Smeg K7088D180 Manual

Smeg Emhætte K7088D180

Læs gratis den danske manual til Smeg K7088D180 (2 sider) i kategorien Emhætte. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Smeg K7088D180, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

K7088D/180

180cm wall mounted, twin chimney rangehood

ASC — automatic sensor control

dimensions

1 00mmW x 500mmD x 1240mm maximum H8

nish

satin stainless steel

installation

wall mount

motors

2 x 250 watt centrifugal motors —

each motor: twin impellors, double air uptake

air extraction

• duct direct to atmosphere — 150mm diameter ducting required

• recirculate to kitchen — 125mm diameter ducting required

NB: for recirculation, a recirculation diverter kit is supplied for each

chimney

capacity

each half: 750m³/hr net

illumination

4 x 20 watt halogens

noise rating

1 x 38 dBA minimum → 2 x 58 dBA maximum

speeds

four per motor

delay stop

ve minute delay stop selection

controls

four buttons, one LED window

ltration

six removable four-ply stainless steel (washable)

prompts

via LED window ashing —

• ve-minute delay stop

• 30-hour stainless steel lter cleaning prompt

• 120-hour charcoal lter inspection prompt

supplied

• two one-way, non-return buttery valves — removable

• two 150-125mm diameter duct size adaptors

• two recirculation diverter kits

accessory

optional activated charcoal lter for each motor, part number 08999802

warranty

two years on parts and labour

ASC AUTOMATIC SENSING CONTROL

By selecting this button, the K7088D/180 automatically

senses any vapours, smoke and odours caused by the

cooking process and adjusts the speed of extraction

accordingly. The ASC will also sense and capture an

abnormal presence of gas.

DELAY STOP

When cooking is nished, it is recommended that the

rangehood be left running for a few minutes, even at a

lower speed, to pull through all residual heat, grime and

odours. Selecting the DELAY STOP eliminates the need

to return to the rangehood to turn it off manually. It will

also turn off the lights if they were previously left on.

FILTER INSPECTION PROMPTS

After 30 hours of use, the LED window will visually prompt

for you to inspect the ve stainless steel grease lters

for possible washing. The cleaner the lters, the more

effective is the airow. The controls are simply reset to

zero hours and the counting starts over. The lters can

be cleaned at any time, without waiting for the prompt.

After 120 hours of operation, there is an additional

prompt to check the charcoal lters if they have been

tted for the recirculation mode.

DUCTING TO ATMOSPHERE

Extracting the air direct to atmosphere ensures the

maximum removal of grease/oil/particle-laden vapour,

odours and, very importantly, the heat — resulting in

a cleaner, more comfortable cooking environment.

An internal ducting pipe could, ideally, continue in a

straight line within the decorative ue to the kitchen

roof, then through the roof cavity and exit via a roof

cowl. If the rangehood is mounted against an external

wall, the ducting could, as effectively, exit at the rear

anywhere along the vertical line of the concealing

decorative ue and at a position that is structurally

feasible for an external wall cowl.

RECIRCULATION

When the cooking vapours cannot be ducted to

atmosphere, that is, the rangehood is mounted on an

internal wall and/or there is another storey above, the

supplied recirculation kit is inserted into the telescopic

ue. An activated charcoal lter can be tted below the

centrifugal motor. This will effectively diminish cooking

odours. The charcoal lter is not to be washed and is

replaceable.

DUCTING MATERIAL

The smooth internal walls of either galvanised sheet

metal piping or high temperature-resistant PVC will assist

in both greater unobstructed air ow and a quieter

operation. Flexible ducting can be considered for the

very short run and difcult obtuse bends.

CHARCOAL FILTER

In the recirculation mode, the rangehood is also sending

the cooking odours back into the kitchen. An activated

charcoal lter panel, part number 08999802, can be

inserted just below the motor housing to effectively

diminish the cooking odours. This charcoal lter is not to

be washed; however, it is replaceable.

ID010708

code K7088D180

WARNING: technical specications and product sizes can be varied by the manufacturer without notice. Cutouts

for appliances should only be by physical product measurements. The above information is indicative only.

NB: drawings are not to scale — they are to assist only

electricity supply

240 volt, 50 Hz

electrical connection

each chimney: independent 1.5 metre power

cord for connection to standard 10 amp GPO

wattage

motors: 2 x 250 watt each

lights: 4 x 20 watt halogens

total: 580 watts

current

2.42 amps total

packaged dimensions

gross weight

net weight

supplied

• instructions for installation, operation and

maintenance

• 2 x one-way buttery valves for optional

tment to air exit apertures

• 2 x 150mm/125mm diameter duct adaptors

NB: recirculation requires 125mm diameter

ducting, direct ducting requires 150mm diameter

ducting

• xing screws

optional

2 x activated charcoal lters (replaceable),

individual part number 08999802

SPEED 1 2 3 4

net air capacity m

/hr 2 x 300 2 x 470 2 x 630 2 x 750

pressure mm H

0 2 x 36 2 x 42 2 x 45 2 x 46

input wattage 2 x 120 2 x 150 2 x 2502 x 190

noise level dBA 2 x 38 2 x 48 2 x 54 2 x 58

K7088D/180

180cm wall mounted, twin chimney rangehood

ASC — automatic sensor control

ID010708

code K7088D180

direct ducting to atmosphere

recirculation

Please note the difference in maximum heights between the

‘ ’ installation and the ‘ ’ direct duct to atmosphere recirculation

installation. The recirculation installation’s maximum height

is 1240mm due to the active recirculation vents necessarily

being exposed on each side of each chimney. The ‘direct

duct to atmosphere’ installation shows the now redundant

recirculation vents being concealed by the lower chimney

piece by the reversing — that is, turning the upper chimney

piece 180 degrees on the vertical.

If higher chimney heights are required for the ‘direct duct to

atmosphere’ installation, that is, up to 1240mm, simply follow

the ‘recirculation’ installation and have the recirculation vents

exposed, though redundant.

540

1800

min 700 - max 1050

min 80

max 430

750

278

253

500

540

1800

min 820 - max 1240

min 200

max 610

750

278

253

500

1.5 metre

power cord

253

278

500

PLAN DETAIL — electrical connection

each chimney

500

front

1.5 metre

power cord

278

475

RIGHT-HAND SIDE ELEVATION DETAIL

— electrical connection

Produkt Specifikationer

Mærke:	Smeg
Kategori:	Emhætte
Model:	K7088D180

Har du brug for hjælp?

Hvis du har brug for hjælp til Smeg K7088D180 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Emhætte Smeg Manualer

10 September 2025

22 August 2025

22 August 2025

12 August 2025

12 August 2025

Smeg KSEC61NE3 Manual

12 August 2025

12 August 2025

3 August 2025

3 August 2025

3 August 2025

Emhætte Manualer

Nyeste Emhætte Manualer

Amana WVW53UC0FS Manual

27 September 2025

Elektro Helios SF504-2 Manual

27 September 2025

Elektro Helios SF704-2 Manual

27 September 2025

Novy Pro'line 7221 Manual

27 September 2025

Elektro Helios SF604-2 Manual

27 September 2025

Elektro Helios SF655-2 Manual

26 September 2025

Elektro Helios SF735 Manual

26 September 2025

Elektro Helios SF6131X Manual

26 September 2025

Elektro Helios SF955-2 Manual

26 September 2025

Novy One Power 1801 Manual

26 September 2025