Saris Guardian 2 Manual


Læs gratis den danske manual til Saris Guardian 2 (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Saris Guardian 2, eller vil du spørge andre brugere om produktet?

Side 1/12
T G SHE UARDIAN ERIES
INSTALLATION MANUAL
1045P-Guardian 2 bike
1047P-Guardian 3 bike
Note: Before installing
carrier, clean all surfaces
of vehicle which may
come in contact with the
carrier or its straps. Make
sure foam pads are free of
vehicle's finish.
ADJUST CARRIER TO VEHICLE:
GUARDIAN 2-
Following the illustration below that most resembles your vehicle, adjust the top leg such that the lower leg
rests on or above liscense plate and the rack assumes the position that most resembles the illustration.
Lower leg must rest on or above license plate (not on bumper).
Position 1 or 2
Position 3 or 4
Position 4 or 5
Position 1 or 2
Position 3 or 4
Position 4 or 5
GUARDIAN 3-
Following the illustration below that most resembles your vehicle, adjust the top leg such that the lower leg
rests on the bumper and is positioned vertically. Lower leg must rest on bumper.
1
1
Lower Leg
Lower Leg
Lower
Leg
Lower Leg
Lower Leg
Lower
Leg
Please READ and FOLLOW all instructions carefully.
Check Fit Guide for compatibility.
Top Leg
Top Leg
Top Leg
Top Leg
Top Leg
Top Leg
Chances are, your bikes are just
like ours - your most valued
possessions. And if it has the
Saris name on it, nothing we
build goes out the door unless
it’s worth putting those posses-
sions on. Call it obsessive. Call it
eccentric. We just chalk it up to
caring a hell of a lot about creat-
ing the last rack you’ll ever need.
FINALLY A
COMPANY THAT
LOVES BIKES AS
MUCH AS YOU DO.
ATTACH STRAPS:
Attach Upper-hook straps to top
hinge line of vehicle as shown in
Fig.'s 3 & 4. Always place strap
between car surface and hook.
3
Note: Hook attachment must be to a supported hinge line - NEVER attach
to glass, unsupported plastic, or roof rack.
Unless otherwise specified in current fit chart,
www.saris.com attach inside strap hooks (Fig. 6)
to bottom edge of trunk at position C1 (ideally)
or C2 (Fig. 5). Attach outside strap hooks above
bend in trunk at position C3. (marked on hook)
Upper Hook
Upper Hook
4
Inside Strap Hook and Hatch Hugger special application:
ONLY IF SPECIFIED IN CURRENT FIT CHART
(available at www.saris.com)
Some vehicles require placing the Inside Strap Hooks in the trunk. To
do so: Loosen straps, place hooks inside trunk, close trunk, pull straps
until hooks brace against trunk wall, and tighten as usual (Fig. 5).
Tighten all straps evenly, removing any
slack. When straps are taut, shake
carrier to check for movement. Retighten if necessary.
5
ADJUST CARRIER TO VEHICLE CONTINUED:
Press in on adjusting levers simultaneously and raise rear leg,
then release levers allowing pins to snap into place (Fig. 2).
2
PUSH
Outside strap
Inside strap
6
View from front of rack
Upper Hook
Side Strap Hook
Lower
Strap Hook


Produkt Specifikationer

Mærke: Saris
Kategori: Ikke kategoriseret
Model: Guardian 2

Har du brug for hjælp?

Hvis du har brug for hjælp til Saris Guardian 2 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Saris Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer