Proficient Protege C646 Manual

Proficient Højttaler Protege C646

Læs gratis den danske manual til Proficient Protege C646 (4 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 20 anmeldelser. Har du et spørgsmål om Proficient Protege C646, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Ceiling Speakers

C851 • C801 • C791 • C646 • C641

C626 • C621 • C612 • C606 • C501

OWNER’S MANUAL

Before installing your Ceiling Speakers, you should consider

their placement carefully, taking into account the location of

electrical, plumbing and other xtures. Contact your Dealer

for assistance if you are unsure of the best location for your

particular listening environment.

Placement In Ceiling: When placing your speakers into the

ceiling, they should ideally be located above the primary

listening area.

If the speakers are positioned far away from the primary

listening area, simply adjust the pivoting tweeters so they are

pointed towards it. Note: To avoid possible damage to the pivot-

ing tweeters, read the section entitled “SPEAKER ADJUSTMENTS”

in this manual prior to performing the tweeter adjustment.

In a very large room with high ceilings, it may be necessary to

place additional speakers throughout the room. Contact your

Procient Audio Systems Dealer for assistance.

New Construction - Unnished Ceilings

A Pre-Construction Bracket, available from your Dealer, may

be installed prior to drywall application across joists (up to

24" on-center) where a speaker will be located. After the hole

is cut and the drywall is installed, the speakers are then easily

installed following the instructions for mounting in “Finished

Ceilings” below. Note: If the speakers are to be mounted more

than 24" on-center, a special “Extra Long Wing” is available from

your Dealer.

Finished Ceilings

Prior to the actual installation of the speakers, it will be neces-

sary to run cables to the speaker locations. See your Dealer for

more information about cable installation. After the cable has

been properly installed, you are ready to mount the speakers.

Following the simple steps listed below will result in a profes-

sional looking installation:

1. Determine the best area to mount your speakers. This area

of the ceiling should be free of obstructions such as electri-

cal conduit, HVAC ducts, or water lines. This can best be

determined by noting the placement of xtures and gaining

access to an attic or crawl space for further analysis of the

location of such obstacles.

2. Find the joists nearest the desired speaker mounting

location. We highly recommend using a good stud-nder

tool for this procedure. If you are lining up the speakers to

some other object or molding in the room, make sure you

consider the size of the bae, which extends beyond the

mounting hole.

3. Mark the hole. A template for setting the hole is provided in

the box. Position the template in the desired position and

pencil an outline on the ceiling.

4. Cutting the hole. CAUTION: This is the most important part

of the entire installation. If you are not certain whether any

obstructions exist behind the desired mounting area, you

should start by cutting a small hole in the center of your

penciled mounting hole with a drywall saw, cutting at a 45°

angle towards the inside of the hole. (See Diagram 1) Cutting

the small hole at this angle will make drywall repair much

easier, using the piece cut out. Once you have determined

that there aren’t any obstructions in your desired mounting

location, start cutting the nished hole at a 90° angle to the

ceiling surface.

5. Add insulation. If the area in the ceiling is not already

insulated, add an adequate amount of insulation material to

loosely cover the back of the speaker. If the insulation mate-

rial used is faced with foil or paper, position the foil or paper

away from the speaker.

CAUTION: Speaker components can get hot while playing

music at moderate to high volume levels. There should be

nothing at all touching the speaker. Material in proximity to

the back of the speaker must have at a minimum 1" or 26mm

clearance for non-ammable materials and more for am-

mable materials like plastic vapor barriers.

SPEAKER PLACEMENT

MOUNTING SURFACE PREPARATION

Diagram 1:

Ceiling Cut Out

Produkt Specifikationer

Mærke:	Proficient
Kategori:	Højttaler
Model:	Protege C646

Har du brug for hjælp?

Hvis du har brug for hjælp til Proficient Protege C646 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Højttaler Proficient Manualer

Proficient C850 Manual

30 August 2024

Proficient Ceiling C500 Manual

30 August 2024

Proficient W800 Manual

30 August 2024

Proficient Protege C646 Manual

30 August 2024

Proficient GL6 Manual

30 August 2024

Proficient C660 Manual

30 August 2024

Proficient C605 Manual

30 August 2024

Proficient Ceiling C640 Manual

30 August 2024

Proficient W670 Manual

30 August 2024

Proficient C645 Manual

30 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer

TDK TP6803BLK Manual

28 Oktober 2025

TDK TREK Flex A28 Manual

28 Oktober 2025

Altec Lansing inMotion iM4 Manual

24 Oktober 2025

Vonyx VX822 Manual

21 Oktober 2025

Memphis Audio SRX42 Manual

19 Oktober 2025

Memphis Audio MS62 Manual

19 Oktober 2025

Madison MAD-CENTER120 Manual

19 Oktober 2025

Goji Mini GMINIG17 Manual

19 Oktober 2025

Audison VOCE AV 12 Manual

19 Oktober 2025

Memphis Audio VIV60CV2 Manual

18 Oktober 2025