San Jamar P4800 Manual


Læs gratis den danske manual til San Jamar P4800 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om San Jamar P4800, eller vil du spørge andre brugere om produktet?

Side 1/4
FRONTLINE™ CONDIMENT DISPENSING SYSTEMS
Daily Cleaning and Sanitizing Instructions for Pump
FrontLine is NSF Listed for simple daily “clean-in-place .(see inside for periodic full disassembly cleaning)
T
R
A
S
H
BEFORE CLEANING
1. Empty the pump by
fully compressing
the handle several
times.
2. Rinse the exterior
of the pump to
remove food residue.
1
1. Immerse the pump into
the detergent solution.
2. Wash the outside of the pump.
3. Fully compress the handle at
least 14 times to clean the
inside of the pump.
4. Use the supplied brush to
remove any remaining food
residue from the hard-to-reach
areas - including the spout.
5. Turn the pump upside down to
drain the detergent solution.
WASH
2
1. Immerse the pump into
the warm rinse water.
2. Fully compress the handle
at least 14 times.
RINSE
3
1. Immerse the pump into
the sanitizing solution.
2. Fully compress the handle
at least 14 times.
3. Keep the pump submerged
for a minimum of two minutes.
4. Remove the pump and fully
compress the handle several
times to clean the inside of
sanitizing solution.
5. Turn the pump upside down
to drain the sanitizing solution.
6. Allow the pump to air dry. Store
the pump in a sanitary manner
until ready to use.
SANITIZE
WATER
75ºF(24ºC) min.
+ detergent*
RINSE WATER
75ºF(24ºC) min.
WATER
75ºF(24ºC) min.
+ sanitizer**
*Use a commonly available dishwashing detergent such as Dawn or Joy mixed to a concentration recommended by manufacturer.
**Use a quaternary ammonium sanitizer mixed to the manufacturer recommended concentration for water at 75ºF(24ºC) minimum.
Weekly Cleaning and Sanitizing Instructions for Pump
1 2 3
Before cleaning, empty the pump
by fully compressing the handle
several times until the condiment
is removed from the pump.
Disconnect the dip tube from
the pump body by pulling the
dip tube down using a twisting
motion.
Unscrew the locking collar and
remove the lid and the locking
collar from the pump body.
4 5 6
Separate the handle/upper housing
from the pump engine.
Slip the lower housing off the
pump engine.
Gently twist and pull the end of
the nozzle tube to remove.
7 8
9
Unscrew and remove the pump
bottom.
Place one hand over the elbow
connector and spring. With the
other hand, unscrew the pump
body from the elbow connector.
Use caution as the spring is
under compression.
Slide the
spring off
the plunger.


Produkt Specifikationer

Mærke: San Jamar
Kategori: Ikke kategoriseret
Model: P4800

Har du brug for hjælp?

Hvis du har brug for hjælp til San Jamar P4800 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret San Jamar Manualer

San Jamar

San Jamar P4900 Manual

7 August 2024
San Jamar

San Jamar P7500 Manual

6 August 2024
San Jamar

San Jamar P4800 Manual

6 August 2024
San Jamar

San Jamar P4100 Manual

6 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer