LED T8 TUBES
Models: S
11964,S11965, S11966,S11967
INSTALLATION AND SAFETY INSTRUCTIONS
Satco Products, Inc.
Brentwood, NY 11717© Copyright 2020 Satco Products, Inc. 3/20
WARNING:
• DANGER: Risk of shock-disconnect power before
installation.
•
LED
• WARNING: Product must be installed in accordance
with the national electrical code or your local electrical
code. If you are not familiar with these codes and
• WARNING: Install this kit only in luminaries that have
the construction features and dimensions shown in the
photographs and/or drawing and where the input rating
luminaire.
• WARNING: To prevent wiring damage or abrasion,
do not expose wiring to edges of sheet metal or other
sharp objects. Do not make or alter any open holes in
any enclosure of wiring or electrical components during
kit installation.
• WARNING:
bi-pin lampholders. NOTE: Shunted lamp holders are
words “Instant Start” or “I.S.” marked on the ballast.
This designation may be in the form of a statement
pertaining to the ballast itself, or may be combined
with the marking for the lamps with which the ballast
is intended to be used, for example F40T 12/IS, for
manufacturer.
Installers should not disconnect the existing wire from
lampholder terminals to make new connections at
lampholder terminals. Instead installers should cut
existing lampholder leads away from the lampholder
and make new electrical connections to lampholder
lead wires by employing applicable connectors.
• WARNING: Luminaire wiring and electrical parts
Check for enclosed wiring and components.
• WARNING: Check the existing wiring for damage
before installing upgrade kit. Do not install if existing
wires are damaged.
luminaire where the suitability of the combination shall
be determined by authorities having jurisdiction.
•
operate the originally intended lamp,” shall be marked
during normal maintenance including lamping.
• Do not use with dimmers.
• Suitable for damp locations. Suitable for use in
enclosed luminaries.
• This device is not intended for use with emergency
exits.
• This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Installation instructions on back.
