Scosche ITCCR04B Manual


Læs gratis den danske manual til Scosche ITCCR04B (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Scosche ITCCR04B, eller vil du spørge andre brugere om produktet?

Side 1/12
INTRODUCTION/PRELIMINARY
ITCCR04B
Left Bracket 7563
Right Bracket 7562
Face Panel 7561
Touch Screen UAC
IN-DASH STEREO INSTALLATION KIT
WITH TOUCH SCREEN INTERFACE FOR
2013-UP DODGE RAM TRUCKS
This premium installation for 2013-Up Dodge Ram trucks vehicles allows you to install an
aftermarket ISO Double DIN stereo in the dash. Refer to the detailed steps in this manual to
remove your factory radio and assemble the kit.
CAUTION:
DISCONNECT YOUR VEHICLES NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP
PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/ OHM METER OVER A TEST LIGHT
TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE VEHICLE’S
COMPUTER AND/OR DIAGNOSTIC SYSTEMS. AVOID ALL FACTORY AIRBAG WIRING - AIRBAGS CAN
ACCIDENTALLY DEPLOY CAUSING SERIOUS INJURY OR DEATH.
NOTES
See your vehicle’s instructions for special tools your installation might require.
Read all instructions accompanying your car stereo for proper wiring and mounting instructions.
STOP IMPORTANT NOTE: To ensure proper functionality cycle the ignition key from “OFF” to “Run”
TWO times after rst connecting the interface to your vehicle.
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile disassembly, wire harness/codes
and information pertaining to the installation of this kit. Scosche Industries, Inc. cannot be held responsible for discrepancies/
inconsistencies that may occur due to the automobile manufacturing changes or options, or damages that may occur in the
automobile during the installation of components while using this booklet.
© 2017 SCOSCHE INDUSTRIES, INC.
If you have any questions, call our toll free technical help line at: 1-800-621-3695 x3
ITCCR04B 07/17
Remove mat located in cup center
console (A), then remove the 7mm
screw exposed (B).
NOTE: For models with center cup/
storage console.
Remove tray mat located above cup/
storage center console (A), then remove
the (2) Philip screws exposed (B).
NOTE: For models with center cup/
storage console.
Now that all screws are removed lift
away the cup/storage center console and
proceed to the next step.
NOTE: For models with center cup/
storage console.
Remove (1) T-20 torx screw located in the
pocket inbetween the passenger center
vent and the 12V acc. ports, see image
at right.
Step 4
Step 1
Step 2
Step 3
Step 5
2013-UP DODGE RAM
RAM TRUCKS Disassembly
RAM TRUCKS Disassembly
RAM TRUCKS Disassembly
RAM TRUCKS Disassembly
RAM TRUCKS Disassembly
Disassembly
2
© 2017 SCOSCHE INDUSTRIES, INC ITCCR04B 07/17
Remove the top center tray cover, then
remove (2) T-20 Torx exposed (See image
at right).


Produkt Specifikationer

Mærke: Scosche
Kategori: Ikke kategoriseret
Model: ITCCR04B

Har du brug for hjælp?

Hvis du har brug for hjælp til Scosche ITCCR04B stil et spørgsmål nedenfor, og andre brugere vil svare dig