QualGear QG-SB-001-BLK Manual

QualGear Højtalerbeslag QG-SB-001-BLK

Læs gratis den danske manual til QualGear QG-SB-001-BLK (6 sider) i kategorien Højtalerbeslag. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 2 anmeldelser. Har du et spørgsmål om QualGear QG-SB-001-BLK, eller vil du spørge andre brugere om produktet?

Side 1/6
Version May 2019Version May 2019
1 2
Parts Checklist
WARNING
Hardware ckagePa
IMPORTANT: Before starting installation, please check that all parts shown in this checklist
are included. If any parts are missing or damaged, contact your local distributor or
support@qualgear.com for replacement parts and do not start assembly and installation
Soundbar Bracket
M4x14 (x2)
E
M6x14 (x4)
K
M8x50 (x4)
O
5mm Small Spacer (x8)
P
15mm Large Spacer (x8)
Q
Plastic Washer (x2)
R
M6x20 (x4)
L
M8x20 (x4)
M
M6x30 (x4)
N
M5x14 (x2)
F
M6x14 (x2)
I
M6 (x2)
J
M6x14 (x2)
G
D5 Washer(x2)
H
M6x10 Screw (x4)
C
M6 Nut (x4)
D
A (x2)
Extension Arms
B (x2)
Do not begin to install your QualGear product
until you have read and understood all the
instructions and warnings contained in this
installation manual. If you have any questions
regarding the instructions, for US customers
please contact QualGear customer support
via email at support@qualgear.com. For
all international customers, please contact
your local distributor.
This product should only be installed by
s eone of good c nical aptitude, has om me ha
ex ence with basic ding construction, peri buil
and fully erstands these instructions.und
This product was designed to be installed
and utilized only as specified in this manual.
Improper installation of this prod
uct may cause
damage or serious injury. QualGear is not
liable for the improper use or installation of its
products.
Make sure that the s porting surface up
will safely s port the c ined load of the up omb
equipment and all attached ware and hard
c nents.ompo
Always use an assistant or mec nical ha
lifting ment to safely lift and position the equip
equipment.
Tighten screws firmly, but do not over tighten.
Over tightening can damage the items, greatly
reducing their holding power.
All QualGear products are intended for
indoor use only and any outdoor use voids the
limited ranty.war
All QualGear products are designed
and tested for residential use only and any
c ercial use voids the limited omm warranty.
For warranty information, please visit
http://www.qualgear.com/warranty.php.
Never exceed the maximum rated ight we
specified in this ual.man
All bolts and screws must be used at the
designated points in the installation instructions
to pre provent perty damage and/or personal
injury.
DO NOT install near air conditioner vents or
where there is exce
ssive dust or smoke.
Please read the entire installation manual. Check to ensure that all parts are included
before you start installation and assembly.
NOTE


Produkt Specifikationer

Mærke: QualGear
Kategori: Højtalerbeslag
Model: QG-SB-001-BLK

Har du brug for hjælp?

Hvis du har brug for hjælp til QualGear QG-SB-001-BLK stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højtalerbeslag QualGear Manualer

Højtalerbeslag Manualer

Nyeste Højtalerbeslag Manualer