Schatten Design Mini Pre 2 Manual

Schatten Design Ikke kategoriseret Mini Pre 2

Læs gratis den danske manual til Schatten Design Mini Pre 2 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Schatten Design Mini Pre 2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Mini-Pre Acoustic Preamp Instructions

Getting started

1) Remove the back cover and install a 9 volt alkaline or lithium battery (not

included).

2) Install the belt clip to the back cover of the preamp using the two supplied

screws. Reinstall back cover.

3) Use standard 1/4" shielded instrument cables.

4) The input accepts all piezo and magnetic pickups (passive or active). It is a

good idea to turn down your amp or mixer before you plug into the input of the

preamp.

5) Note that the battery within the preamp is turned on only when a plug is

inserted into the output jack.

The Input Gain Trim Pot

1) There is a small trim pot for adjusting the input gain of the preamp. It is

positioned between the input and output jacks on the circuit board (as shown in

the diagram to the right) and is accessible with the back cover removed.

2) From our facility, this trim pot is set to approximately 7 db of input gain, which

works properly in most applications.

3) If the signal coming from your pickup is very weak, you may wish to turn the

input trim pot clockwise, which will raise the overall level and reduce system noise

(hiss). If you hear distortion when you play (with a new battery), lower

the input trim until it goes away.

4) For the cleanest signal, set the volume control (output gain) as high

as possible without distorting the amp or PA.

Important: The trim pot may be adjusted using a very small jewellers

slotted screwdriver.

Output

Plug a standard instrument cable from the output to an amp or an

unbalanced microphone input on a PA.

Specifications

Input Impedance: 10MOhm

Output Impedance: Less than 3.5kOhm

Input gain: 0 to 20 db

Battery life: 9 volt alkaline - 1500 hours

Do Not Use Rechargeable Batteries.

Rev. 04-19-2012

Produkt Specifikationer

Mærke:	Schatten Design
Kategori:	Ikke kategoriseret
Model:	Mini Pre 2

Har du brug for hjælp?

Hvis du har brug for hjælp til Schatten Design Mini Pre 2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Schatten Design Manualer

Schatten Design Mini Pre 2 Manual

2 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Siemens WQ32G28IL Manual

6 December 2025

MDT BE-TA550606.02 Manual

6 December 2025

Opticis USC-CC32 Manual

6 December 2025

Audio-Technica AT33xMONO Manual

6 December 2025

Bosch SPI4EMS24E Manual

6 December 2025

Fostex P1000K Manual

6 December 2025

Advantech UTC-124I1 Manual

6 December 2025

Anton/Bauer Titon Micro Kit Manual

6 December 2025

Philips Zoom! DayWhite DIS130 Manual

6 December 2025

Opticis USB-FC30AA Manual

6 December 2025