o Please read the entire instructions before installing the Splash back.
Comply with current Drainage and Plumbing Regulations as required by your local authority. Sanitary
plumbing shall only be carried out by a Registered Plumber. All plumbing work must be done in accordance
with local and national building and plumbing codes as applicable. All electrical work must be done in
accordance with local and national electrical codes as applicable. In some instances this product may need to
be earthed.
Determine the most suitable position for the splashback. Mark the position on the wall as reference.
Important safety information
o This Robinhood Splash back is not intended for use by young children or infirm persons without
supervision.
o Young children should be supervised to ensure that they do not play with the Robinhood Supertub.
o Use abrasive household cleaner.
Powder coated surfaces must not be cleaned with abrasive or chemical cleaners. To keep the Robinhood Supertub
looking its best, wipe regularly with a damp soft cloth. A mild soap and water solution may be used to remove
stubborn dirt. Under no circumstances should harsh detergents (including chemical cleaners) such as bleach,
scourers or any abrasive cleaner be used as these products may irreparably damage the surfaces of the
Robinhood Supertub.
NB. Their use will render the warranty void
Installing the Splash back
1. Fix mounting screws and cup washers to the wall using the dimensions given below. Mounting to a stud
is recommended. However, if fitted to other wall linings (plasterboard, concrete etc) suitable wall fixings
will be required (not supplied).
A Distance from the bench top to the lower fixing screw
107mm flush fit between the bottom surface of the splash back and the bench top
110mm allows a 3mm gap between the splash back and bench top if sealing is required
2. Hang splash back from the cup washers.
3. Seal the splash back to the wall using suitable approved sealant. (Check with your local council for
building regulations).
