N DOR/ Manual v1.0
2
Describes basic precautions that users should be aware of when installing and using the product in case of a situation that
may cause bodily harm. Therefore, before installing or using the product, be sure to familiarize yourself with the
information described here.
General precautions
During and after installation of the product, the area around
the product must be kept clean and dust-free.
Do not leave tools, cables, etc. in the aisle, as this may result in personal injury.
When installing the product, avoid wearing loose-fitting clothes, neckties, scarves, or sleeves that may get caught in the
product.
Do not take any action that could cause damage to persons or equipment.
If you need to open the cover of the product to extend the product's performance or repair a malfunction, be sure to
contact the place of purchase for professional help.
Power Precautions
When connecting power to the product, first check that the wiring is not overloaded.
When connecting the power to the product, do not wear jewelry such as rings, necklaces, or watches. If these accessories
are connected to a power source or ground, there is a risk of burning the parts.
Always check the work area for potential hazards. Be sure to check for wet floors, ungrounded power extension cables,
frayed internal power cords, and floors that do not have a safety grounding facility.
There must be an outlet near the appliance and the outlet must be easily accessible.
Install by service personnel and install the appliance so that it is connected to a socket-outlet with a protective earth wire
Power
The power cord and power outlet act as the main power disconnect device in case of an emergency such as a fire, so do
not stack or block objects in front of the power outlet so that you can unplug the power cord from the power outlet at any
time.
1. Precautions before installation
Before proceeding with hardware installation, turn off the power of the system to be installed,
and then touch a grounded surface such as the metal side of the power supply to discharge
static electricity from the body.
The manufacturer assumes no liability for direct or indirect damage resulting from the use of
improper parts by unauthorized service personnel.
If power is supplied during installation, it may cause damage to system components and body.
