Rockustics SubScape 12 Manual

Rockustics Subwoofer SubScape 12

Læs gratis den danske manual til Rockustics SubScape 12 (4 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 3.9 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Rockustics SubScape 12, eller vil du spørge andre brugere om produktet?

Side 1/4
Escape Series
INSTALL INSTRUCTIONS
© 2021 MSE Audio. Rev. 02.19.2021
Ultra-Fidelity Outdoor Speakers
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com
Please read the following instructions carefully before installing
your Rockustics
®
Rock speaker. If you have any questions
directions, please contact your local sound contractor or the
Rockustics
®
/MSE Audio
®
technical support team.
Optimizing Speaker Placement for Best Sound
All Rockustics speakers can generate a high SPL (sound
pressure level). Be ready to rock, but be considerate of your
neighbors! Maximum acoustic performance should be an
important factor in determining speaker placement. Here is
how to achieve it:
1) Establish where the most likely or average listening
position will be.
2) The speakers should be placed at or close to the same
distance from that point.
3) The actual distance between the listening position and
the location of the speakers is not critical. However, keep
in mind that as the distance between listening area and
speaker is increased, there will be a noticeable decrease
in perceived volume.
4) Be sure to conrm amp power matches the power rating
on the speaker. Over-driving the speaker can lead to
permanent damage that is not covered under warranty.
Optimizing Aesthetics with Speaker Placement
All Rockustics products are designed with a boost in high fre-
quency response to accommodate for placement near plants
and other landscaping features. Feel free to position the product
within your landscaping, camouaged near bushes or shrubs.
Rockustics products strive to blend into the natural aesthetic of
their surroundings.
Be sure to account for the wires which will run from the rock to
your stereo or audio source. Camouage wires by running them
an inch below ground level when possible.
Cautions and Maintenance
All Rockustics Rock Series speakers are sealed and fully weath-
erproof. However, DO NOT place speakers where the grille will
be in the path of a sprinkler system. Sprinklers typically have a
high water pressure level that can damage speaker cones if hit
directly.
DO NOT place soil or wood chips over the speaker grille. If the
grilles accumulate a build up of soil, the speaker may become
damaged. If build up does occur, simply rinse the grille with a
garden hose set to a low pressure level. Accumulated soil may
also promote undesired insect trafc into the speaker. Insects
may eat through the speaker surround. Chemical sprays may
also cause damage to the rubber of the speaker surround. This
includes bug spray, deck sealant, some fertilizers and oil based
products. Speakers MUST be covered when applying these
treatments or chemicals in your yard.
For environments that get snow and ice during the winter
months, be sure to check that the openings and woofer cone
are clear and there is no hard-packed snow or ice built up in
these areas before playing. If there is ice or snow present on the
cone, use a hair dryer set on a low setting to to melt it away. If
the speakers are not going to be used during winter months, it
is recommended that they either be disconnected and brought
indoors, or covered with a plastic bag to help protect the
speaker components.
Escape Series
INSTALL INSTRUCTIONS
© 2021 MSE Audio. Rev. 02.19.2021
Ultra-Fidelity Outdoor Speakers
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com
Wiring for Low Impedance Applications
If using 8 ohm wiring instead of 70V, only use tap position 1
on Periscape units. Subscape units require specic preparation
for 8 ohm use, outlined in step 5 of the Subscape instructions
section. Use the supplied silicone wire nut to connect the
positive (+) leads of the speaker and input wires. Repeat this
step with the negative (-) leads. Rockustics recommends using
14ga or heavier direct burial cable for the connection between
the amplier and the speakers.
Wiring for 70V/100V Applications
For speakers with transformers, use to nd Diagram C and D
the proper wire selection for your desired tap setting. Once
the desired tap setting is conrmed, trim the unused wires to
minimize corrosion. For harsh and wet environments, it is
recommended to apply a bead of silicone to the end of the
unused wires for added protection.
If daisy-chaining, follow wire preparations as outlined in the
Basic Wiring Diagram Fsection. Review for a typical daisy-chain
wiring system for 70V and 100V applications. Be sure to
connect the wires going to the next speaker in the chain as
shown in . There should be three pairs of wires at Diagram E
each speaker, but the last speaker in the chain will only have
two pair. Follow standard protocol for polarity and make sure all
units are wired with the same polarity.
Diagram E
Diagram C
Wire Color Subscape 8 Subscape 10 Subscape 12
Black 70V-Common 70V-Common 70V-Common
Yellow 150W 250W 300W
Blue 75W 125W 150W
Brown 38W 63W 75W
Subscape
Subscape
Subscape
SubscapeSubscape
T
T
T
Tap Wir
ap Wir
ap Wir
ap Wire
e
e
eTap Wire
Key
Key
Key
KeyKey
Diagram D
Switch Position Periscape 6Periscape 4
I 8 Ohm 8 Ohm
II 25W 50W
III 13W 25W
IV 7W 13W
V 4W 7W
Periscape
Periscape
Periscape
PeriscapePeriscape
T
T
T
Tap Wire
ap Wire
ap Wire
ap WireTap Wire
Key
Key
Key
KeyKey
Diagram F


Produkt Specifikationer

Mærke: Rockustics
Kategori: Subwoofer
Model: SubScape 12

Har du brug for hjælp?

Hvis du har brug for hjælp til Rockustics SubScape 12 stil et spørgsmål nedenfor, og andre brugere vil svare dig