QUIO QU-1001-HF Manual


Læs gratis den danske manual til QUIO QU-1001-HF (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 13 anmeldelser. Har du et spørgsmål om QUIO QU-1001-HF, eller vil du spørge andre brugere om produktet?

Side 1/1
QU-1001-HF RFID Card Reader
Manual
Specification
Working VoltageDC 9V-16V
Static Current ≤80mA
Reading Range 5 10CM: ~
Support :EM-ID or M1card
Ambient Temperature -40 70
Ambient Humidity 10% 90%: ~
International Standard Wiegand Interface
Less than 100M Communication Distance
Installation
Using “+”type screw driver to loosen the screw between the
panel and mother board. And then embed the motherboard
to the side wall with the plastic plug and screws.
Wire Connection
WG26/34 RS485 RS232
Red DC9V-16V Red DC9V-16V Red DC9V-16V: : :
Black GND
Green D0
White D1
Blue LED
Yellow BEEP
Black GND
Green 4R+
White 4R-
Black GND
Green RX
White TX
gray :GND to wiegand 34
purple: Door Bell
Notice
1. Confirm the electric voltage (DC12V) and differentiate
positive anode and cathode of power supply
2. When external Power is used, make sure sharing the
power with Controller Box or using the same GND
3. The wire connects reader to controller, advise use 8
cores stranded twisted pair cable(among them, three
strands are spare, if no need reader show illegal cards by
sound and light, LED wire can not be used, data wire
Data1 Data0 are twisted pair would be better,
we suggest sectional area are 0.22 square millimeter at
least. The length should not exceed 100meters.
Email: web: kontakt@quio-rfid.de http://www.quio-rfid.de/
Quick-Ohm Küpper & Co. GmbH | Cronenfelderstraße. 75 | 42349 Wuppertal | Tel: +49 (0) 202 404329 | Fax: +49 (0) 202 404350


Produkt Specifikationer

Mærke: QUIO
Kategori: Ikke kategoriseret
Model: QU-1001-HF

Har du brug for hjælp?

Hvis du har brug for hjælp til QUIO QU-1001-HF stil et spørgsmål nedenfor, og andre brugere vil svare dig