Saris Hatch Huggers Manual

Saris Ikke kategoriseret Hatch Huggers

Læs gratis den danske manual til Saris Hatch Huggers (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Saris Hatch Huggers, eller vil du spørge andre brugere om produktet?

Side 1/2
Note: See back page for Hatch Hugger vehicle
compatibility list.
THE HATCH HUGGER IS INTENDED FOR:
1) Vehicles with glass or plastic hinge lines that are
currently not recommended for Graber or Saris
carriers with standard S-hooks.
2) Vehicles with narrow gaps around the hatch or trunk
that do not permit placement of standard hooks.
GENERAL COMPATIBILITY REQUIREMENTS:
hatch (glass) and vehicle body.
9Confirm that tension on the strap will not deform or
damage vehicle molding or trim.
9Be certain mounting strap is not rubbing against any
sharp metal edges.
9Hatch must have internal metal support frame.
S-hook strap replacement / application:
1 Remove S-hook straps from buckles.
2 Open vehicle trunk or hatch.
3 Insert end of Hatch Hugger
strap between hatch and
vehicles body.
4 Be sure there is not interference when hatch/trunk
is closed.
HATCH
5 Close hatch or trunk.
Pull mounting strap to seat Hatch Hugger in place.
STRAP
HATCH
Narrow J-hook strap replacement / application:
· Remove narrow J-hook straps from buckles.
· Open vehicle trunk or hatch.
· Place Hatch Hugger inside trunk, close trunk, and
pull strap until hugger braces against trunk wall.
6 Thread Hatch Hugger straps to carrier buckles.
SPRING BUCKLE
7 Be sure to keep straps in line with rear leg to prevent
carrier from shifting.
YES NO NO
8
Continue mounting carrier as instructed in your
owners manual.
3 BAR BUCKLE
NO
NARROW J-HOOK


Produkt Specifikationer

Mærke: Saris
Kategori: Ikke kategoriseret
Model: Hatch Huggers

Har du brug for hjælp?

Hvis du har brug for hjælp til Saris Hatch Huggers stil et spørgsmål nedenfor, og andre brugere vil svare dig