Rockustics OneSub Manual

Rockustics Subwoofer OneSub

Læs gratis den danske manual til Rockustics OneSub (2 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Rockustics OneSub, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

OneSub & DubSub

INSTALL INSTRUCTIONS

Ultra-Fidelity Outdoor Speakers

Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com

Please read the following instructions carefully before installing

your Rockustics

Rock speaker. If you have any questions

regarding installation that are not answered in the following

directions, please contact your local sound contractor or the

Rockustics

/MSE Audio

technical support team.

OneSub™

The terminal block is on the underside of the OneSub. 14 gauge

or heavier direct burial wire should be run directly from an

amplier with an integrated low frequency crossover (We

recommend a Phase Technology P350 amplier. Please see

P350 manual to setup crossover point.) to the speaker location.

Stripped wire ends are then inserted into the terminal blocks.

DubSub™

The dual terminal blocks are on the underside of the DubSub. 14

gauge or heavier direct burial wire should be run directly from a

dual channel full range amplier. The DubSub has an integrated

crossover that will route the low frequencies to the DubSub, and

the rest of the signal to the satellite speakers.

Wires from the ampliifer are wired to the ‘in’ terminals, and

satellite speakers are wired to the ‘out’ terminals.

INPUT

12V TRIGGER

UNBALANCEDBALANCED

OUTPUT

TRIGGER

MODE

IN OUT

MUSIC

12V

4-16 OHMS

INPUT

VOLTAGE

POWER

ON OFF

115V 60 Hz/ 230V 50 Hz

AC INPUT 600W MAX

PUSH

115V

P350

Terminal Block

OS-440

L R

L IN

L OUT

R OUT

R IN

Out

OneSub & DubSub

INSTALL INSTRUCTIONS

Ultra-Fidelity Outdoor Speakers

Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com

Optimizing Speaker Placement for Best Sound

All Rockustics speakers can generate a high SPL (sound

pressure level). Be ready to rock, but be considerate of your

neighbors! Maximum acoustic performance should be an

important factor in determining speaker placement. Here is how

to achieve it:

1) Establish where the most likely or average listening

position will be.

2) The speakers should be placed at or close to the same

distance from that point.

3) The actual distance between the listening position and the

location of the speakers is not critical. However, keep in

mind that as the distance between listening area and

speaker is increased, there will be a noticeable decrease

in perceived volume.

4) Be sure to conrm amp power matches the power rating

on the speaker. Over-driving the speaker can lead to

permanent damage that is not covered under warranty.

Optimizing Aesthetics with Speaker Placement

All Rockustics products are designed with a boost in high

frequency response to accommodate for placement near plants

and other landscaping features. Feel free to position the product

within your landscaping, camouaged near bushes or shrubs.

Rockustics products strive to blend into the natural aesthetic of

their surroundings.

Be sure to account for the wires which will run from the rock to

your stereo or audio source. Camouage wires by running them

an inch below ground level when possible.

Cautions and Maintenance

All Rockustics Rock Series speakers are sealed and fully

weatherproof. However, DO NOT place speakers where

the grille will be in the path of a sprinkler system. Sprinklers

typically have a high water pressure level that can damage

speaker cones if hit directly.

DO NOT place soil or wood chips over the speaker grille. If the

grilles accumulate a build up of soil, the speaker may become

damaged. If build up does occur, simply rinse the grille with

a garden hose set to a low pressure level. Accumulated soil

may also promote undesired insect trafc into the speaker.

Insects may eat through the speaker cone. Chemical sprays may

also cause damage to the rubber of the speaker surround. This

includes bug spray, deck sealant, some fertilizers and oil based

products. Speakers MUST be covered when applying these

treatments or chemicals in your yard.

For environments that get snow and ice during the winter

months, be sure to check that the openings and woofer cone

are clear and there is no hard-packed snow or ice built up in

these areas before playing. If there is ice or snow present on

the cone, use a hair dryer set on a low setting to to melt it away.

If the speakers are not going to be used during winter months, it

is recommended that they either be disconnected and brought

indoors, or covered with a plastic bag to help protect the

speaker components.

Produkt Specifikationer

Mærke:	Rockustics
Kategori:	Subwoofer
Model:	OneSub
Højde:	355.6 mm
Antal pr. pakke:	1 stk
Brugervejledning:	Ja
Produktfarve:	Sand
Pakkevægt:	21180 g
Pakkedybde:	635 mm
Pakkebredde:	622.3 mm
Pakkehøjde:	546.1 mm
Bluetooth:	Ingen
Udgangseffekt (RMS):	70 W
Strømforbrug (typisk):	64 W
Husmateriale:	Elastomer
Pakketype:	Kasse
Anbefalet brug:	Have
Frekvensområde:	38 - 22000 Hz
Lydtryksniveau (maks.):	106.5 dB
Impedens:	4 ohm (Ω)
Forbindelsesteknologi:	Ledningsført
Højttaler, type:	2-vejs
Lyd-output kanaler:	2.0 kanaler
Højttaler, placering:	Gulv
Strømkilde type:	Vekselstrøm
Diameter:	438.1 mm
Farvenavn:	Sandsten
Bæredygtighedscertifikater:	CE, RoHS, Trade Agreements Act (TAA)
Diskanthøjttaler:	Ja
Antal drivere til diskant:	1
Peak Music-Udgangseffekt (PMPO):	140 W
Sensitivitet:	91 dB
Diskant diameter:	0.75 "
Bashøjttaler:	Ja
Antal bashøjttalerdrev:	1
Woofer diameter:	203.2 mm
Højttaler kabinet:	Lukket
Woofer diameter (britisk mål):	8 "
Egnet til udendørs brug:	Ja