Shaws AUSH-4417 Manual

Shaws Vandhane AUSH-4417

Læs gratis den danske manual til Shaws AUSH-4417 (4 sider) i kategorien Vandhane. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Shaws AUSH-4417, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4


6
Ø6


Ømm
hole
FULL REACH 
G1/2”
female
Pot Filler
AUSH.4417
AUSH.4417NI: Nickel
AUSH.4417PF: Pewter
AUSH.4417SB: Satin Brass
AUSH.4417EB: English Bronze
AUSH.4417BR: Polished Brass
AUSH.4417IG: Gold (special order)
Temperature range: Min 1°C. Max 70°C
Working Pressure: Min kPa (psi). Max kPa (psi)
Flow Rate: Regulated to 8.L/min
I M P O R T E R S & D I S T R I B U T O R S O F F I N E K I T C H E N A N D B AT H RO O M W A R E
 6  |  French Avenue, Brendale QLD 4500 | aftersales@luxebydesign.com.au | www.luxebydesign.com.au
Pot Filler | INSTALLATION AND USER GUIDE
1
Measure and mark the desired height above the tallest
pot on the stove top. This is where the cold water
supply should be connected.
A 1/2" shank is required to protrude -8mm from the
finished wall surface.
Ensuring the slots are oriented vertically, apply a
suitable thread sealant and tighten the inlet connector
onto the supply shank with a 1/2" hex key.
Please note the correct orientation of the pot filler,
ensuring the handle points upwards and the spout
points downwards. Slide the mounting ring back to
the wall and mark the fixing positions. Secure to the
wall with supplied screws if suitable. Using a spirit level,
ensure the flat surface at the top is level.
When installing on internal walls, appropriate
reinforcement may be required for sufficient strength.
3
Check the condition of the o seals.
Slide the pot filler body fully onto the wall connector with the
retaining screws orientated to align with the keyway slots.
4
Slide the rosette forward to access the retaining screws.
Securely fix with the two concealed fixing screws, ensuring
that the screws are correctly located into the keyway.
Once secured, slide the rosette over the concealed fixing
until it is flush with the mounting surface.
2
Secure the mounting ring to the inlet connector with the grub
screws provided.
Ensure all connections are firmly tightened.
LUXEBYDESIGN.COM.AU
BEFORE USE
 Carefully check the installation for leaks
If further building work is being carried out in the vicinity, cover the product to avoid damaging the finish.
 Please ensure the installation complies with the water supply by-laws.
Slots to be vertical
G 1/2”
Ø 
Hole
-8mm
Finished Surface
Check with spirit level
Secure grub screws
with 3mm AF key
Secure grub screws
with 2.5mm AF key
Congratulations on the purchase of your Shaws by Perrin & Rowe kitchen product. Correctly installed and with sensible care,
this product will give you many years of trouble-free service.
INSTALLATION REQUIREMENTS
Perrin & Rowe tapware must be installed by a Licensed Plumber in accordance with the installation instructions provided, best
trade practices and must comply to local plumbing regulations in your area. Incorrect installation may damage your tap and
could invalidate your warranty.
 Where the inlet water pressure exceeds 500kpa, pressure limiting valves must be installed.
 In-line gauze filters must be fitted in the incoming water supply lines.
 Prior to installation, it is important to flush all incoming water lines thoroughly. Failure to do so may result in issues caused
by debris in the water supply such as bits of metal or plastic, dirt, sand, rust, silt, and other unwanted materials. Any
problems that arise as a result of inadequate flushing may not be covered by the warranty.
 Please take care of this product before, during and after installation as accidental damage to the tap finish is not covered
by the warranty. Please wear gloves when handling 'living finish' models. If further work is to be carried out in the vicinity of
the product, please cover it to protect from paint, plaster, adhesives, sealants and cleaning products.
 For ease of possible future servicing, we recommend the fitting of conveniently placed isolating valves.
 Once unpacked, remove fixing nuts, clamp plate, fibre washer and plastic backnut from tap assembly, ready for installation.
DISTRIBUTED IN AUSTRALIA BY LUXE BY DESIGN     AFTERSALES@LUXEBYDESIGNCOMAU

Produkt Specifikationer

Mærke: Shaws
Kategori: Vandhane
Model: AUSH-4417

Har du brug for hjælp?

Hvis du har brug for hjælp til Shaws AUSH-4417 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Vandhane Shaws Manualer

Shaws

Shaws AUSH-4417 Manual

6 Juli 2025
Shaws

Shaws AUSH-4846 Manual

5 Juli 2025

Vandhane Manualer

Nyeste Vandhane Manualer

Quooker

Quooker Q11-MODERN-SACH Manual

6 Oktober 2025
Quooker

Quooker Q-COMBI-2.2-CLASSIC-BRCH Manual

6 Oktober 2025
Quooker

Quooker Q11-BASIC-SS Manual

6 Oktober 2025
Quooker

Quooker Q-DESIGN-SACH Manual

6 Oktober 2025
Quooker

Quooker Q11-CLASSIC-SS Manual

6 Oktober 2025
Quooker

Quooker Q7-BASIC-SACH Manual

6 Oktober 2025
Quooker

Quooker Q-BASIC-CH Manual

6 Oktober 2025
Quooker

Quooker Q7-BASIC-GP Manual

6 Oktober 2025
Quooker

Quooker Q7-CLASSIC-SACH Manual

6 Oktober 2025
Quooker

Quooker Q-BASIC-SS Manual

6 Oktober 2025