port 7 and port 8 (uplink port).

3. Transmission distance of 250m at speed of

10Mbps.

Note

Please reboot the Wall-mount Gigabit Switch after

adjusting the DIP switch.

Power Adapter x 1 DIN-rail Kit x 1

If any item is found missing or damaged, please contact your local

reseller for replacement..

2.2 LED Indicators

 System and Ports

LED Color Function

PWR Green Lights to indicate that the Switch has power.

LNK/

ACT Green

Lights To indicate the link through that port is

successfully established.

Blinks

To indicate that the switch is actively

sending or receiving data over that

port.

2.4 Physical Dimensions

W x D x H: 148 x 24.2 x 134 mm

148.00 24.20

134.00

133.00

118.00

6.00

24.20

118.00

3 421

7 865

PWR

ACTLNK

DC Input Range

12V

, 1A max.

Standard

VLAN

Extend

Uplink

ACTLNK

Step 2-2: Or the switch, shown in the picture below, can be hung

on the wall by screwing the two screws leaving a space

of 2mm apart after the anchors are hammered in.

2mm

M4 Screw

PoE+

3 421

7 865

Uplink

60W

PoE Us age

45W

30W

15W

PWR

ACTLNK

PoE-in-Use

ACTLNK

DC Input Range

48-56V

, 1.5A max.

Standa rd

VLAN

Exte nd

3.2 DIN-rail Mounting Installation

The DIN-rail kit is included in the Wall-mount Gigabit Switch

package. To hang up the Wall-mount Gigabit Switch, follow the

steps below:

Step 1: Screw the DIN-rail bracket on the Wall-mount Gigabit

Switch.

- 9 -

- 10 -

- 11 -

- 12 - - 13 -

www.PLANET.com.tw

Energy Saving Note of the Device

This power required device does not support Standby mode operation. For energy savings, please remove the DC plug or slide the hardware-based Power Switch

to the OFF position to disconnect the device from the power circuit. Without removing the DC plug from or switching off the device, the device will still consume

power from the power source. In view of Saving the Energy and reducing the unnecessary power consumption, it is strongly suggested to power off or to remove

the DC plug from the device if this device is not intended to be active.

PLANET Technology Corp.

2350-AW1010-000

10F., No. 96, Minquan Rd., Xindian Dist., New Taipei City 231, Taiwan

Warn ngi :

This device is compliant with Class A of CISPR 32.

In a residential environment this device may cause radio interference.

Industrial 8-Port 10/100/1000T Wall-mounted

Gigabit Ethernet Switch

►

WGS-810

Step 2: Lightly press the bottom of DIN-rail bracket into the

track.

Step 3: Check whether the DIN-rail bracket is tightly on the track.

1Push

2Click

PoE+

3 421

7 865

Upl ink

60W

PoE Usage

45W

30W

15W

PWR

ACTLNK

PoE-in-Use

ACTLNK

DC Input Range

48-56V

, 1 .5A ma x.

Stan dard

VLAN

Exten d

PoE+

3 421

7 865

Upl ink

60W

PoE Usage

45W

30W

15W

PWR

ACTLNK

PoE-in-Use

ACTLNK

DC Input Range

48-56V

, 1. 5A ma x.

Stan dard

VLAN

Exten d

3.3 Magnet Installation

To install the Wall-mount Gigabit Switch on a magnetic surface,

simply follow the following diagram:

PoE+

3 421

7 865

Uplink

60W

PoE Usage

45W

30W

15W

PWR

ACTLNK

PoE-in-Use

ACTLNK

DC Input Range

48-56V

, 1.5A max.

Standard

VLAN

Extend

Appendix: Product Specications

Model WGS-810

Hardware Specications

Network

Connector

8-port RJ45 for 10/100/1000BASE-T

Auto-negotiation and auto MDI/MDI-X

Power

Requirements 12V DC, 1A max.

Power

Consumption 3 watts/10 BTU

ESD Protection 4KV DC

Surge Protection 6KV DC

DIP Switch Selectable operation mode

- Standard/VLAN/Extend

Enclosure IP30 metal

Dimensions 148 x 24.2 x 134 mm (W x D x H)

Weight 446 g

Switch Specications

MAC Address

Table

4K MAC address table with auto learning

function

Data Buer 64Kbytes

Switch Fabric 16Gbps

Switch Throughput 11.9Mpps@64bytes

Flow Control Back pressure for half duplex.

IEEE 802.3x pause frame for full duplex

4. Customer Support

Thank you for purchasing PLANET products. You can browse our

online FAQ resource and User’s Manual on PLANET Web site rst

to check if it could solve your issue. If you need more support

information, please contact PLANET switch support team.

PLANET online FAQs:

https://www.planet.com.tw/en/support/faq

Switch support team mail address:

support @planet.com.tw

Contents are subject to revision without prior notice.

PLANET is a registered trademark of PLANET Technology Corp.

All other trademarks belong to their respective owners.

Standard Conformance

Standard

Compliance

IEEE 802.3 Ethernet

IEEE 802.3u Fast Ethernet

IEEE 802.3ab Gigabit Ethernet

IEEE 802.3x Flow Control

IEEE 802.3az Energy Ecient Ethernet (EEE)

Regulatory

Compliance FCC Part 15 Class A, CE

Environment

Operating Temperature: -20 ~ 60 degrees C

Relative Humidity: 5 ~ 95% (non-condensing)

Storage Temperature: -20 ~ 70 degrees C

Relative Humidity: 5 ~ 95% (non-condensing)

Produkt Specifikationer

Mærke:	Planet
Kategori:	Skifte
Model:	WGS-810
Kode for international beskyttelse (IP):	IP30
Bredde:	148 mm
Dybde:	25 mm
Højde:	134 mm
Vægt:	446 g
Produktfarve:	Blue, Grey
Opbevaringstemperatur (T-T):	-20 - 70 °C
Relativ luftfugtighed ved drift (H-H):	5 - 95 %
Relativ luftfugtighed ved opbevaring (H-H):	5 - 95 %
Driftstemperatur (T-T):	-20 - 60 °C
Certificering:	FCC Part 15 Class A, CE
Netværksstandarder:	IEEE 802.3, IEEE 802.3ab, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
LED-indikatorer:	Ja
Kan monteres på væggen:	Ja
Fuld duplex:	Ja
Switch-type:	Ikke administreret
Opbevar-og-frem:	Ja
MAC adresselabel:	4000 entries
Switch kapacitet:	16 Gbit/sek.
Gennnemløb:	11.9 Mpps
Halv dupleks:	Ja
MAC-adresse auto-indlæring understøttet:	Ja
DIN-skinne montering:	Ja