RCBS Powder Trickler-2 Manual

RCBS Ikke kategoriseret Powder Trickler-2

Læs gratis den danske manual til RCBS Powder Trickler-2 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om RCBS Powder Trickler-2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

POWDER TRICKLER-2

and UPGRADE KIT

LIMITED LIFETIME WARRANTY

Your powder trickler is warranted to be free from defects in material or

workmanship for as long as the original owner owns it. This warranty is

extended only to the original consumer purchaser. This warranty

excludes any electrical components or products. All RCBS products are

intended for non-commercial use by hobbyists. Any other use of these

products will void the warranty. Should you believe that your powder

trickler is defective in material or workmanship, you must return the

powder trickler to Ammunition Accessories Inc. through its Oroville

operation (hereinafter “Oroville Operations”) postage paid for evaluation.

If defective, the product will be repaired or replaced at Oroville

Operations’ option, at no charge.

Send a dated proof of purchase to Oroville Operations for return shipping

and handling, along with the Powder trickler to:

Ammunition Accessories Inc.,

Oroville Operations

605 Oro Dam Blvd East

Oroville, California 95965

Warranty services cannot be provided without meeting the above

requirements.

THIS LIMITED LIFETIME WARRANTY DOES NOT COVER DEFECTS

OR DAMAGE RESULTING FROM: CARELESSNESS, MISUSE,

COMMERCIAL USE, ABUSE, IMPROPER INSTALLATION,

MODIFICATION, OR NORMAL WEAR AND TEAR. THE IMPLIED

WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A

PARTICULAR PURPOSE ARE LIMITED TO THE DURATION OF THIS

LIMITED LIFETIME WARRANTY. OROVILLE OPERATIONS IS NOT

LIABLE FOR DAMAGES IN EXCESS OF THE PURCHASE PRICE OF

THE PRODUCT AND UNDER NO CIRCUMSTANCES SHALL

OROVILLE OPERATIONS BE LIABLE FOR CONSEQUENTIAL OR

INCIDENTAL DAMAGES. HOWEVER, SOME STATES DO NOT

ALLOW LIMITATIONS ON INCIDENTAL, OR CONSEQUENTIAL

DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT

APPLY TO YOU.

The above warranty provides the sole and exclusive warranty available

to the customer in the event of a defect in material or workmanship in the

powder trickler. This warranty gives you specific legal rights, and you

may also have other rights which vary from State to State.

SAFETY

Reloading is an enjoyable and rewarding hobby that can be

conducted safely. But, as with any hobby, carelessness or

negligence can make reloading hazardous. This product has

been designed from the beginning with the user's safety in mind.

When reloading, safety rules must be followed. By observing

these rules, the chance of a hazardous occurrence causing

personal injury or property damage is minimized.

GENERAL

• Use all equipment as the manufacturer recommends. Study

the instructions carefully and become thoroughly familiar with

the operation of the product. If you do not have written

instructions, request a copy from the equipment manufacturer.

• Do not take short cuts. Attempting to bypass established

procedures is an invitation to an accident.

• Observe "good housekeeping" in the reloading area. Keep

tools and components neat, clean and orderly. Promptly and

completely clean up primer and powder spills.

• Reload only when you can give your undivided attention. Do

not reload when fatigued or ill, or under the influence of

medications or alcohol.

• Develop a reloading routine to avoid mistakes which may

prove hazardous. Do not rush - load at a leisurely pace.

• Always wear adequate eye protection to protect your eyes

from flying particles. You assume unnecessary risk when

reloading without wearing safety glasses.

LOADING DATA

• Use only laboratory tested reloading data. We highly

recommend the current SPEER Reloading Manual.

• OBSERVE ALL WARNINGS ABOUT THE USE OF

MAXIMUM LISTED LOADS

INTRODUCTION

The Powder Trickler-2 has been designed to work with both

mechanical and electronic scales. The adjustable height base

and extended reach dispensing tube are guaranteed to reach the

powder pan of most powder scales. The weighted base and non-

skid feet keep the Trickler from moving around during

dispensing.

Photo 1 Adjustable base – high (NOTE: angle/draft to speed

trickling)

Photo 2 Adjustable base - low

ASSEMBLY

Clean powder trickler tubes and body prior to use. Use alcohol or

Outers Crud Cutter to remove oils or solvents.

Remove the green plastic retainer from the Powder Dispensing

Tube and insert the tube through hole in the Powder Trickler

body, replace the green plastic retainer.

Photo 3 Insert tube and install retaining ring

(UPGRADE KIT assembly starts here)

Slide the Powder Dispensing Tube extension over the Powder

Tube and secure the Socket Head Set Screw.

Photo 4 Secure extension tube set screw

Place the Powder Trickler onto the Adjustable base, align the

Powder Dispensing tube with the “SCALE” marking on the upper

portion of the Adjustable base. Alignment of the dispensing tube

with the “SCALE” mark adds a slight draft(taper) to speed the

trickling process. Secure the three socket head set screws in the

upper base.

Photo 5 Align dispensing tube with “SCALE” mark on upper base

Photo 6 SECURING the three SHSS

USE

Unscrew the lower portion of the Adjustable Base until the

desired powder dispensing tube height is achieved. The

dispensing tube should be ¼” or greater above the scale pan.

Fill the Powder Trickler reservoir with smokeless powder and

turn the dispensing tube clockwise to start the flow of powder.

At the end of the reloading session, pour the remaining

smokeless powder back into the original factory container. This

will preserve the identity and shelf life of the smokeless powder.

MAINTENANCE

Periodically clean powder trickler tubes and body. Use alcohol or

Outers Crud Cutter to remove oils or solvents.

Clean Powder Trickler when changing powders to prevent

contamination. Pay special attention to the interior of the powder

trickler tube and insure that there is no powder from the previous

session stuck inside the tube.

Customer Service

1-800-533-5000 (US or Canada) or 530-533-5191

Hours: Monday - Thursday, 6:30am - 4:00pm Pacific Time

(hours may vary)

e-mail: rcbs.tech@atk.com or visit our website at www.rcbs.com

RCBS 605 Oro Dam Blvd. East Oroville, CA 95965

7200561/1010

Produkt Specifikationer

Mærke:	RCBS
Kategori:	Ikke kategoriseret
Model:	Powder Trickler-2

Har du brug for hjælp?

Hvis du har brug for hjælp til RCBS Powder Trickler-2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret RCBS Manualer

RCBS Rock Chucker Supreme Auto Prime Manual

2 September 2024

RCBS Trim Pro 2 Manual

30 August 2024

RCBS Powder Trickler-2 Manual

28 August 2024

RCBS Case Activated Linkage Kit Manual

28 August 2024

RCBS Lube-A-Matic 2 Manual

28 August 2024

RCBS M1000 Manual

25 August 2024

RCBS Cowboy Dies Manual

25 August 2024

RCBS Rangemaster 2000 Manual

25 August 2024

RCBS Pro Melt 2 Manual

25 August 2024

RCBS ChargeMaster Supreme Manual

25 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

AmpliVox Airvox SW695 Manual

15 Juni 2025

Stiga SBC 635 KD Manual

15 Juni 2025

Cleveland 36CGM300 Manual

15 Juni 2025

Gourmia GTF7970 Manual

15 Juni 2025

Planet Audio P9630B Manual

15 Juni 2025

ORNO OR-DOM-YR-934UD Manual

15 Juni 2025

Lavex 842CD12VST12 Manual

15 Juni 2025

Marshall RCP-PLUS Manual

15 Juni 2025

Hughes & Kettner BassForce XL Manual

15 Juni 2025

Hughes & Kettner Red Box Mk III Manual

15 Juni 2025